USER MANUAL - Primo Water Store
Contents
1. Model 900129 Page 7 Dispensing Cold Water Note After setup it will take 1 hour to get water to maximum cold temperature During this time the compressor will run continuously This is normal 1 Position bottle glass pitcher or cooking pot securely below cold water tap The circular shapes in the drip plate help align the flow of water This unit dispenses water at a fast rate To avoid splashes hold cup as close to the tap as possible 2 Depress cold water control downward to start flow 3 Release cold water control once desired fill level is achieved Dispensing Hot Water A CAUTION This unit dispenses water at temperatures that can cause severe burns Avoid direct contact with hot water Keep children and pets away from unit while dispensing Never allow children to dispense hot water without proper and direct supervision Note After setup hot water will be available in 15 20 minutes 1 Position bottle glass pitcher or cooking pot securely below hot water tap a The gray triangle below the hot water control indicates the location of the hot water tap b The circular shapes in the drip plate help align the flow of water This unit dispenses water at a fast rate To avoid splashes hold cup as close to the tap as possible 2 Push red child safety button inward and depress hot water control downward to start flow 3 Release hot water control once desired fill level is achieved Empty Water Bott2. USER MANUAL O taste perfection O PRIMO Bottom Loading Bottled Water Dispenser Model 900129 TO REDUCE THE RISK OF INJURY AND PROPERTY DAMAGE USER MUST READ THIS MANUAL BEFORE ASSEMBLING INSTALLING OPERATING DISPENSER SAVE FOR FUTURE USE PN O 009A O 2008 Primo Water Corporation Model 900129 Page 2 SAFETY PRECAUTIONS To reduce risk of injury and property damage user must read this entire manual before assembling installing amp operating dispenser Failure to execute the instructions in this manual can cause personal injury or property damage This product dispenses water at very high temperatures Failure to use properly can cause personal injury When operating this dispenser always exercise basic safety precautions including the following Prior to use this dispenser must be properly assembled and installed in accordance with this manual This dispenser is intended for water dispensing only Do NOT use other liquids Do NOT use for other purposes Never use any other liquid in the dispenser other than known and microbiologically safe bottled water For indoor use only Keep water dispenser in a dry place away from direct sunlight Do NOT use outdoors Install and use only on a hard flat and level surface Do NOT place dispenser into an enclosed space or cabinet Do NOT operate dispenser in the presence of explosive fumes Position back of dispenser no closer than 4 inches from
3. Wipe dust from back of dispenser to improve efficiency Remove drip tray assembly by sliding it forward Remove cover Place tray and cover in dishwasher or wipe parts clean with a soft cloth and warm soapy water Cleaning Water Tanks and Lines Perform Every 3 months or whenever an off taste occurs Time Required 30 minutes Note Best to do prior to loading a fresh bottle 1 2 3 Turn energy saving switch to OFF Unplug power cord from wall outlet Remove water bottle and place probe on hanger IMPORTANT Do NOT Return Dispenser To Store If you have a question or problem please contact 866 429 7566 for assistance 10 11 12 13 14 15 16 1 18 19 20 Model 900129 Page 9 Wipe probe and area around both taps with a soft cloth moistened with mixture of one gallon tap water and 1 tablespoon of unscented household bleach Move dispenser away from wall and turn it 90 in either direction Place a 2 gallon or larger bucket under the drain plug in the rear of the dispenser Remove drain cap and silicon plug Cold water will immediately flow into the bucket Several seconds later hot water will dispense Reminder Place drain cap and silicon plug in a safe location so they are not lost Once unit has drained replace silicon plug and drain cap Remove remaining water from cold reservoir by dispensing from the cold tap into a pitcher Remove the cap from a spare empty 5 gallon bottl
4. at www primowater com For future support please record your serial number located on label on back of dispenser and date purchased Staple your receipt to manual You will need this information to obtain warranty service E l gt Product Bottom Loading Bottled Water Dispenser Model Number 900129 Serial ID Number Date of Purchase IMPORTANT Do NOT Return Dispenser To Store If you have a question or problem please contact 866 429 7566 for assistance Model 900129 Page 4 SPECIFICATIONS Power Supply 5 AMPs Re Refrigerant Type R 134A Cold Water Power 125 Watts C US Cold Capacity Hour 1 0 Gallons Cold Temp Range 39 F 59 F AS Hot Water Power 425 Watts A Hot Capacity Hour 1 0 Gallons retti Hot Temp Range 149 F 199 F Dimensions 43 2 inches H x 12 6 inches W x 15 0 inches D Net Weight 46 3 Ibs PARTS amp FEATURES Front Back Hot Water Control 4 Child Safety Latch Cold Water Control 3 Hot Water Tap 4 LED Nightlights Cold Water Tap 6 Drip Tray 7 Door Bottle Tray Inside Energy Saving Switch Drain Plug 11 Carry Handle 12 Bottle Probe Inside Cabinet 13 Power Cord 14 IMPORTANT Do NOT Return Dispenser To Store If you have a question or problem please contact 866 429 7566 for assistance Model 900129 Page 5 ASSEMBLY Keep plastic bags away from children AANA 1 Remove dispenser from packaging 2 Unpack dr
