WRX-1 Single DMX universe receiver
Contents
1. If successful the receivers W DMX indicator will go ON 6 2 To unlink from a transmitter 1 Onthe receiver press and hold the LINK button until the W DMX indicator goes OFF The receiver is now unlinked 7 Trussholders mounting Useastandard Truss clamp to be inserted in the screw hole top of the box e Make sure that the installation is safe and secure 8 9 ignition s Importer B amp K Braun GmbH Industriestra e 1 D 76307 Karlsbad Ittersbach www bkbraun com info bkbraun com RoHS 9792. Antenna Shows the receiving state OFF not linked with a transmitter ON linked with a transmitter Rapid Flash Linking with transmitter WRX 1 4 Rear panel details DMX Out 3Pin XLR 5Pin XLR Rj45 Powercon In and Out f x E POWERCON IN POWERCON OUT DC 12V Ih 12V In for Accu Pack Usage 5 9 ignition 5 Technical data DMX INTERFACE WRX Full compliance with USITT DMX 512 1990 amp 512 A standards Maximum number of transceivers on a single bus 32 compliant with the EIA TIA RS 485 standard Data rate Electrostatic discharge protection DMX frame rate and frame size Frame rate Frame size Recovery from loss of DMX input or radio link 250kbps slew rate limited to minimize EMI 15 kV Auto sensing 1 min to 44 max frames per second 1 min to 512 max channels Less than 1 second Loss of DMX input or radio link After one second if there is no resumption the DMX output will cease to transmit and go into a high impedance mode Power characteristics High voltage input Low voltage input Average current transmit mode RF characteristics 90 260 VAC 12VDC 200 mA 12VDC W DMX uses Adaptive Frequency Hopping Spread Spectrum AFHSS and changes frequency every 910 us Tested link range 450m Low power EU mode using standard antenna in an urban area Operational frequency range EU ASIA RF output power output power Channel ba
3. MX one universe wireless through the W DMX technology that is proven to be safe reliable and easy to use WRX 1 can be used for both Multicasting and Point to Point systems In a Multicast system each DMX 512 device has its own WRX 1 which negates the need for DMX 512 cable as the entire system is wireless In a Point to Point situation W DMX is used to bridge a distance There can of course be a combination of these two modes for example a WSX 1 connected to the console can transmit to 6 units of WRX 1 and each of the WRX 1 has a fixture connected that is daisychained to several other units by cable on either same or different DMX addresses The WRX 1 has a built in universal power supply with 90 250 V guaranteed worldwide use without problems WRX 1 units are delivered with multipurpose brackets for easy mounting and rigging as well as standard 2 dBl rubber whip antenna A multitude of other antenna options are available to increase the standard transmission range All W DMX products use the license free 2 45 GHz ISM band and are certified for use in the United otates Canada Japan and all European Union countries The WRX 1 uses FHSS Frequency Hopping Spread Spectrum along with a number of other techniques to avoid interference and create a very reliable wireless link 4 9 ignition 3 Front panel details Ki 7s correct Power input present ignition Power
4. ignition USER MANUAL WRX 1 Single DMX universe receiver ignition ES Table of contents Je Sa ely Ipot amp I60nS u uu uuu RR 1 1 FOR SAFE AND EFFICIENT OPERATION a oaa next ases 2 Ou u u uuu u um a uuu u PROMI tik S cance accesses GAE bali L m WCC E E ______ _ _ WAS I cen TEE 61 Tolink with a transmitter a a RAFAEL 6 2 To unlink from a transmitter a aaa nnns nnns Trusshoidders mouhntifig UU 219 ignition E 1 Safety instructions e This device is suitable for indoor use only modifications to the device will void the warranty e Repairs are to carry out by skilled personnel only Useonly fuses of the same type and original parts as spare parts e Protect the unit from rain and humidity to avoid fire and electric shocks e sure to unplug the power supply before opening the housing 1 1 FOR SAFE AND EFFICIENT OPERATION Be careful with heat and extreme temperature Avoid exposing it to direct rays of the sun or near a heating appliance Not put it in a temperature bellow 32 F 0 C or exceeding 131 55 Keep away from humidi
5. ndwidth Sensitivity at 0 1 Packet Error Rate Approvals 2402 2479MHz ISM band 20dBm or 100mW 25dBm 275mW 1 MHz 95dBm FCC 15 247 amp 68 Class B Canada ICES 003 Japan ARIB STD T66 CE EN 301 489 1 301 489 17 EN 300 328 1 EN 300 328 EN 609 50 679 ignition Diecast aluminium casing Operating temp range 0 C to 55 C 32 F to 131 F Dimensions W x H x D 219 x 45 x 131 mm 8 6 x 1 8 x 5 2 Weight 1005 g 35 45 oz Connectors N type female antenna connector N RP SMA adaptor included 2 Neutrik XLR 5 pin gold plated DMX connectors 2 RJ45 DMX over cable links 1 DC input pluggable terminal strip Phonix MSTB 2 5 1 AC input IEC 6C 749 WRX ignition 6 Installation 1 Attach the antenna to the connector on the front panel If using the standard antenna use also the supplied adaptor 2 Link the DMX source to the DMX out socket on the rear panel 3 Connect power to the unit either via the Powercon input 90 to 250 VAC or the DC power input 12 VDC If using the AC input fit an appropriate mains plug to the supplied power cord this should be carried out only by a qualified electrician 6 1 To link with a transmitter 1 Ensure that this receiver is not linked with any other transmitter W DMX indicators should be OFF 2 Onthe transmitter unit press and release the LINK button The transmitter will scan for all unlinked receivers for a period of ten seconds
6. ty water and dust Do not place the set in a location with high humidity or lots of dust Containers with water should not be placed on the set Keep away from sources of hum and noise ouch as transformer motor tuner TV set and amplifier To avoid placing on un stable location Select a level and stable location to avoid vibration Do not use chemicals or volatile liquids for cleaning Use a clean dry cloth to wipe off the dust or a wet soft cloth for stubborn dirt If out of work contact sales agency immediately Any troubles arose remove the power plug soon and contact with an engineer for repairing do not open the cabinet by yourself it might result a danger of electric shock Take care with the power cable Never pull the power cable to remove the plug from the receptacle be sure to hold the plug When not using the device for an extended period of time be sure to disconnect the plug from the receptacle 3 9 ignition Important Damages caused by the disregard of this user manual are not subject to warranty The dealer will not accept liability for any resulting defects or problems Make sure the electrical connection is carried out by qualified personnel All electrical and mechanical connections have to be carried out according to the European safety standards 2 Description The WRX 1 indoor receiver is a user friendly single receiver with One Button 2 Go technology The WRX 1 receives all 512 channels D
Download Pdf Manuals
Related Search