wdh-930ed new widetech
Contents
1. CAUTIONS Do not pull the power cord to avoid broken cord which lead to danger i n1 1 a 3 Bey fa Do not place the machine on an uneven Please always keep the unit 20 cm away from the ground to avoid shaking noise and leakage wall to dissipate the heat properly of water Do not use insect oil or paint spray around the machine it might cause damage to the plastic parts or start a fire 20 cm Maa It is dangerous to put anything into the Close all the open windows to reach the maximum machine possible efficiency of removing moisture Keep the machine away from any type of heat When moving or put in storage do not place the sources dehumidifier on side way or upside down and avoid violent shaking li Wt MAINTENANCE For safety reasons make sure the dehumidifier is unplugged before serving or cleaning the machine 1 Cleaning the shell A A Wipe the shell with a clean soft cloth B If the dehumidifier is very dirty use mild detergent then wipe off the detergent with half dried cloth C Do not wash the machine with a hose or immerse2. DEFROST LAMP When low temperature unit gets into defrosting mode and lamp lights CURRENT TEMP TIMER SET DISPLAY When machine is running it displays the current temperature Press the Timer button to set the machine to shut off automatically after a specified amount of time 10 seconds after displaying the timer the display will change back to current temperature A DDooc Ch DEHUMIDIFIER FAN SPEED High Low POWER On Off TIMERS When unit operates press TIMER set hours unit will off after set hours When unit stand by press setting The humidity is adjusted in an increment SET HUMIDITY CURRENT HUMIDITY DISPLAY Press the CF switch buttons When machine is running it displays the current it will switch at humidity Press A or V to select humidity P of TIMER set hours unit will on of 5 by each pressing of A or V Adjustable after set hours Setting timer from 1 24 hours To cancel the timer proceed as above but set the timer off to zero hours range is within 30 RH to 90 RH 10seconds after setting humidity the display will change back to the current humidity OPERATING INSTRUCTIONS Start Operation 1 Place the product in an upright position on a flat steady stable heat resistant surface Make sure there is nothing flammable o
3. Tig NEW WIDETECH WDH 930ED DEHUMIDIFIER CONTENTS WARNING AUTO NA SS 1 DESCRIPTION OF COMPONENTS FUNCTIONEXPLANATION 2 OPERATIONINSTRUCTIONS e s 8 sf 8 3 CONTINUOUS DRAINAGE e 4 CAUTIONS a s amp Rk Owe ew oe ee 5 MAINTENANCE EMERGENCY ee 6 SPECIFICATION e e gt eoe eses LAST PAGE USER S MANUAL THANKS FOR YOUR CHOOSING GLENDIMPLEX S DEHUMIDIFIER BEFORE USING IT PLEASE READ THOROUGHLY OF THIS INSTRUCTION MANUAL Do not fold the power cord as shown below KD i Make sure the plug is clean Do not place anything on top of the control panel Do not wet the machine or the control panel WARNING Make sure the plug is placed fully amp firm into the socket O After turning the unit off please take plug out of the socket Do not place anything over the inlet or outlet points Keep the flammable gas oil away from the machine Do not use multiple socket as shown below Do not have wet hands when connecting the power plug Do not let children by play with the unit or control Ask professionals to do the servicing DESCRIPTION OF COMPONENTS BUCKET FULL LAMP Water tank is full and lamp lights
4. it in water The may cause leakage of electricity 2 Cleaning the air filter The propose of the air filter is to filter dust and other materials from the air If the filter is blocked by dust the electricity usage will be greater than normal For optimal moisture removal efficiency clean the filter every two weeks Cleaning Steps A Pull the air filter out gently B Clean the filter with a vacuum cleaner or wash it with clean water and dry with a dry cloth C Put the clean air filter back in place and continue to operate the dehumidifier EMERGENCY Ifa problem occurs unplug the machine and contact a qualified serving center immediately Do not disassemble the dehumidifier yourself SPECIFICATION MODEL WDH 930ED 15 L D 27 C 60 RH 30 L D 30 C 80 RH MOISTURE REMOVAL SIZE OF SHELL 340 253 540 H W D OPERATING TEMPERATURE o f the power cord on this unit is damaged it must be replaced by the manufacturer its service agent or qualified persons in order to avoid a hazard O This appliance is not intended for use by children or other persons without assistance or supervision if their physical sensory or mental capabilities prevent them from using it safely Children should be supervised to ensure that they do not play with the appliance Please recycle where facilities exist Check with your local authority or retailer for recycling advice iy NEW WIDETECH Wa
5. r heat sensitive within 100 cm 39 inches Operating the product in any other position could cause a hazard 2 Insert the plug into a suitable wall socket The dehumidifier is suitable for operation on an electricity supply having the same voltage as that shown on its rating label 3 Make sure the water tank is correctly located After switching on the machine for the first time if the Bucket Full lamp illuminates just pull out the water tank check the float lever is able to move freely then return the water tank to the correct position A ne 59 Doo e ZScHUMIDIFIER When Bucket Full Lamp Is On When the water tank is full the machine will stop and the Bucket Full light will illuminate The water tank should be carefully removed from the machine by sliding it outwards from the front of the machine and it should be emptied When the empty tank is replaced properly into the machine the machine will start up and run normally Please use both hands to carefully empty the water tank DEFROST When the machine is operated at low temperatures less than 12 C the surface of the evaporator may accumulate a layer of frost which would reduce the efficiency of the machine When this happens the machine will go into periodic defrost mode The defrost symbol onthe LCD display will come on The machine will operate in temperatures down to 5C The time taken to defrost may vary If the machine freezes
6. ste electrical products should not be disposed of with household waste E NEW WIDETECH INDUSTRIES CO LTD 8F 8 NO 112 SHIN MIN ST CHUNG HO CITY TAIPEI HSIEN TAIWAN TEL 886 2 22265381 FAX 886 2 22265539
7. up it should be turned off at the power supply and re started If the room temperature remains below 5 C the machine should be switched off CONTINUOUS DRAINGE The function of continuous drainage can be started in following steps when there is a good condition of drainage near by the unit f 1 To save having to periodically empty the water tank this unit can be configured for continuous drainage You can use the supplied drain hose to connect to the continuous drainage connector N Back of the unit Drain hose e Drain cover on W Dran cover 2 Unscrew and remove the drain cover at the rear of the unit 3 Remove the soft rubber stopper Put it into the water tank for safe keeping Soft rubber stopper JA o _ Drain cover 4 Insert the drain hose through the hole of the drain cover Drain cover Drain hose Hy 5 Connect the drain hose to the drain port 6 Tighten the drain cover in clockwise direction onto the rear of the unit Drain cover Mit Drain hose 7 Place the bucket on its original location Drain hose Sl Bucket J INSTALLING DRAINAGE PVC HOSE When using the function of continuous drainage the PVC hose must be placed horizontally below the drainage hole Must avoid uneven ground and folding the hose S
Download Pdf Manuals
Related Search