5. sure to push the water controls in fully Cold water is not cold It takes up to one hour after setup to secure cold water Make sure the back of the dispenser is at least 4 inches from a wall and there is free airflow on all 4 sides of the dispenser Hot water is not hot It takes 15 20 minutes after setup to secure hot water Make sure the power cord is properly connected to a working outlet Make sure energy saving switch is ON Dispenser is noisy Make sure dispenser is positioned on a level surface Water tastes bad Drain water from reservoirs and replace bottle with a fresh one Sanitize dispenser per Proper Care amp Cleaning instructions Nightlight Isn t Working Make sure the power cord is properly connected to a working outlet Bulb could be out Call 866 429 7566 for assistance Water Isn t Pumping Make sure the power cord is properly connected to a working outlet Make sure the probe connection with the water bottle forms a complete seal Make sure the door is closed IMPORTANT Do NOT Return Dispenser To Store If you have a question or problem please contact 866 429 7566 for assistance Model 900129 Page 11 LIMITED WARRANTY Primo Water Corporation Vendor warrants to the original purchaser of this dispenser and to no other person that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it then for a period of two 2 years from the date of p
6. e Fill the bottle with 1 gallon of tap water and 1 tablespoon of household bleach Place the spare bottle cap that comes with this unit onto the bottle so there is a complete seal Place bottle onto tray and insert probe so it has a complete seal on the bottle cap Slide tray in and close door Plug power cord into a grounded wall outlet Turn energy saving switch ON Allow the water and bleach mixture to fill the empty reservoirs Wait 10 minutes then turn energy saving switch OFF and unplug the power cord Drain the water from the reservoirs as described in steps 6 8 Repeat the flushing process again This time with clean tap water only The dispenser will be clean after you have drained the tap water and replaced the silicon plug and drain cap Return the unit to its location install a fresh water bottle plug the power cord back into the grounded wall outlet and turn the energy saving switch back ON IMPORTANT Do NOT Return Dispenser To Store If you have a question or problem please contact 866 429 7566 for assistance Model 900129 Page 10 TROUBLESHOOTING Dispenser does not operate Make sure the power cord is properly connected to a working outlet Water is leaking Bottle may have a leak Remove bottle and replace with new bottle If leak remains remove probe from bottle and call 866 429 7566 for assistance No water is coming from the taps Make sure the bottle is not empty If so replace it Make
7. ip tray and insert into dispenser 3 Properly dispose all of packaging INSTALLATION Place dispenser upright 2 Locate dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet Notice Do NOT plug in power cord yet 3 Position dispenser so the back is at least 4 inches from wall and there are at least 4 inches of clearance on both sides 4 Level dispenser by adjusting feet Turn clockwise to raise height and counterclockwise to lower OPERATION A CAUTION This unit is intended for water dispensing only Do NOT use other liquids Do NOT use for other purposes This dispenser has been designed to use water bottles with 3 amp 5 gallon capacity Do NOT use alternative bottles IMPORTANT Do NOT Return Dispenser To Store If you have a question or problem please contact 866 429 7566 for assistance Model 900129 Page 6 Initial Set Up Notice To prevent damage to compressor allow unit to sit upright for at least 4 hours prior to operating 1 Open door 2 f using a 5 gallon bottle use the bottle probe as it is supplied If you desire to use a lighter weight 3 gallon bottle remove the bottom half of the probe by pulling it apart 3 Slide bottle tray out and place fresh bottle on tray 4 Clean bottle cap and neck with a soft cloth and warm soapy water 5 Remove tamper seal from bottle cap Do NOT remove plastic cap Note If your water bottle does not have a
8. le Signal This dispenser includes an audible and visual feature to inform you when your water bottle is empty or the connection between the probe and bottle is not completely sealed If either of these conditions occurs you will hear a series of short beeps and the LED nightlights will blink This is normal The beeping will stop in less than a minute The lights will stop blinking after you replace the empty bottle complete the bottle connection and close the door IMPORTANT Do NOT Return Dispenser To Store If you have a question or problem please contact 866 429 7566 for assistance Model 900129 Page 8 Replacing an Empty Bottle PAI A IS Open door and slide bottle tray out Remove probe from bottle by pulling straight up Hang probe on inside of door so it remains clean Remove empty bottle from tray and replace it with a fresh one Remove tamper seal from cap of fresh bottle Clean bottle cap and neck with a soft cloth and warm soapy water Insert probe into bottle by applying slight pressure downwards until the plug inside the cap is released and the probe housing snaps onto the bottle cap Once you are sure you have a complete seal slide the tray into the cabinet and close door completely PROPER CARE amp CLEANING General Cleaning Perform As needed Time Required 5 minutes Note Do NOT use abrasive materials or chemical cleaners Clean cabinet surfaces with a soft cloth and warm soapy water
