Home

NIGHTmate® Operator`s Manual to include:

image

Contents

1. copyright protected 3 Third Eye specifications are subject to change without notice Revision H Page 12 C 01 224
2. lt gt ThirdEye User s Manual for the Color Third Eye Spotting Scope Eyecam High Resolution Model Part Number C 01 224 Copyright 2015 Hooker Tactical Safety and Defense Equipment Inc Revision H C 01 224 Table of Contents 1 0 INTRODUCTION vsvccccciccnssescssedecsvsissssscsetdessvesoncsccssessvesecoeees odessesvesbenecs 3 CAUTIONS 3 3 2 0 SYSTEM SPECIFICATIONS ccsssssssssssscccsscecesecsscscsssssssssscsecsccees 4 3 0 HOWIE WORKS wisisiccscscec sischesecacssbsseveesaccacuntecvecccesedasssdesestasasvacvessouaee 5 4 0 WARRANT Y REPAIR ccssssssssssssscssccsscccccccccsesessecsssessssscsscscsecees 5 5 0 RECOMMENDED USKG ccccssssssssssscsssscsccccccccesssssscessssssscsessceeee 6 6 0 HOW TO PREPARE FOR 6 6 1 REMOVAL FROM 6 6 2 MOUNTING ON A SCOPE c ccccescesscsscessessessscesccsscescssssescsssessesssessseesssesees 6 6 3 CONNECTING THE CABLES norena a a aiii 7 6 4 CLEANING THE VIEW PORT cccccccecsesccsscesccsssesccssessecssesssecesesesssesssseesues 7 7 0 HOW TO OPERATE esssssssscssonssstecccsscosesesocsoosevssssssossenssonvonsescsseasceosseas 8 TURNING IIT ON 8 7 2 OBTAINING A CLEAR VIDEO IMAGE ccccccccsceesecesscsessceseessseceesssseceeens 8 8 0 TROUBLE SHOOTING TIPS ccsss
3. on to the eyepiece as it can be Revision H Page 8 01 224 8 0 Trouble shooting tips The following are trouble shooting suggestions 8 1 Video image unclear If the video image is out of focus i e fuzzy complete the following steps 1 Remove the eyecam from the eyepiece of the spotting scope 2 Wearing your corrective lenses if required adjust the eyepiece lens of the scope for its sharpest focus Adjustment is usually made by moving the focus ring on the eyepiece 3 Remount the eyecam to the eyepiece of the scope 4 If the image is still too fuzzy or grainy change the batteries in the battery source and repeat the steps above 5 Prior to calling Customer Service see Section 8 2 remove the eyecam from the scope Holding the eyecam by itself up to your eye look through the view port at an object at least 10 meters away If the video image is in focus then the eyecam is performing properly However if the video image is out of focus the eyecam is defective and the instructions in Section 8 2 should be followed NOTE If you just can t get the video image focused to your liking call us for technical assistance see Section 8 2 Revision H Page 9 01 224 8 2 Inoperative Unit For an inoperative unit Check to see that the cable from the eye cam is connected properly Check to see that the batteries are installed correctly in their housing Reinstall correctly or replace with fresh ones Inst
4. The High Resolution eye cam is designed for use on an optic with a 25mm eye relief The video image it captures will not be in sharp clear focus when attached to an optic with a different eye relief such as a rifle scope having a 75mm eye relief A different model eye cam must be used with a rifle scope Note 4 The video out format is not switchable It must be specified when placing order Third Eye specifications are subject to change without notice Revision H Page 4 01 224 3 0 How it Works The Third Eye Slip On Eye Cam system captures the image using a proprietary beam splitter image sharing module that in no way interferes with the image quality or field of view This unique system may be attached to the eyepiece of almost any optic to record and or transmit live video images The field of view of the camera covers the rectangular areas of the view as per the diagram to the left The standard view is the 1x view and can only be changed with a factory modification to your eye cam Ifa 1 5x or 2x view is desired it must be requested at the time of purchase or your unit returned for modification 4 0 Warranty Repair If the Third Eye eye cam fails to conform to system specifications see Section 2 0 within one year of the date of delivery and has not been misused or damaged the non conforming device shall be promptly repaired or replaced free of charge See Section 8 2 for additional information Please fill out wa
