EXTECH INSTRUMENTS CT100 Network Cable Tester user manual
Contents
1. EXTECH INSTRUMENTS CT100 Network Cable Tester user manual http www manuallib com file 2691072 From ManualLib com ManualLib com collects and classifies the global product instrunction manuals to help users access anytime and anywhere helping users make better use of products Home http www manuallib com Chinese http www shuomingshuku com EXTECH User Guide NSTRUMENTS CT100 Network Cable Tester Introduction Congratulations on your purchase of the Extech CT100 Network Cable Tester System The system consists of a Transmitter and a Receiver This system automatically performs the following tests Continuity Open Short Circuits and Wire Crosses Reversals The CT100 tests F type coaxial and RJ45 terminated cables meeting the following wiring standards e 10Base T e AT amp T258A e EIA TIA 568B e Token Ring Operation WARNING Do NOT test on LIVE CIRCUITS 1 Power the transmitter by moving the ON OFF switch to the ON position The power LED will light 2 To test a patch cable connect one end of the cable under test to the Transmitter and the other end to the Receiver Testing begins automatically and is indicated by the stepping action of the e0000 E LEDs on the Receiver Note To test cabling that is part of an installation the Transmitter and Receiver must be connected in line with the installation Patch cords needed to connect from wall plates to the Transmitter and Receiver must be provid2. ed by the user 3 Test result examples are listed below 10Base T EIA TIA 568A s 10Base T o00ee x a i Al 4 Pair Test A 2 Pair Test 1 2 and 3 6 Pass Green x 4 Pass Green x 2 1234 5678 Fail Red or No Light 12949618 Fail Red or No Light EIA TIA 568B Token Ring AT amp T 258A C8 CC m O0 eO PR3 E PR2 4 Pair Test A 2 Pair Test 3 6 and 4 5 Pass Green x 4 Pass Green x 2 TES E9078 Fail Red or No Light TES 9878 Fail Red or No Light Screened Shielded Cable PR2 Ee 00000 PR3 A 4 Pair Shield Test Pass Green x 1 Pass Green x 5 Fail Red or No Light 1234 5678 Fail Red or No Light Battery Replacement Transmitter only 1 Turn power OFF on the Transmitter disconnect any cables and remove the Transmitter s rear screw to access the battery compartment The Receiver does not contain batteries 2 Replace the two AAA 1 5V batteries and re assemble the Transmitter Warranty EXTECH INSTRUMENTS CORPORATION warrants this instrument to be free of defects in parts and workmanship for one year from date of shipment a six month limited warranty applies on sensors and cables If it should become necessary to return the instrument for service during or beyond the warranty period contact the Customer Service Department at 781 890 7440 ext 210 for a
3. uthorization or visit our website at www extech com click on Contact Extech and go to Service Department to request an RA number A Return Authorization RA number must be issued before any product is returned to Extech The sender is responsible for shipping charges freight insurance and proper packaging to prevent damage in transit This warranty does not apply to defects resulting from action of the user such as misuse improper wiring operation outside of specification improper maintenance or repair or unauthorized modification Extech specifically disclaims any implied warranties or merchantability or fitness for a specific purpose and will not be liable for any direct indirect incidental or consequential damages Extech s total liability is limited to repair or replacement of the product The warranty set forth above is inclusive and no other warranty whether written or oral is expressed or implied Copyright 2002 Extech Instruments Corporation All rights reserved including the right of reproduction in whole or in part in any form Website www extech com Email support extech com Rev 1 0 9 02
Download Pdf Manuals
Related Search