2000 Watt - Arlec Australia
Contents
1. mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety The heater must not be located immediately below a power outlet Do not use this heater in the immediate surroundings of a bath shower or swimming pool ASSEMBLY The heater must always be used with feet assembled and in upright position Attach the feet to the heater body as given in figure 1 1 Make sure the heater is switched off and is unplugged from the mains socket 2 Place the heater on a flat surface or upside down Control knobs near to the ground 3 Unscrew the feet fixing screws attached to the base of the heater 4 Locate the feet in position make sure the mounting holes on the feet and the heater body align 5 Fasten the feet fixing screw to secure the feet in position The heater is now ready for use Screw Figure 1 Control Panel Power Control Knob 1 With the power control switch in position 0 the heater is OFF 2 When the switch is at position 1 the heater will run at low heat setting 750W the led corresponding to low heat setting will glow 3 When the switch is at position 2 the heater will run at medium heat setting 7250W the led corresponding to medium heat setting will glow 4 When the switch is at position 3 the heater will run at high heat setting 2000W the led2. use in areas where petrol paint or flammable liquids are used or stored 13 Use the heater only as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury 14 Do not connect via double adapters or power boards Avoid the use of an extension cord because the extension cord may overheat and cause risk of fire However if this heater is used with an extension cord use as short a cord as practical 15 Do not use this appliance with a programmer timer or any other device that switches the heater on automatically since a fire risk exists if the appliance is covered or positioned incorrectly 16 In order to avoid overheating do not cover the heater 17 There are no user serviceable parts installed in the unit 18 Young children should be supervised to ensure that they do not play with the appliance 19 Keep these instructions handy for future reference Caution This heater is to be operated only in upright position The heater incorporates a tip over switch If the unit it tilted or knocked over the power will be cut off automatically When the heater is put to back to the right upside position it will start working as normal again When the heater is not in use store in a cool dry location Do not store until the heater cools down Warning This appliance is not intended for use by persons including children with reduced physical sensory or
3. CPIN002608 2 TECHNICAL SPECIFICATIONS pa jay E G Motel MT L a 2000 Watt MICATHERMIC HEATER MTHS POLL DEAE O AAAA AAAA SAA SSS SSY LERLERLL ELLIE PIPPI OPEL ISIE ONES INI OCS AAR AE RENE ENS SASKI PLELEE ALE EEOC TITAS Warranty Arlec guarantees this product in accordance with the Australian Consumer Law Arlec also warrants to the original first purchaser of this product you from a retailer that this product will be free of defects in materials and workmanship for a period of 12 months from the date of purchase provided the product is not used other than for the purpose or ina manner not within the scope of the recommendations and limitations specified by Arlec is new and not damaged at the time of purchase has not been subjected to abuse misuse neglect or damage has not been modified or repaired without the approval of Arlec and has not been used for commercial purposes Warranty If you wish to claim on the Warranty you must at your own expense return the product and provide proof of original purchase and your name address and telephone number to Arlec at the address below or the retailer from whom you originally purchased the product within 12 months from the date of purchase Arlec will or authorise the retailer to assess any claim you may make on the Warranty in the above manner and if in Arlec s reasonable opinion the Warranty applies Arlec will at its own option and expense or author
4. ater is hot when in use To avoid burns do not let bare skin touch hot surfaces Use handles when moving this heater Keep combustible material such as drapery and other furnishings at least 1 metre from the heater When in use keep the mains cord of the heater from touching the heater body Do not drape the cord over the heater while hot Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating unattended 3 Always unplug heater when notin use 4 Do not operate any heater with a damaged cord or plug or after the heater malfunctions has been dropped or damaged in any manner Return heater to suitably qualified facility for examination electrical or mechanical adjustment or repair 5 Donotuse outdoors the product is designed only for household use 6 Never locate heater where It may fall into a bathtub or other water container 7 Donotrun cord under carpeting Do not cover cord with throw rugs runners or the like Keep cord away from traffic areas to avoid tripping over 8 To disconnect heater turn controls to off then remove plug from outlet 9 Connectto properly earthed socket outlet of the appropriate voltage 10 Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater 11 To prevent a possible fire do not block the grilles in any manner 12 Do not
5. corresponding to high heat setting will glow Thermostat Control The rotary knob is to regulate the heat in order to maintain a desired temperature When the room temperature setting is lower than the temperature setting on the knob the heater will function and heat up the room until the desired temperature is attained When the ambient temperature reaches the set temperature the heater will be turned off automatically Turn the knob further clockwise for higher heat setting CPIN002608 2 OPERATION Caution There may be some odour coming from the heater for the very first time you use it This is normal during the break in period or after long term storage Make sure the heater is in well ventilated area and continue running it until the smell goes away 1 Set the power control switch to off position 2 Plug the heater into a 10Amp wall socket 3 Ensure heater is on a flat stable surface If on a carpet ensure that the carpet pile does not obstruct the air vents on the underside of the body or cause the tip over switch to operate inadvertently 4 Set power knob to desired position for Low Medium or High heat setting Turn the thermostat control knob clockwise until the heater is ON The power on light for respective heat setting on the front of the heater body will illuminate Slowly turn the thermostat control knob anticlockwise until the heater shuts OFF The heater will automatically maintain this temperature F
6. ise the retailer to replace the product with the same or similar product or repair the product and return it to you or refund the price you paid for the product Arlec will bear its own expenses of doing those things and you must bear any other expenses of claiming on the Warranty The Warranty is in addition to other rights and remedies you may have under a law in relation to the product to which the Warranty relates Our goods come with guarantees that cannot be excluded under the Australian Consumer Law You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure ARLEC User Manual Arlec Australia Pty Ltd ACN 009 322 105 Arlec gives the Warranty FOR PERSONAL INDOOR USE ONLY Arlec s telephone number address and email address are Keep this manual in a safe place for future reference Customer Service 03 9982 5111 Building 3 31 41 Joseph Street Blackburn North Victoria 3130 WARNING To reduce the risk of fire electric shock or personal injury Blackburn North LPO P O Box 1065 Blackburn North 3130 Emo eus enice E eccomi PE read understand and follow instructions before using this heater IMPORTANT SAFEGUARDS 1 Read all instructions before using this heater 2 This he
7. or a lower temperature turn the knob further anti clockwise For a higher temperature turn the knob clockwise Caution This heater is to be operated only in upright position The heater incorporates a tip over switch If the unit is tilted or knocked over the power will be cut off automatically When the heater is put back to the right upside position it will start working as normal again Power Control 1250W 2000W 750W Thermostat Control
Download Pdf Manuals
Related Search