5. all a fresh set or fully charged set of batteries into power source If the unit is still inoperative return it for repair or replacement using the following procedures e Call Third Eye Customer Service 801 745 5457 and advise of problem Or send an email to support htactic com e Information requested will include date time and circumstances of failure e Follow instructions received from the Customer Service Representative Note Upon receipt the unit will be quickly analyzed and a repair estimate sent to you if the unit is not under warranty For units out of warranty repairs will be made and the working unit returned after customer approval is received Note Upon receipt the unit will be quickly analyzed and a repair estimate sent to you if the unit is not under warranty For units out of warranty repairs will be made and the working unit returned after customer approval is received 8 3 Cleaning after being immersed in mud or water To clean the unit if it has fallen into mud or dirty water rinse it off with clean water dry off immediately and then wipe it with a clean soft cloth Do not immerse the unit into water or any cleaning liquid Use a minimum amount of water during the cleaning process Use lens cleaning tissue dampened with clean water to clean both both sides of the viewing port If unit has fallen into clean water dry it off with a soft clean cloth Use lens cleaning tissue to wipe both sides of viewi
6. ng port Let unit dry thoroughly before using Revision H Page 10 C 01 224 8 4 Moisture on viewing port During a quick temperature change especially in a humid climate the viewing port may become fogged on its outside The unit is designed to minimize fogging on the inside of the viewing port To clear a fogged viewing port take a lens cleaning tissue or soft clean cloth and gently wipe it off Do not use defogging chemicals on any part of the viewing port Copyright 2015 Hooker Tactical Safety and Defense Equipment Inc All rights reserved 9 0 User Notes Revision H Page 11 C 01 224 WITH THE EXCEPTION OF THIS PAGE WHICH MAY BE COPIED AND MAILED TO HOOKER TACTICAL FOR PURPOSES OF REGISTRATION COPYING OF THIS MANUAL IN PART OR WHOLE WITHOUT WRITTEN CONSENT IS FORBIDDEN Warranty Registration Information Please fill in the information below Mail a copy to Hooker Tactical Safety and Defense Equipment Inc Attn Third Eye Customer Service 190 147 South Idaho Street Arco Idaho 83213 USA Or fax a copy to 208 403 0391 Purchaser Agency or name Address City State Zip Third Eye Model Standard __ Third Eye Serial Number Date Purchased Purchased From Name Address City State Zip NOTICES 1 The Third Eye Eyecam is a Made in the USA by Hooker Tactical Safety amp Defense Eq Arco Idaho 83213 USA b Patent pending 2 All Third Eye documentation is
7. rranty registration information on page 12 of this manual and fax or mail it to us Revision H Page 5 C 01 224 5 0 Recommended uses The recommended uses for the Third Eye eye cam include the following SWAT team training and evaluation Tactical Command Surveillance Battlefield intelligence gathering Target identification spotting Marine search and Customs enforcement amp evidence gathering Perimeter defense Border patrol Night vision recording Correctional facility observation escapee search 6 0 How to prepare for use 6 1 Removal from box When opening the shipping container make sure no sharp objects penetrate into the container Remove contents and check them against the packing list to ensure receipt of all items 6 2 Mounting on a scope To mount the Third Eye on a scope or optic slide the collar over the eye piece until its forward motion is stopped by the rear of the collar Position the Third Eye housing to the right as shown in the figure below Turn the clamping screw to lock in place If the collar does not fit properly on the scope either contact your supplier to get the correct collar or if it is loose wrap tape around the eyepiece to fill the space Revision H Page 6 01 224 6 3 Connecting the cables First connect the single cable from the eye cam to the independent battery pack power source Second connect the video cable between the BNC connector on the batte
