MY MUSIC - SDS Music Factory AG
Contents
1. MY MUSIC PROGRAM SOURCE SERIES INSTALLATION AND OPERATION MANUAL IMPORTANT SAFETY INFORMATION Save the carton and packing material even if the equipment has arrived in good condition Should you ever need to ship the unit use only the original factory packing Read all documentation before operating your equipment Retain all documentation for future reference Follow all instructions printed on unit chassis for proper operation Do not spill water or other liquids into or on the unit or operate the unit while standing in liquid Make sure power outlets conform to the power requirements listed on the back of the unit Do not use the unit if the electrical power cord is frayed or broken The power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them paying particular attention to cords and plugs convenience receptacles and the point where they exit from the appliance Always operate the unit with the AC ground wire connected to the electrical system ground Precautions should be taken so that the means of grounding of a piece of equipment is not defeated Mains voltage must be correct and the same as that printed on the rear of the unit Damage caused by connection to improper AC voltage is not covered by any warranty Have gain controls on amplifiers turned down during power up to prevent speaker damage if there are high signal levels at the inpu2. Non use periods The power cord of equipment should be un plugged from the outlet when left unused for a long period of time Service Information Equipment should be serviced by qualified service personnel when The power supply cord or the plug has been damaged Objects have fallen or liquid has been spilled into the equipment The equipment has been exposed to rain The equipment does not appear to operate normally or exhibits a marked change in performance The equipment has been dropped or the enclosure damaged THIS SAFETY INFORMATION IS OF A GENERAL NATURE AND MAY BE SUPERSEDED BY INSTRUCTIONS CONTAINED WITHIN THIS MANUAL INTRODUCTION AND CONTENTS The Australian Monitor Installation Series My Music program source series are one rack unit dual program source players that features either an AM FM tuner amp single disc CD USB player MYM TCD dual CD USB players MYM DCD or dual AM FM tuner modules MYM DT The tuner module has one FM band amp one AM band with 10 user selectable preset stations there is also a programmable sleep function for the tuner The CD USB player is fully programmable up to 20 tracks amp includes Random track selec tion for CD s amp Repeat single track or Repeat all track functions for both CD amp MP3 s There is also an optional IR control available for the CD USB player The My Music is supplied with an IEC power lead amp AM FM antenna on tun er models The My Music also boasts
3. 2 IF FREQUENCY amp REJECTION 3 IMAGE REJECTION 4 S N RATIO 5MV M INPUT 5 AUTO TUNING SENS DIMENSIONS MY MUSIC PROGRAM SOURCE SERIES INSTALLATION 1 2V 0 3V 20Hz 20kHz 2dB gt 60 dB lt 0 05 gt 80 dB 87 5 MHz 108 MHz 10 7 MHz gt 80 dB gt 25 dB 46db lt 1 0 50uV 522kHz 1620kHz 450 kHz gt 45dB gt 30dB gt 35dB 2mV 482 W x 44 H x 250 D mm amp OPERATION MANUAL PAGE 7 AUSTRALIA AND NEW ZEALAND www australianmonitor com au SYDNEY NSW amp ACT SALES 1 Clyde Street Silverwater NSW 2128 Private Bag 149 Silverwater NSW 1811 Phone 02 9647 1411 Fax 02 9648 3698 Email MELBOURNE VIC amp TAS SALES 22 277 Middleborough Road Box Hill VIC 3128 PO Box 151 Blackburn South VIC 3130 Phone 03 9890 7477 Fax 03 9890 7977 Email nsw audiotelex com au vic audiotelex com au BRISBANE QLD SALES 42 Commercial Road Fortitude Valley QLD 4006 PO Box 2578 Fortitude Valley BC QLD 4006 Phone 07 3852 1312 Fax 07 3252 1237 Email qld audiotelex com au EUROPE ASIA MIDDLE EAST wwwW australianmonitor com au INTERNATIONAL SALES 1 Clyde Street Silverwater NSW 2128 Australian Private Bag 149 Silverwater NSW 1811 Phone 61 2 9647 1411 Fax 61 2 9648 3698 Email internationalQaudiotelex com au ADELAIDE SA amp NT SALES 31 Walsh Street Thebarton SA 5031 PO Box 157 Hindmarsh SA 5007 Phone 08
4. 8352 4444 Fax 08 8352 4488 Email sa audiotelex com au PERTH WA SALES 3 11 Howe Street Osborne Park WA 6017 PO Box 1281 Osborne Park BC WA 6916 Phone 08 9204 0200 Fax 08 9244 3783 Email wa audiotelex com au AUCKLAND NZ SALES 9C Piermark Drive Albany 0752 New Zealand PO Box 300 512 Albany 0752 Phone 09 415 9426 Fax 09 415 9864 Email sales audiotelex co nz
