Solar Lamp Post User Manual
Contents
1. solar module regularly with a damp towel to guarantee optimum performance of the solar panel Do not use any type of solvent for cleaning and be careful not to put too much pressure on the module while cleaning Trouble Shooting If your solar charged light does not come on at dusk despite observance of all the instructions please try the following steps l Make sure that the solar light is not being affected by any other light source 2 Ensure the solar light is not positioned in the shade during the day 3 Make sure the switch is in AUTO position 4 Check that the batteries are installed correctly NOTE The performance of the solar light will vary with the time of year It will deliver more light when it has had a full day in the sun rather than a day in overcast weather WINTERTIME TIPS Keep snow and debris cleaned off the solar panels so the batteries can recharge If the lights are covered with snow for an extended period of time after the snow melts allow all the batteries to charge in full direct sunlight for at least 6 hours to their maximum capacity WARNING Please keep out of reach of children 22. SOLAR LAMP POST US Patent 7172307 Instruction Manual Models GS 94L GS 94S GS 94D GS 94T GS 94W GS 94P GS 94F Please read the instruction manual carefully to obtain the best results from your purchase Unpack and identify the following components Parts GS 94L UB Parts GS 94S Parts GS 94D Parts GS 94T Parts GS 94P Parts GS 94 Tools that needed but not supplied with the high post solar lamp set are a screw driver a wrench and an electrical drill that will be used to anchor the lamp base to the ground Solar Light Location It s important to mount your solar lamp post in a spot where it will receive maximum sunlight throughout the day Shadows cast by your home trees and other structures will move and lengthen during the day So please consider this before deciding on a location Assembly Instructions GS 94L and GS 94S NOTE The following steps are for reference only Consult your local hardware store for the best installation method for your particular surface 1 Use the electrical drill to make three holes in concrete floor which shall be similar to but smaller than the screws G The holes shall be lined up with the holes of the lamp base F 2 Putthe fastening screws G into the holes with their ends facing up Fig 1 2 Secure the screws to the lamp base using a wrench 4 Make sure the lamp base F is stable before installing Part D to the lamp ba
3. at night NOTE The solar light must be charged for two sunny days for best results Fig 6 ry GS 94W GS 94P and GS 94F Screw part A into Part B and turn the On Off switch in the lamp head A to ON position according Fig 4 and 5 Be Sure to place your lamp post in a spot where it can receive maximum sunlight throughout the day It will turn on automatically at night Replacing the Batteries After several years of use the batteries may need replacing l Detach the top of the lamp unit A by releasing the 2 screws and twisting it counter clockwise as shown in Fig 8 2 Make sure the selector switch is in OFF position 3 Releasing the 3 screws on the silver reflector and Remove the old Batteries Make sure the new batteries are high quality Ni Mh AA rechargeable pack batteries 4 Install the new batteries into the battery compartment ensuring the correct polarity is observed 5 Reassemble the unit by reversing the above procedure WARNING Do not dispose of Ni Mh batteries in the regular trash municipal waste stream or by fire as batteries may leak or explode Do not open short circuit or mutilate batteries as injury may occur Preserve our environment by recycling Ni Mh batteries or disposing of them in accordance with local State and federal regulations Do not mix old and new batteries Do not mix Alkaline Standard Carbon Zinc or rechargeable Nickel Cadmium batteries Maintenance Clean the
4. se by using 3 supplied screws 5 GS 94L Then screw part A into part B and part B to Part D Fig 3 6 GS 94S Then screw part A into Part H part H to part B part B to part C part C to part D Fig 4 7 Turn the On Off switch in the lamp head A to ON position according Fig 4 and 5 8 Be sure to place your lamp post in a spot where it can receive maximum sunlight throughout the day It will turn on automatically at night Go NOTE The solar light must be charged for two sunny days for best results GS 94L Fig 3 N wz ai un e wz be _ Fu GS 94D and GS 94T NOTE The following steps are for reference only Consult your local hardware store for the best installation method foryour particular surface 1 Do steps 1 to 5 as described in models GS 94L and GS 94D 2 Insert part K into part B as shown in Fig 5 3 Screw part D into part B using the screws C provided and screw the top cup as shown in Fig 6 Repeat these steps twice in model GS 94D and 3 times in model GS 94T 4 Screw part A twice in model GS 94D 3 times in model GS 94T as shown in Fig 7 and screw the whole top into part B 5 Turn the On Off switch in the lamp head A to ON position according Fig 4 and 5 6 Be sure to place your lamp post in a spot where it can receive maximum sunlight throughout the day It will turn on automatically
Download Pdf Manuals
Related Search