PowerStar Extreme User Manual Uninterruptible Power Supply
Contents
1. Important Safety Warnings This manual contains instructions and warnings that should be followed during the installation operating and storage of the UPS system Please keep this manual for further reference PowerStar Extreme User Manual CAUTION To prevent the risk of fire or electric shock install in a temperature and humidity controlled indoor area free of conductive contaminants See the specifications for the acceptable temperature and humidity range CAUTION To reduce the risk of overheating the UPS do not cover the UPS cooling vents and avoid exposing the unit to direct sunlight or installing the unit near heat emitting appliances such as space heaters or furnaces CAUTION Do not attach non computer related items such as medical equipment life support equipment microwave ovens or vacuum cleaners to UPS CAUTION Do not plug the UPS input into its own output CAUTION Do not allow liquids or any foreign object to enter the UPS Do not place beverages or any other liquid containing vessels on or near the unit CAUTION In the event of an emergency press the OFF button and disconnect the power cord from the AC power supply to properly disable the UPS E E CAUTION Do not attach a power strip or surge suppressor to the UPS Uninterruptible Power Supply CAUTION If the UPS is with metal chassis for safety purpose grounding is a must during UPS installation in order to reduce leakage current below 3 5mA Attention hazardous th2. f battery environment or improper operation to battery The mains is normal but Power cord is loose Reconnect the power cord properly green LED is flashing
3. install the monitoring software Connect Modem Phone Network for Surge Protection Only for the models with RJ 45 Connect a single modem phone line into surge protected IN outlet on the back panel of the UPS unit Connect from OUT outlet to the computer with another phone line cable Power On Off UPS Press power switch on the front panel of the UPS to turn on UPS Press switch again to turn off the UPS Connection Chart seseeeeeee Surge Protected Socket g amp Battery Backup Sockets Surge Protected Socket Battery Backup Sockets Battery mode LED yellow lighting AC mode LED green lighting Fault LED red lighting UPS status LED AC Mode green lighting Battery Mode green flashing Troubleshooting Possible Cause Solutions No LED display on the Low Low battery Charge the UPS at least 6 hours the UPS at least 6 hours type of battery on the UPS The UPS is overload Remove some loads first Before reconnecting equipment please verify that the load matches the UPS capability specified in the specs The UPS is overload Remove some critical load Alarm continuously sounds when the mains is normal When power fails PACU UNE S ENAREN Battery voltage is too low Charge the UPS at least 6 hours Battery defect It might be due Replace the battery with the same to high temperature operation type o
4. nux Unix and MAC Installation amp Operation Initial Set up After unpacking the unit please avoid placing the unit in direct sun light excessive heat excessive humidity or in contact with fluids of any type Place the unit away from other equipment at least 20 cm to avoid interference Place the unit to avoid Direct sunlight Excessive heat Excessive humidity or contact with fluids Connect Utility Plug the UPS into an electrical outlet that does not share a circuit with a heavy electrical load Please allow the UPS to charge at least 6 hours prior to use Connect Equipment Connect critical equipment to Battery Backup Sockets These battery backup sockets provide battery back up and surge protection In case of power outage battery power is automatically provided to these outlets Connect minor less critical devices to Surge Protected Socket Power is not supplied to this socket when the utility fails NOTE Please DO NOT connect scanner or printer into Battery Backup Sockets Connect Com Port and Install Software Only available for the SMART models with USB RS 232 ports Connect the communication port cable end to the communication port located on the rear panel of the UPS Connect the other end of communication port cable to the port on the rear panel of the computer Download the software from http www power software download com viewpower html Follow on screen instruction to
5. rough electric shock Also with disconnection of this unit from the mains hazardous voltage still may be accessible through supply from battery The battery nn eo supply should be therefore disconnected in the plus and minus pole at the quick connectors of the battery when maintenance or service work inside the UPS is necessary CAUTION Servicing of batteries should be performed or supervised by personnel knowledgeable of batteries and the required safety precautions Keep unauthorized oe ee CAUTION When replacing the batteries use the same number and type of batteries CAUTION Internal battery voltage is 12VDC Sealed lead acid 6 cell battery CAUTION Do not dispose of batteries in a fire The battery may explode Do not open or mutilate the battery or batteries Released electrolyte is harmful to the skin and eyes CAUTION Unplug the UPS prior to cleaning and do not use liquid or spray detergent CAUTION A battery can present a risk of electric shock and high short circuit current The following precaution should be observed before replacing batteries 1 Remove watches rings or other metal objects 2 Use tools with insulated handles Net Weight kgs 425 3 Wear rubber gloves and boots 4 Do not lay tools or metal parts on top of batteries USB RS 232 Port option USBPort USBPort 5 Disconnect charging source prior to connecting or disconnecting batteries terminal Supports Windows 98 2000 2003 XP Vista 2008 7 Li
Download Pdf Manuals
Related Search