5. individual stereo outputs from both the Tuner amp CD player as well as a stereo priority output for the MYM TCD The My Music series provides a high quality rack space friendly amp extremely well featured dual background music source at a contractor friendly price Your My Music will be one of these models MYM DCD Dual CD USB players MYM DT Dual AM FM tuners MYM TCD 1 AM FM Tuner and 1 CD USB player L je p TUNE I vann i BAND SLEEP CO O CO COO O MEMORY C1 CO CO C COO COL TUNER 1 FOLDER SKIP DOWN REV UP CUE STOP PLAY PAUSE EJECT PROG ESP FIND CL MUTE PLAYMODE USB cD LE JL OE JEJEJ CD USB INTRODUCTION FRONT PANEL BACK PANEL SPECIFICATIONS FOLDER SKIP DOWN REV UP CUE STOP PLAY PAUSE EJECT PROG FIND S 2 MUTE PLAYMODE USB n J OO OOO C Be TUNE I ee L SLEEP CO O COO O MEMORY C1 CO CO CO CO CO L TUNER 2 ala TUNE L ad SLEEP OOOOOOO MEMORY OO O OO TUNER AUS EUR USA Copyright 9th Feb 2006 The diagrams below show a MVM TCD which has both module tvpes for explanatorv purposes Rev D 3rd June 2008 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONAL Caution WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC HOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOI
6. STURE MY MUSIC PROGRAM SOURCE SERIES INSTALLATION amp OPERATION MANUAL This symbol is intended to alert the user to the presence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons This symbol is intended to alert the user to the presence of important operational and maintenance servicing instructions in the literature accompanying the appliance To prevent electric shock do not use this polarised plug with an extension cord receptacle or other outlet unless the blades can be fully inserted to prevent blade exposure To prevent electric shock match wide blade of plug to wide slot fully insert PAGE 3 FRONT PANEL CD USB PLAYER a Lej A FOLDER SKIP DOWN REV UP CUE OFF MYM TCD CD USB PLAYER Power Turns the My Music player on or off E FOLDER SKIP For use when plaving MP3 data CDs or USB memorv sticks Jumpes to either the next aVailalble folder or previous folder Moves sequentiallv through folder tree structure DOWN REV UP CUE Pressing these buttons momentarilv changes the track Pressing and holding these buttons while a track is playing changes the position within a track Note that audio is not audible while changing track position stop Stops the CD MP3 playing and returns to the start of the disk This button also clears the programmed track ord
7. YM DT one for each module There is no antenna connection for the MYM DCD PAGE 6 T CONFORME TO UL STD 60065 Left side Back Panel INPUT 115V AC gt 60Hz 50VA AC FUSE F1 1 25A 250V Slow Blow PLACE WITH CORRECT FU 4 Right side Back Panel NOTE The above drawing shows the back panel of the 115V version Lavout is similar for the 230V version Correct mains voltage should be noted on the actual unit o IEC MAINS INPUT SOCKET This is a standard IEC 3 pin socket It accepts a standard IEC mains cable provided The fuse drawer contains the mains fuse and a spare The mains fuse is a time lag slow blow HRC 20mm x 5mm ceramic type fuse The ratings are 230V 240V model 0 63mA 115V model 1 25A Mains connected apparatus covered by this standard is intended for installation in compliance with the National Electric Code ANSI NFPA 70 Always replace the fuse with one of the same value and tvpe NOTE Alwavs disconnect power to the amplifier before replacing fuses MY MUSIC PROGRAM SOURCE SERIES INSTALLATION amp OPERATION MANUAL SPECIFICATIONS SPEC OF CD USB PLAYER 1 OUTPUT LEVEL 1KHZ ODB 2 FREQUENCY RESPONSE 3 SEPARATION 1KHZ ODB 4 T H D NOISE 1KHZ ODB 5 S N RATIO SPEC OF AM FM TUNER FM 1 TUNING RANGE 2 IF FREQUENCY amp REJECTION 3 IMAGE REJECTION 4 S N RATIO 1MV M INPUT 5 T H D 1MV 6 AUTO TUNING SENS AM 1 TUNING RANGE
8. er Q PLAY PAUSE Plays and pauses the track EJECT Ejects the disk Pressing this button while a disk is ejecting returns the disk to the player PAGE 4 STOP PLAY PAUSE EJECT CD USB E PROG Works with conventional CD s only does not apply to MP3 recorded disks Allows you to program up to 20 tracks to play in the order you program The program order is not saved and will be cleared when you press STOP Use the UP DOWN buttons to change track and press PROG to move to the next program slot Press PLAY PAUSE to start the program order REPEAT ALL will repeat the order that has been programmed While in pro gram mode Pxx on the LCD display indicates the program order position While in program play mode Pxx on the LCD display indicates the actual track number An ordered program cannot be paused Advance the program order using UP DOWN Once an order position Pxx in program mode has been entered it cannot be changed Pressing PROG while the track indicator reads cycles you through the pro gram order Selecting UP DOWN changes the track number but pressing PROG again will put that track in the next program position ESP Electronic Shock Protection Provides 30sec onds of buffered audio Enabling ESP will provide continuous un interupted audio play back if the CD skips ESP only works on normal audio CDs The ESP function does not work on MP3 playback FIND Search function tha
