USER MANUAL
Contents
1. Home when the quadcopter is out of control When the quadcopter is out of control it ll enter Return Home Mode and return back and land in the position when it is unlocked automatically 7 The cancellation of the Return Home Mode In Return Home Mode and after the quadcopter returns to the area in which it can be seen if you want to stop the Return Home Mode you need to do the following steps A If the SWA is in the 0 position in the Return Home Mode set SWA on 1 position first and then turn it back to O position then the Return Home Mode is canceled B If the SWA is on the 1 or 2 position in the Return Home Mode set SWA to 0 position first then turn it back to 1 position and then turn it to 0 position again then the Return Home Mode is canceled NOTE 1 It is suggested to use only Manual Mode Stable Mode and One Key to Return Home Mode for the beginners it means to use the SWA switch only 2 It is required to take off in the Manual Mode 1 Low voltage protection is a protection system designed to avoid the quadcopter crashing in low battery voltage When the battery voltage is between 10 4V to 10 5V the quadcopter will activate the low voltage alarm and give out the beep beep beep sound and the front and rear indicator LED lights will blink at the same time 2 There is 1 2 minutes to fly safely after turning into low voltage protection therefore the pilots need to ad2. NCSA 5 Mode Switch 1 Manual Mode Set SWA to the 0 position After the motors are unlocked raise the throttle stick then it can go forward backward go up down do left side flying right side flying turn left right etc 2 Stable Mode Take off the quadcopter and fly to a fixed height in Manual Mode then set SWA to the 1 position SWB on the 0 position the quadcopter will start to hover then set the throttle stick in the middle position the quadcopter will keep in the current altitude and position NOTE 1 In stable Mode the GPS signal indicator light should be steady lit it means that the signal is good 2 Stable is relatively stable it can move in a certain range depending on the speed of the wind and the weather therefore you need enough space to safely fly it 3 In Stable Mode the throttle stick needs to be in the middle position it will emit a beep beep beep sound when the throttle stick is in the middle position in order for you to better control it 3 One Key to Return Home Mode When you need the quadcopter to return back set the SWB on the 0 position the SWA on 2 position Then the quadcopter will return back from the current position to the starting point automatically If the current position is higher than 15 meters the quadcopter will return back in the current altitude If the current position is lower than 15 meters the quadcopter will rise to the 15 meter height and then
3. craft in flight has risk of uncertain flight pe speed and direction which is potentially e dangerous When flying please keep your Aircraft far away from people high buildings high tension lines etc and avoid operating in rain storms thunder and lightening 2 Keep away from humidity Aircraft should be kept away from humidity and vapor because its complex precise electronic components and mechanical parts may be damaged 3 Proper operation and maintenance Please use Cheerson original spare parts to 4 Safe operation Please fly your Aircraft according to your physical status and flight skills Fatigue listlessness and mis operation will increase the possibilities of accidental hazard 5 Away form highly spinning parts T gt Please keep pilot people and object away from the spinning blades of both man rotor and tail rotor 6 Protect form heat An Aircraft is made from metal fiber plastic and electronic components efe Please keep upgrade modify or maintain your Aircraft in away from heat and sunshine in order to avoid order to ensure its safety Please operate distortion even damage caused by high your Aircraft within the range of functions temperatures permitted It is forbidden to use it outside of the safety laws or regulations 3 Attention before flight 1 Ensure the battery packs of both transmitter and receiver are fully charged saturated 2 Ensure both the throttle stick and the throttle trim of yo
4. erials mechanics electronics aerodynamic and high frequency radio Correct installation and adjustment are necessary to avoid accidents taking place The owner must always operate in a safe manner Improper operation may result in serious property damage bodily injury or over death 2 We accept no liability for damage and consequent damage arising from the use of these products as we have no control over the way they are maintained used and operated 3 This product is suitable for experienced Aircraft pilots aged 14 years or more All minors must be accompanied by a respensible adult when flying 4 The flight field should be legally approved by the local government We accept no liability for any safety duties or fines arising form operation usage or mis control after the sale of the products 5 We oonsign our distributors to offer technical support and service after sale Please contact the local distributors for problem resolutio caused by usage operation maintenance etc 2 Safety mat ers needing attention Aircraft flight is a high risk hobby whose flight should be kept far away from other people Mis assembled or broken main frame defective electronic equipment and or problematic radio system will lead to unforeseen accidents such as bodily inlury or property damage The pilot MUST pay attention to the fight safety and UNDERSTAND his responsibility for accidents caused by his carelessness 1 Far away from obstacles and people An Air
