User manual - Pdfstream.manualsonline.com
Contents
1. 1 In mute mode quickly press AUX twice L gt The factory settings is restored EN 8 5 Wall mount H noe e Improper wall mounting may result in accident injury or damage If you have any query contact Consumer Care in your country e Before wall mounting make sure the wall can support the weight of your SoundBar Screw length diameter Depending on the type of wall mounting your SoundBar make sure that you use screws of a suitable length and diameter 3 3 5mm kr gt 25mm For information about how to wall mount your SoundBar see the quick start guide 6 Product specifications Note e Specifications and design are subject to change without notice Amplifier e Total output power 40W RMS 0 5 dB 10 THD e Frequency response 20 Hz 20 kHz 3 dB e Signal to noise ratio gt 65 dB CCIR A weighted e Input sensitivity e AUX 650 mV e AUDIO IN 400 mV Audio e S PDIF Digital audio input Coaxial IEC 60958 3 Optical TOSLINK Main unit e Power supply 220 240 V 50 Hz Power consumption 40 W Standby power consumption lt 0 5 W e Speaker impedance 8 ohm full range e Speaker drivers 4 x 54 5 mm 2 Dimensions WxHxD 845 x 74 5 x 94 mm e Weight 2 0 kg Remote control batteries e 1 x CR22. coupler is used as the disconnect device the disconnect device shall remain readily operable Disconnect the product from the power outlet before lightning storms When you disconnect the power cord always pull the plug never the cable of short circuit or fire Before you connect the product to the power outlet ensure that the power voltage matches the value printed on the back or bottom of the product Never connect the product to the power outlet if he voltage is different of injury or damage to the SoundBar ever place the product or any objects on power cords or on other electrical equipment f the product is transported in emperatures below 5 C unpack the product and wait until its temperature EN Risk Risk Risk matches room temperature before connecting it to the power outlet Parts of this product can be made of glass Handle with care to avoid injury and damage of overheating ever install this product in a confined space Always leave a space of at least four inches around the product for ventilation Ensure curtains or other objects never cover the ventilation slots on the product of contamination Do not mix batteries old and new or carbon and alkaine etc Danger of explosion if batteries are incorrectly replaced Replace only with the same or equivalent type Remove batteries if they are exhausted or if the remote control is not to be used for a long time Bat
3. See Copyright Act 1956 and The Performer s Protection Acts 1958 to 1972 Care for your product Use only microfiber cloth to clean the product Care of the environment ab Your product is designed and manufactured with high quality materials and components which can be recycled and reused i When this crossed out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002 96 EC Please inform yourself about the local separate collection system for electrical and electronic products Please act according to your local rules and do not dispose of your old products with your normal household waste Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health m Your product contains batteries covered by the European Directive 2006 66 EC which cannot be disposed with normal household waste Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health Help and support For extensive online support visit www philips com support to e download the user manual and the quick start guide e watch video tutorials available only for selected models e find answers to frequently answered questions FAQs e email us a question e chat with our s
4. quality connection available on your TV Soundbar and other devices Option 1 Connect audio through a digital optical cable Best quality audio DIGITAL IN OPTICAL 1 Using an optical cable connect the OPTICAL connector on your SoundBar to the OPTICAL OUT connector on the TV or other device e The digital optical connector might be labeled SPDIF or SPDIF OUT Option 2 Connect audio through a digital coaxial cable Good quality audio DIGITAL IN COAXIAL IN 1 Using a coaxial cable connect the COAXIAL connector on your SoundBar to the COAXIAL DIGITAL OUT connector on the TV or other device e The digital coaxial connector might be labeled DIGITAL AUDIO OUT Option 3 Connect audio through analog audio cables Basic quality audio 1 Using an analog cable connect the AUX connectors on your SoundBar to the AUDIO OUT connectors on the TV or other device AUX IN AUDIO IN 4 Use your SoundBar This section helps you use the SoundBar to play audio from connected devices Before you start e Make the necessary connections described in the quick start guide and the user manual e Switch the SoundBar to the correct source for other devices Adjust the volume 1 Press VOLUME to increase or decrease a volume level e To mute sound press amp MUTE e To restore the sound press amp MUTE again or press VOLUME L gt All So
5. 025 EN 10 7 Troubleshooting Warning e Risk of electric shock Never remove the casing of the product To keep the warranty valid never try to repair the product yourself If you have problems using this product check the following points before you request service If you still have a problem get support at www philips com support Sound No sound from SoundBar speakers Connect the audio cable from your SoundBar to your TV or other devices e Reset your SoundBar to its factory settings e On the remote control select the correct audio input e Make sure that the SoundBar is not muted Distorted sound or echo e If you play audio from the TV through the SoundBar make sure that the TV is muted 8 Notice This section contains the legal and trademark notices Compliance CE This product complies with the radio interference requirements of the European Community Trademarks O1 DOLBY DIGITAL Manufactured under license from Dolby Laboratories Dolby and the double D symbol are trademarks of Dolby Laboratories EN 12 PHILIPS 2013 WOOX Innovations Limited All rights reserved Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N V and are used by WOOX Innovations Limited under license from Koninklijke Philips N V HTL2100_12_UM_V7 0
