Home

Pond-Bio

1. 5 Operating Instructions Pond Bio filter CBF 350 ARTICLE 50107 CBF 350B ARTICLE 50108 CBF 350C ARTICLE 50114 LICHT KRAFT TECHNIK Read and follow the operating instructions and safety information before using for the first time Technical changes reserved Due to further developments illustrations functioning steps and technical data can differ insignificantly Updating the documentation If you have suggestions for improvement or have found any irregularities please contact us by WilTec Wildanger TechnikGmbH Seite 4 http www wiltec info The information contained in this document is subject to change without prior notice No part of this document can be copied or duplicated in another form without the prior written consent of Wiltec Wildanger Technik GmbH The Wiltec Wildanger Technik GmbH assumes no liability for any errors in this user manual or the connection diagram Although Wiltec Wildanger Technik GmbH has made every effort to make sure that this user manual is complete accurate and updated errors cannot always be avoided In the event of problems with this user manual please complete and send this form back to us FAX notification 49 2403 55592 15 from Name Firm Tel Fax would like to report the following mistakes Customer Service Wiltec Wildanger Technik GmbH e mail service wiltec info Tel 4 49 2403 55592 0 by WilTec Wildanger TechnikGmbH
2. Seite2 http www wiltec info ij Thank you for purchasing this quality product To minimize the risk of injury by means of fire or electric shock we urge that our clients take some basic safety precautions when using this device Please read the operation instructions carefully and make sure you have understood its content Introduction Safety guideline A ATTENTION The device is not intended for use by persons including children with impaired or limited physical sensory and mental abilities or lack of experience and or real knowledge unless they are supervised by a person responsible for their safety or you follow the instructions made by this person how to use the device correctly Children should be supervised to make sure they do not play with the device A ATTENTION e Run a visual inspection of the device before every use Do not use the device if the safety appliances are damaged or worn out Never override safety regulations e Use the device exclusively according to the intended purpose stated in the instructions for use You are responsible for the safety of the working environment The device cannot be installed in the drinking water circuit The device can be installed only out of the water lt must be ensured that the device cannot fall into the water Place the device in such a way so that it is not exposed to direct sun light Die universal hose connectors stepped hose tails can be shortened if n
3. one channels conducts the whole pond content through the filter within a specific time unit circulation per hour The following values may serve as guide values Koi pond fish pond 1 x in 3 hours up to 2 circulation circuits in 1 hour without plants and with high fish stock Garden pond plants pond If the pond has no fish stock can leave out the circuit circulation In this case water and marsh plants are a sufficient replacement substitute for a filter system Natural swimming pond Here the circulation cycle is strongly influenced greatly dependent on the plants and your own requirements The upper limit is 1 x in 2 3 hours the lower limit by circulation cycle 2 The water dwelling time in the Filter length of stay filter volume Here the real volume of the filter applied by pressureless sytems is interesting 50107 CPF 350 approx 85 Litre 50108 CPF 350B approx 170 Litre 50114 CPF 350C approx 250 Litre After a period of time of approx 2 3 weeks nitrifying bacteria settle the filter sponges These need time in order to affect have an impact on the water The intended period that the pond pump need in order to fully fill the filter once is by the above mentioned filter volume between 1 5 minutes and 3 minutes A good run in filter needs therefore NO circulation cycle of 2 3x per hour It definitely suffices here depending on the pond size to have cycles of 1 2x every 10 h
4. ecessary to match the hose diameter e Apply mount the hoses and the hose clamps WARNING Read carefully all the safety guidelines and the instructions Keep the instructions and the safety guidelines in a safe place in case you need them in the future Wear resistance The max temperature of the conveyed liquid should not exceed 35 C in permanent operation The filter is exclusively designed and intended for filtering garden ponds The filter is not suitable for filtrating water that exceeds 40 C or falls below 8 C Do not use in combination with oil petrol or lubricant The filter is not frost resistant Therefore it is recommended not to use the filter in winter The filter cannot be used under water e The filter must be placed at least 2m away from the pond edge by WilTec Wildanger TechnikGmbH Seite 3 http www wiltec info Technical Data Number of fiter mats 4 O Ce 2 CoE ia for fish ponds up to 25m 45 up to Connection to UV Lamp CUV 118 18W CUV 136 36W CUV 136 36W optional According to the type of use the optimal circulation cycle is dependent on various factors fish population water plants solar radiation and the desired water clarity Of course the other components of the filter circuit must be harmonised with one another if necessary Basically there are two distinctions 1 Optimal pond circulation This refers to how often
