Xbox One Arbiter 4 installation instructions
Contents
1. Start by taking apart the controller check out our disassembly video at http www youtube com angelsixtube To make install much easier recommend removing the main rumble motor wires and potentially the trigger motor wires too J Pree 1720 e s A TPIS oo TP26 C71 C25 ose pA P pr Fr FP PEN EN RE VP lt wer P i JP s f TPIS y ban ba Se IP34 p Hdi gt Sine 8 02980788 HL gt p15 o R lt x 994340 e a Next solder the B button pad at the top right to the copper you exposed earlier by removing the carbon from the B button pad Check all of you connections are solid before proceeding The final step is to attach the wires for the RT R3 LED SIG L3 and LT pads Your board should come pre attached with wires on the pads but if not attach wires to each gold pad before turning the board over Make sure that the connections on the Arbiter 4 chip are solid and not dry joints It is easy to make dry joints that appear good but break very easy If you get dry joins the chip will not work Also make sure that you have no joins between each pin on the chip Start by scraping off the carbon on the B button as shown here Then place the Arbiter 4 board over the controller and line up the gold pads with the pads of the 2 black connector blocks as accurately as possibly You can hold down the board with tape or tack while you make your first few connections For the2. main black connectors solder the pins that are labelled They are the Sync on the left side and the PWR A Y BK X RB and GND pins It does not matter if you connect the other pins however they are not required Be careful not to join pins together Using solder flux really helps for this step y saa PAODIIFY CONTROLLERS www modiify com XBOX ONE V40 0 Arbiter 4 0 Elite 0 LED i 4 Bk 4 enrnrinn fr Pt W Sic PAOSIFY CONTROLLERS www modiify com XBOX ONE V4 0 0 gt Arbiter 4 0 Ette Note that for the RT and LT connections the bottom pin of the resistor left and capacitor right are joined so you are ok to connect the wire going over both pins like we do For close up connection points see below Once done build up and test The controller must be synchronised and connected to an Xbox One console before it will work Once connected the guide LED should be solid on Now tap the sync button and the LED should flicker rapidly several times If that works you are ready to test based on the User Manual If you get no response at all check the connections are good and not dry It is easy to get a dry joint for power or ground that look ok but break if you pull them slightly If you do not have good connections the chip will not work
Download Pdf Manuals
Related Search