EN - User`s manual ()
Contents
1. mA Dimensions 50x33 mm Short description Timer and delay module applicable for various timing tasks T2 OUT1 is active for T1 time from the last pulse arriving at the input OUT2 is active for T2 time after the T1 time is over Due to the chatter suppression on the input the T1 timing starts only after the last pulse arriving at the input Wiring The supply voltage is to be connected to the POWER connector The contact providing for the starting pulse is to be connected to the START points Use only potential free galvanically isolated closing contact Do not use e g rail contact to control this input Guarantee and legal statement Each parameter of the device was submitted to comprehensive testing prior to marketing The manufacturer undertakes one year guarantee for the product Defects occurred during this period will be repaired by the manufacturer free of charge against the presentation of the invoice The validity of the guarantee will cease in case of improper usage and or treatment Attention By virtue of the European EMC directive the product can be used solely with devices provided with CE marking The mentioned standards and branch names are the trademarks of the firms concerned TrainModules BioDigit Ltd Kerepesi street 92 H 1144 Budapest Made in Hungary Tel 36 1 46 707 64 http www trainmodules hu Figure 1 OUT START GND2. TM 86481 SS TRAINMoDuLES Universal timer and delay module User s manual MI lt 9897513009 2011 BioDigit Ltd All rights reserved It is forbidden to reproduce and or publish the contents of the present document in any form including electronic and mechanical design without the written permission of BioDigit Ltd uN Safety warning During the operation of the device the specified technical parameters shall always be met At the installation the environment shall be fully taken into consideration The device must not be exposed to moisture and direct sunshine A soldering tool may be necessary for the installation and or mounting of the devices which requires special care During the installation it shall be ensured that the bottom of the device should not contact with a conductive e g metal surface Contents Safety Warning scans eG nesses py cee eva ner dae einher 1 Properties rer A aaa 2 Technical parameters 2sssssssesseensennsenennnnennnennnen nen een nennen 2 S hort deschiption sn ne er ea er 2 WIFING 2 er Ads 3 Guarantee and legal statement cece eee e eee namen nen nenn 4 Properties e Continuously adjustable timing e Two channel high current output e Applicable for delaying and pulse lengthening as well e Low idle mode current consumption e High load current Technical parameters Supply voltage 7 24V Idle mode current consumption 20 mA Max current consumption 500
Download Pdf Manuals
Related Search