5. ilter mats and the maintenance The optimal design of the filter enables an easy cleaning Dirt indicator Temperature indicator by WilTec Wildanger TechnikGmbH Seite5 http www wiltec info Commissioning aS 11 12 Remove the top cover 1 take out the bio filter sponges 7 and wash them Wash also the filter mats 8 Bring the cleaned filter materials to their exact position again If the pond filter has a UV lamp place the filter at least 2m away from the pond shore on a firm and even ground The filter must be levelled and sit up straight in order to avoid overflowing Install the discharge hose for the water outlet directed towards the pond and the hose for the dirt outflow towards the sewer system or the flower bed with sufficient gradient sufficient inclination Cut the stepped hose tails at the corresponding place Then insert the hose in the stepped hose tail connect them and tighten it with a hose clamp Insert a flat gasket ring 19 over the thread of the stepped hose tail Afterwards push the thread of the stepped hose tail through the water inlet opening Insert a second flat gasket ring from the inside on the thread and the screw the outlet nozzles 18 from inside on the thread Connect now the other end of the hose with the pump For the normal filter operation leave the dirt outflow with its screw cap 17 and the sealing ring 15 closed If you want to install a permanent 2 inch h
6. ose remove the screw cap in order to install the hose Install the upper cover Supply the filter with voltage Now the filter starts working A NOTE The bio filter is a biological filter system and needs a few weeks if newly installed to reach its full biological efficiency by WilTec Wildanger Technik GmbH Seite 6 http www wiltec info Cleaning and maintenance Attention Before cleaning and maintenance works disconnect the pump filter The device should be cleaned when required see dirt indicator 2 For this reason no chemical cleaning agents are allowed because they can destroy the bacteria in the filter soonges As soon as the float of the dirt indicator becomes visible disconnect the pump and the clarifier from the power supply and open the upper cover Take out the filter soonges by holding them by the fix up 6 Press together squeeze the filter soonges slowly for several times against the grips 6 sponge fix up 9 sponge press board If necessary clean the filter soonges with pond water Open the screw cap of the dirt outflow until the water has drained away At temperatures below 8 C or higher than 40 C the device must be taken out of operation Therefore empty the filter and clean the device thoroughly Remove all filter materials in order to dry them Keep the filter materials in dry frost free place over the winter Cover the filter housing so that no rain water can ingress Empty all the hoses pi
7. ours by WilTec Wildanger TechnikGmbH Seiteg http www wiltec info Calculation example A specific example Our pump manages 10 000 litre per hour This means that by our Pond Test with 100 000 litre volume the pond is completely filtered every 10 hours In 24 hours this means 2 4 times cycles in which the water in our pond filter flows through and is clarified Because our filter takes 250 litre water and in one hour 10 000 litre are pumped into the pond filter it means that the pond filter is fully filled with water 40 times per hour This means every 1 5 minutes the filter is fully filled once Consequently our bacteria have only 1 5 minutes time to have an effect on the water and give clear filtered water We recommend according to your needs to find a reasonable compromise beween both systems to achieve an optimal pond filtration Intended use Products of this series are optimal for the cleaning of garden and fish ponds If it is correctly applied the pond water is effectively cleaned Biodegradable filter materials clean the water from bacteria through mechanical filtering Equipment features partly optional Efficient cleaning through ultraviolet light sterilisation before filtering Powerful bio filtering by means of large filters multi cchamber system easy installation and cleaning due to its modular structure The water flow system that conducts the first step of the filtration reduces the pressure on the f
8. pelines and connectors to the extent possible Before starting up the filter again install it again with the open side towards the exit by WilTec Wildanger TechnikGmbH Seite 7 http www wiltec info 10 11 12 13 Disposal regulations EU guidelines regarding the disposal of scrap electric appliances WEEE 2002 96 EC were implemented in the law related to electrical and electronic equipment and appliances All Wiltec electric devices that fall under the WEEE regulations are labelled with the crossed out wheeled waste bin logo This logo indicates that this electric equipment must not be disposed with the domestic waste The company Wiltec Technik GmbH has been registrated in the German registry EAR under the WEEE registration number DE45283704 Disposal of used electrical and electronic appliances intended for use in the countries of the European Union and other European countries with a separate collection system for these appliances The logo on the article on its packaging points out that this article must not be treated as normal household waste but must be disposed to a recycling WilTec Wildanger Technik GmbH collection point for electronic and electrical waste DE 52249 Eschweiler equipment By contributing to the correct disposal of this article you protect the environment and the health DE45283704 of your fellow men Environment and health are threatened by inappropria
9. te disposal Materials recycling helps reduce the consumption of raw materials Additional information on recycling this article can be provided by your local community municipal waste disposal facilities or the store where you purchased the article Address WilTec Wildanger Technik GmbH Konigsbenden 12 28 D 52249 Eschweiler Important notice The reprint or reproduction even of excerpts and any commercial use even in part of this instructions manual require the written permission of Wiltec Wildanger Technik GmbH by WilTec Wildanger TechnikGmbH Seite 9 http www wiltec info C i by WilTec Wildanger TechnikGmbH Seite 10 http www wiltec info

Pond-Bio

Contents

Download Pdf Manuals

Related Search

Related Contents