8. ry pack and your monitor or DVR NOTE When the eye cam is not being used do not leave the eye cam cable to the battery pack connected to it or leave the eye cam laying in the direct sunlight This may damage the unit 6 4 Cleaning the view port The Third Eye view port may become dirty or develop a film that degrades performance When this happens use a lens cleaning tissue or soft cloth dampen it with clean water and carefully wipe the view port Wipe with a light circular motion Do not immerse the Third Eye in water to clean the view port Revision H Page 7 01 224 7 0 How to operate The following instructions will assist the user in operating this unit for maximum performance 7 1 Turning it on To turn the eyecam on connect the between the eye cam and battery pack power source Also make sure there are fresh fully charged batteries in the power source Caution Do not attempt to view the sun or any other very bright light source See Section 1 1 7 2 Obtaining a clear video image The eyecam has no user operated focus adjustments All adjustments have been made at the factory and locked into place To obtain a clear video image the user must first remove the eyecam and focus the scope to 0 diopters This is the setting for a user with perfect vision and for a user wearing corrective lenses Remount the eyecam as instructed in Section 6 2 to the eyepiece end of the scope making sure it is positioned as far
9. ssssscccccssecssesccscessssssssccccsessceeee 9 8 1 VIDEO IMAGE 9 8 2 INOPERATIVE UNIT vosenn naei ate i e ewes Bs 10 8 3 CLEANING AFTER BEING IMMERSED IN MUD OR 10 8 4 MOISTURE ON VIEWING PORT cccccessccscesccsscsscsssessecssessesssesssesseeeseeees 11 9 0 11 REGISTRATION INFORMATION ccsssssssssccccccccccecscesscesccceeeeescceces 12 Revision H Page 2 01 224 1 0 Introduction The Third Eye eye cam is a versatile easy to use specialized video camera system that uses the latest in high performance technology Third Eye eye cam Systems allow the user to share their eye view of any given situation via a live video link and record what they see Third Eye eye cam products are designed to be compatible with most existing professional optics from spotting scopes to riflescopes night vision to surveillance optics and are ideal tools for all branches of police and military The eye cam mounts on the eyepiece of almost any optic The design and construction is such that it does not interfere with the user s normal vision through the optic 1 1 Cautions Opening the Third Eye housing will void the warranty There are no user adjustments inside the housing Do not drop or misuse the Third Eye Operate the Third Eye as described in these operating instructions Do not expose
10. the view port of the Third Eye to direct sunlight or point the optic to which it is attached towards the sun The bright sun light can permanently damage the sensitive image capture portion of the unit Also to protect the image capturing system and the image sharing module keep the eyecam unit stored in its protective case when not in use When not in use disconnect the Third Eye from the battery supply Store batteries in a safe place Battery leakage may cause severe equipment damage For rechargeable batteries only use the charger recommended for the battery Do not charge batteries inside the storage case Batteries charged incorrectly with the wrong charger may explode and cause injury or death Revision H Page 3 C 01 224 2 0 System Specifications Voltage Source Requirement Any DC source between 12 amp 18 volts 150 mA Operating temperature range 10 C to 40 C Storage temperature range 30 C to 70 C Eye cam Specifications par Resolution TV lines 800 Sensitivity lux 0 08 Input Current mA 130 Chip Type CCD Chip Size 1 3 Either Video output format NTSC or PAL Video output 75 ohms 1V p p unbalanced Approximate Weight grams 30 Note 1 The collar of your choice will be supplied with the model ordered A list of available collars and the equipment to which each attaches may be requested Note 2 Systems can be built to customer specifications Quotes for customized systems are no charge Note 3

Download Pdf Manuals

image

Related Search

Related Contents

Manuel d`utilisation  PAVINOX Mortero epoxi al agua  PeopleAdmin - Wright State University  Gebrauchsanleitung - Topvitalinfo.ch Topvitalinfo.ch  PROTEC MAIN  UNICORN 5.1 - GE Healthcare Life Sciences    FR Manuel d`instructions et d`utilisation EN User and - D-Mail  Ewent EW3951 surge protector  Español MANUAl DE OPERACióN  

Copyright © All rights reserved.
DMCA: DMCA_mwitty#outlook.com.