9. sealed cap with a plug use the cap supplied with this unit Simply snap it onto your bottle Make sure the cap is completely installed and there is a tight seal 6 Insert probe into bottle by applying slight pressure downwards until the plug inside the cap is released and the probe housing snaps onto the bottle cap T Slide tray into cabinet and close door completely Note Unit will NOT operate properly with the door open 8 Plug cord into a properly grounded wall outlet The unit will come ON and start pumping air into the bottle which will force the water from the bottle into the hot and cold water reservoirs Note If water does NOT start pumping open the door and make sure probe has a tight seal on the bottle t will take up to 3 minutes for the reservoirs to load During this time the pump will run on and off This is normal Each time you dispense water from the taps the pump will come on 9 Turn energy saving switch on back of dispenser to ON This switch controls the heating of water If you do not want hot water turn this switch OFF Initial Rinsing of Water Lines This unit has been tested and sanitized prior to packing and shipping During transit dust and odors can accumulate in the tank and lines Dispense and dispose at least one quart of water prior to drinking any water IMPORTANT Do NOT Return Dispenser To Store If you have a question or problem please contact 866 429 7566 for assistance
10. ties Vendor disclaims all warranties for products that are purchased from seller other than authorized retailers or distributors AFTER THE PERIOD OF THE TWO 2 YEAR EXPRESS WARRANTY VENDOR DISCLAIMS ANY AND ALL IMPLIED WARRANTIES INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE FURTHER VENDOR SHALL HAVE NO LIABILITY WHATSOEVER TO PURCHASER OR ANY THIRD PARTY FOR ANY SPECIAL INDIRECT PUNITIVE INCIDENTAL OR CONSEQUENTAL DAMAGES Vendor assumes no responsibility for any defects caused by third parties This Limited Warranty gives the purchaser specific legal rights a purchaser may have other rights depending upon where he or she lives Some jurisdictions do not allow exclusion or limitation of special incidental or consequential damages or limitations on how long a warranty lasts so the above exclusion and limitations may not apply to you Primo Water Corporation 104 Cambridge Plaza Drive Winston Salem NC 27104 866 429 7566 www primowater com IMPORTANT Do NOT Return Dispenser To Store If you have a question or problem please contact 866 429 7566 for assistance
11. urchase all parts in such dispenser shall be free from defects in material and workmanship Vendor may require reasonable proof of your date of purchase from an authorized retailer or distributor Therefore you should retain your sales slip or invoice The Limited Warranty shall be limited to repair or replacement of parts which prove defective under normal use and service and which Vendor shall determine in its reasonable discretion upon examination to be defective Before returning any parts you should contact Vendor s Customer Service Department using the contact information listed below If Vendor confirms after examination a defect covered by this Limited Warranty in any returned part and if Vendor approves claim Vendor will replace such defective part without charge If you return defective parts transportation charges must be prepaid by you Vendor will return replacement parts to original purchaser freight or postage prepaid The Limited Warranty does not cover any failures or operating difficulties due to accident abuse misuse alteration misapplication improper installation or improper maintenance or service by you or any third party or failure to perform normal and routine maintenance on the dispenser as set out in the User s Manual In addition the Limited Warranty does not cover damages to the finish such as scratches dents discoloration or rust after purchase The Limited Warranty is in lieu of all other express warran
12. wall and permit free airflow between wall and dispenser There must be at least 4 inches clearance on the sides of the dispenser to permit airflow Use only properly grounded outlets Do not use an extension cord with your water dispenser Always grasp plug and pull straight out from outlet Never unplug by pulling on power cord Do NOT use dispenser if cord becomes frayed or otherwise damaged To protect against electric shock do NOT immerse cord plug or any other part of cooler in water or other liquids Ensure dispenser is unplugged prior to cleaning Never allow children to dispense hot water without proper and direct supervision Unplug unit to prevent unsupervised use by children Service should be performed only by a certified technician Please contact us at 866 429 7566 for assistance IMPORTANT Do NOT Return Dispenser To Store If you have a question or problem please contact 866 429 7566 for assistance Model 900129 Page 3 TABLE OF CONTENTS Sale PIGCAUIONS ssl isteja 2 Key Information for Future Use oococccccccccoccncoccncooo Specifications seria Parts amp Features rica ocas d PAS SOIMDIY siii 5 Ga oe ODO ai a Proper Care 8 Cleaning ococococcconcconcconcconnconncannnanos Troubleshooting esromivariciana ici enbreraacrradica cir nanidanpida 10 Limited Warranty arcomaratorbisina comic rtareierdiacicicosdara rias 11 KEY INFORMATION FOR FUTURE USE Please register your dispenser immediately
Download Pdf Manuals
Related Search