5. is moment close the battery cover when the Red indicator light and the Green indicator light blink slowly alternately 2 Turn on the transmitter the binding with the quadcopter will succeed after the beeping sound of the transmitter stops NOTE Put the throttle stick to the lowest position before the binding 2 SWA SWB switches need to be in the 0 position Receiving the GPS signal 1 For the first time outdoors it takes longer to get the GPS signal please wait about 2 minutes until the LED indicator light becomes steady lit 2 Please do not use the GPS Modes Stable Mode and Return Home Mode indoor in order to avoid accidents Motor Unlock amp Motor Lock 1 Motor Unlock Once binding put down the throttle stick to the bottom right position When the Red light becomes steady the motors are unlocked 2 Motor Lock Once binding put down the throttle stick to the bottom left position When the Red light blinks the motors are locked Motor Unlock Mode 2 Motor Lock Mode 2 Motor Unlock Mode 1 Motor Lock Mode 1 4 Compass Calibration The purpose of calibrating is to assure the quadcopter s compass can pinpoint itself in the GPS so that the return to home function can work properly Calibrating your quadcopter is especially important when flying in a new air field for the first time 1 Mode 2 Lower the throttle to the cut off position the aileron elevator stick to the lower right corner connect the
6. just the flying distance and to prepare to return safely 1 Low voltage protection is a protection system designed to avoid the signal interruption for the transmitter in low battery voltage 2 When the battery voltage is low the transmitter will give out the beep beep beep sound and the power indicator light will blink slowly at the same time 3 Please change the battery in low voltage protection Frequently asked Fly in circle in Stable Mode 2 Fly 3 5 minutes in Manual Mode and it ll get the GPS signals automatically Motors do not work 1 SWA switch is not set on the 0 position 2 Low battery voltage please change the battery ea settee Make sure the propellers are installed correctly reinstall the propellers if they are installed reversely Does not return home accurately Poor GPS signal Change to some other open places The quadcopter The quadcopter need to be re calibrated cannot hover 1 Poor GPS signal Change to some other open places NCSA 1 LED instruction The indicator light for the flight control board calibration motor unlock lock indicator light yellow LED light red LED light GPS signal indicator light Green LED light EAN ES cat p p N l ep gt Bo SS The rear downward LED GREEN The front downward LED The rear downward LED GREEN 2 The description of the LED indicator light status 1 The front indicator light a The red light keeps steady when the motor
7. n Altitude Sensor Mode the throttle stick needs to be in the middle position making beep beep beep sound when the throttle stick is in the middle position in order for you to better control it 2 Constant altitude is relatively constant it can move in a certain range depending on the speed of the wind and the weather therefore you need enough space to safely fly it 1 The Propeller Installation 1 To prepare the quadcopter and the propellers 2 The propellers with spin mark should be installed upward make sure the spin mark of the propellers is matched accordingly to the spin mark on the quadcopter arm 3 Use the included hex wrench in the kit to tighten the prop nut of the motor Note The blade prop nuts feature reversed threads they will be tightened by spinning counter clockwise The silver prop nuts feature standard threads they will be tightened by spinning clockwise Anti clockwise propeller Clockwise propeller 2 The Landing Gear amp Antenna Installation 1 Preparing the quadcopter and the landing gear 2 Install the landing gear with the antenna hole aligned to match where the antenna exits the body and fix the landing gear with the screws 3 Install the other landing gear on the opposite side and fix the landing gear with the screws 4 Place the antenna in the groove of the landing FN gear LN 5 Fix the antenna in the groove of the landing a gear with clear tape NCSA 6 Return