9. ins Pressing this button while in sleep countdown mode turns off the sleep function MEMORY This button allows the memory setting to be programmed To Q TUNE UP DOWN oan Changes the tuner frequency a memory setting L 1 Tune to the frequency you want 2 Press MEMORY MEMO flashes on LCD display 3 Press a number from 1 5 or 5 and a number for 6 10 4 Press MEMORY again This process must be completed within 4 secs or you will need to start again MY MUSIC PROGRAM SOURCE SERIES INSTALLATION amp OPERATION MANUAL PAGE 5 BACK PANEL CAUTION A N DONOT OPEN WARNING 1 TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE GO AM LOOP ANTENNA ANTENNA 1 OUTPUT TUNER Ga CD C DIRECT STEREO OUTPUTS These outputs provide direct signal from the modules priority The My Music MYM TCD features a STEREO PRIORITY OUTPUT in addition to the separate Direct Stereo outputs for the modules The Priority Output will output the signal from the secondary module until signal appears on the primary module MYM TCD CD has priority over TUNER Signal from the secondary module will return automatically once the primary module falls silent This feature allows the user to utilize only one input on their mixer amplifier for both modules Q ANTENNA These terminals provide connections for the antenna of each band There will be two strips of terminals on the M
10. t allows the operator to find an MP3 file based upon its title The find function works on both MP3 data CDs and MP3 files on a USB memory stick MUTE PLAYMODE USB CD 9 6 6 6 6 MUTE Mutes the audio output of the CD USB module CD and MP3 playback continues whilst muted PLAY MODE Toggles between various random and repeat modes Available modes of play include RANDOM REPEAT PLAY ALL PLAY ALL RANDOM REPEAT TRACK REPEAT ALL D use Selects the USB memory stick port as the source for playback cp Selects the CD drive as the source for playback IR This sensor allows for remote control Contact your local Australian Monitor dealer for more information use This socket is for connecting a USB memory stick with MP3 audio files pre loaded CD This slot is for loading either audio CDs or data CD ROMs with MP3 files pre loaded MY MUSIC PROGRAM SOURCE SERIES INSTALLATION amp OPERATION MANUAL FRONT PANEL AM FM TUNER 3 4 A Z Australian Monitor TUNE Jp INSTALLATION SERIES C o ala lt MEMORY D EB 0 TUNER AM FM TUNER BAND MEMORY UP DOWN Changes between AM and FM bands Changes the preset number SLEEP 55 This button allows you to set a countdown timer to switch the These buttons allow the immediate selection of a preset tuner module off It is set in increments of 10mins form 90mins Use 5 to select 6 10 to 10m
11. ts Power down amp disconnect units from mains voltage before making connections Never hold a power switch in the ON position if it won t stay there itself Do not use the unit near stoves heat registers radiators or other heat producing devices 20 Do not block fan intake or exhaust ports Do not operate equipment on a surface or in an environment which may impede the normal flow of air around the unit such as a bed rug weathersheet carpet or completely enclosed rack If the unit is used in an extremely dusty or smoky environment the unit should be periodically blown free of foreign matter Do not remove the cover Removing the cover will expose you to potentially dangerous voltages There are no user serviceable parts inside Do not drive the inputs with a signal level greater than that required to drive equipment to full output Do not connect the inputs outputs of amplifiers or consoles to any other voltage source such as a battery mains source or power supply regardless of whether the amplifier or console is turned on or off Do not run the output of any amplifier channel back into another Channels input Do not parallel or series connect an amplifier output with any other amplifier output Australian Monitor Inc is not responsible for damage to loudspeakers for any reason Do not ground any red hot terminal Never connect a hot red output to ground or to another hot red output
Download Pdf Manuals
Related Search