6. Always there to help you Register your product and get support at www philips com welcome HTL2100 HTL2100B a _ Question a n cacet HTL21 00G Philips HTL21 00S HTL2100T HTL2100W User manual PHILIPS Contents 1 Important 3 Safety 3 ains fuse 4 Care for your product 4 Care of the environment 4 elp and support 4 2 Your SoundBar 5 ain unit 5 Remote control 5 Connectors 6 3 Connect 7 Connect audio from TV and other devices 7 4 Use your SoundBar 8 Adjust the volume 8 Choose your sound 8 MP3 player 8 Auto standby 8 Apply factory settings 8 5 Wall mount 9 6 Product specifications 0 7 Troubleshooting 1 8 Notice 2 Compliance 2 Trademarks 2 EN 1 Important Read and understand all instructions before you use your product If damage is caused by failure to follow instructions the warranty does not apply Safety Risk of electric shock or fire Risk Risk lever expose the product and accessories o rain or water Never place liquid containers such as vases near the product f liquids are spilt on or into the product disconnect it from the power outlet immediately Contact Consumer Care to have the product checked before use lever place the product and accessories near naked flames or other heat sources including direct sunlight ever insert objects into the ventilation slots or other openings on the product Where the mains plug or an appliance
7. al surround sound 1 amp Mute or restore volume BASS Increase or decrease volume VOLUME Increase or decrease volume AC MAINS eo AUDIO IN Switch your audio source to audio input Oo connection 3 5mm jack OPTICAL DIGITAL IN AUX Switch your audio source to the AUX connection Q AUDIO IN AUX Connect to an analog audio output on the TV or an analog device Connectors DIGITAL IN COAXIAL Connect to a coaxial audio output on the This section includes an overview of the TV or a digital device connectors available on your SoundBar GB DIGITAL IN OPTICAL Connect to an optical audio output on the Side right TV or a digital device AC MAINS Connect to the power supply o Q AUDIO IN Audio input from an MP3 player 3 5mm jack EN 6 3 Connect This section helps you connect your SoundBar to a TV and other devices For information about the basic connections of your SoundBar and accessories see the quick start guide Note e For identification and supply ratings refer to the type plate at the back or bottom of the product e Before you make or change any connections make sure that all devices are disconnected from the power outlet Connect audio from TV and other devices Play audio from TV or other devices through your Soundbar speakers Use the best
8. teries contain chemical substances they should be disposed of properly of swallowing batteries The product remote control may contain a coin button type battery which can be swallowed Keep the battery out of reach of children at all times If swallowed the battery can cause serious injury or death Severe internal burns can occur within two hours of ingestion f you suspect that a battery has been swallowed or placed inside any part of the body seek immediate medical attention When you change the batteries always keep all new and used batteries out of reach of children Ensure that the battery compartment is completely secure after you replace the battery If the battery compartment cannot be completely secured discontinue use of the product Keep out of reach of children and contact the manufacturer This is CLASS I apparatus with double insulation and no protective earth provided Mains fuse This information applies only to products with a UK mains plug This product is fitted with an approved molded plug If you replace the fuse use one with e the ratings shown on the plug e a BS 1362 approval and e the ASTA approval mark Contact your dealer if you are not sure about what type of fuse to use Caution To conform with the EMC directive 2004 108 EC do not detach the plug from the power cord Copyright in the U K e Recording and playback of material may require consent
9. upport representative Follow the instructions on the website to select your language and then enter your product model number Alternatively you can contact Consumer Care in your country Before you contact note down the model number and serial number of your product You can find this information on the back or bottom of your product EN 4 2 Your SoundBar Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your SoundBar at www philips com welcome Main unit This section includes an overview of the main unit O SURR indicator Lights up when you select Virtual Surround sound Q Source indicators Source indicator lights up when a source is selected e COAXIAL Lights up when you switch to coaxial input source e OPTICAL Lights up when you switch to optical input source e AUX Lights up when you switch to analog input source e AUDIO IN Lights up when you switch to audio input source 3 5mm jack Remote control This section includes an overview of the remote control PHILIPS SOUNDBAR SPEAKER 4 Standby On Switch the SoundBar on or to standby COAX Switch your audio source to the coaxial connection 3 OPTICAL Switch your audio source to the optical connection 4 TREBLE Rear connectors Increase or decrease treble SURR Toggle between stereo and virtu
10. urce indicators on the main unit blink twice when a volume is set to the maximum or minimum value Choose your sound This section helps you choose the ideal sound for your video or music Surround sound mode Experience an immersive audio experience with surround sound modes 1 Press SURR to select a surround mode e Virtual Surround Creates a highly surround listening experience The SURR indicator on the main unit lights up e Stereo Two channel stereo sound Ideal for listening to music Equalizer Change the high frequency treble and low frequency bass settings of the SoundBar d Press TREBLE or BASS to change the frequency L gt All Source indicators on the main unit blink twice when treble or bass is set to the maximum or minimum value MP3 player Connect your MP3 player to play your audio files or music What you need e An MP3 player e A 3 5mm stereo audio cable 1 Using the 3 5mm stereo audio cable connect the MP3 player to the AUDIO IN connector on your SoundBar Press AUDIO IN Press the buttons on the MP3 player to select and play audio files or music WN Auto standby When playing media from a connected device the SoundBar automatically switches to standby if no button is pressed for 30 minutes and e no audio play from a connected device Apply factory settings You can reset your SoundBar to the default settings programmed at the factory
Download Pdf Manuals
Related Search