8. power of the model then turn on the power on the transmitter while holding the right stick to lower right corner position The flight controller has 5 seconds delay before arming if within 5 seconds the syncing wasn t successful the flight controller would not turn on to calibrating mode Mode 1 Position the elevator stick to the lowest position then position the throttle stick to the lower right corner and hold connect the power on the model and then turn the power on the transmitter on The flight controller has 5 seconds delay before arming if within 5 seconds the syncing wasn t successful the flight controller would not turn on to calibrating mode When the flight controller is in calibrating mode the indicator to the left will flash red and yellow while the GPS indicator stays unchanged When calibrating turn the quadcopter in one direction for 3 to 5 circles then point the nose of the quadcopter to the ground then turn the quadcopter in one direction for 3 to 5 circles while the nose is still pointing to the ground Unplug the power source the flight controller will automatically save the calibration input
9. return back NOTE 1 In Return Home Mode make sure the GPS signal indicator light remains steady lit it means that the signal is good 2 It s suggested to switch to the Stable Mode first or until the quadcopter becomes stable before initiating Return to Home Mode 3 After returning back the quadcopter will lock automatically if you need to restart the motor please set the SWA to 0 position first and then unlock the motors Flight Direction Lock Mode While flying set SWA on the 1 position and SWB on the 1 position first The quadcopter will then fly as if the front of the quadcopter is always pointing in the same position as when you entered this flight mode You can turn the quadcopter left right but it will always respond to bank left right and forward back inputs as if the front of the quad is still facing the initial position when entering this flight mode NOTE 1 This mode is not appropriate for beginners it requires more skills and experience to do so 2 In this mode the quadcopter can return safely in long distance or in poor light 5 Altitude Sensor Mode After taking off in the Manual Mode to set SWB on the 1 position and SWA on the 2 position then push the throttle stick to the altitude you want and to set the throttle stick to the middle position the quadcopter will remain the current altitude constantly and in the Altitude Sensor Mode the quadcopter will fly in constant altitude NOTE 1 I
10. starts b The red light blinks in low voltage condition and there s an alarm sound if the battery voltage drops below 10 6V 2 The rear indicator light a The green light keeps steady when the motor starts b The green light blinks in low voltage condition and there s an alarm sound if the battery voltage drops below 10 6V 3 The indicator light of the main control board calibration motor unlock lock indicator light The yellow indicator light and red indicator light blink alternately when the main control board calibrates The red indicator light blinks slowly when the motor is locked and the red indicator light stays lit when motor is unlocked GPS signal indicator LED light The green indicator light blinks when less than 6 satellites from the GPS system are received the green indicator light stays solid lit when more than 6 satellites from the GPS system are received NOTE The satellites received from the GPS system must be more than 6 satellites in Stable Mode and Return Home Modes The green indicator light stays solid lit NCSA Dear customer Thank you for purchasing a Quanum radio control aircraft product In order to quickly and safely master the operation of the NOVA please read the user handbook carefully and then keep it in a safe place for futureconsultation and refernce 1 Important Statement 1 This product is not a toy It is a piece of complicated equipment which harmoniously integrates engineering mat
11. ur transmitter stay at the lowest positions before operation 3 Please strictly obey the order of turn on and rurn off before operation When starting your flight please turn on your transmitter first and connect the power cable of your Aircraft last When finishing your flight please disconnect the power cable of your Aircraft first and turn off your transmitter last 4 An upset in the order of connection may cause your Aircraft to loose control Please cultivate a correct habit of turn on and rurn off NUUA 1 The transmitter introduction 2 4G Antenna AN Auxiliary channel 1 Auxiliary channel 2 Manual Mode Indicator Light SWB Mode switch SWA Mode switch Stable Mode Indicator Light One key To Return Home Mode Throttle Turning Left Right Stick Forward Backward Lommer Left side Right side flying stick Power ON OFF Power indicator light Low voltage indicator light Buzzer speaker 2 Transmitter Mode setting the NOVA is used as the example Mode type SWA Setting SWB Setting Manuail Mode o 0 Flight Directi mae 2 oe Home Mode 2 NOTE Whether flying indoors or out set the transmitter in Manual Mode before take off SWA Mode ON OFF NUUA 4 Basicoperaton 1 Binding 1 Insert the battery into the quadcopter battery bay and connect the power plugs The Red indicator light and the Green indicator light will blink rapidly alternately please do not move or shake the quadcopter at th
Download Pdf Manuals
Related Search