Photocell P5200 user manual
Contents
1. Photocell P5200 user manual Technical Specification Working voltage 12 24VAC DC Working current 24VDC emitter lt 8mA receiver lt 30mA Photocell wavelength 940nm Angle of emission lt 52 Receiving range 212m Angel adjustment of PCBA 0 180 2 Working temperature 202 60 C Relay contact loading capacity 1A 30VDC Size 100 40 35mm l di 3 4 D 6 8 9 Safety Instruction For security please read the user manual carefully before initial operation This photocell is without any fuse so Please make sure the power is off before installation Only used this system that do not cause any danger life or property during the running failure or its security risks eliminated Please guarantee the products used in effective working range lII Picture Display Emitter Receiver BAe LOO AC DC NC NO __ 12 247 Wiring diagram Size IV Installation instruction J2 4 1 Receive module J2 in pic 3 is the option switch of photocell switch 4 1 1 When the short circuit cap on NO The photocell will be Normal Open NO 4 1 2 When the short circuit cap on NC the photocell will be normal closed U 4 2 Installation Pic 3 4 2 The photocells should be installed more than 20cm above the ground to avoid reflection and the distance vetween emitter and receiver shall be more than 50cm 4 2 2 End user should install the photocell on the back of the direct sunlight or other strong light source 52 to k2. eep photocell work well steadily 4 2 3 Avoid installing other infrared photocell emitters within the effective distance of receiver 4 2 4 If the end user need to install other photocells in one same straight line the receivers could be installed in the two ends and the emitters could be back to back installed 4 2 5 Stable installation could avoid the signal of emitter and receiver skewing due to lightly vibrate and the malfunction 4 2 6 Connect the power after the inspection when short circuit cap at NO emitter module LED turns on receiver module LED turns on receiver module contact at off when make the cap of emitter and receiver in alignment receiver module LED is off NC NO is on when something or someone shelter the sensor receiver module LED will turn on NC NO contact is off When short circuit cap at NC the state of NO NO is opposite to the above phenomenon V Installation Pictures 1 Open the package and 2 Stick the holder 3 Drill holes 4 Connect take out the accessories location map where and fix expansion you need pipe 5 Fix the screws NO oe ACUSE Mier ADptopnale 6 Install the angle of PCBA fix screws 8 Finished 1 2 3 with the base ee upper cover and fix the screw
Download Pdf Manuals
Related Search