Click - Wiedamark
Contents
1. 36W FiberLamp Quick Start Manual A Contents e FiberLamp e LightMix Software e USB to mini USB cable e 12V DC Power Supply optional e IEC 60320 C13 to NEMA 5 15 AC Power Cable optional B Connectors Connectors Function Nee DC input cable with 2 1mm x 5 5mm DC connector or fly leads O Pushbutton Mini USB port for LightMix interface fF _4 RJ45 connector for DMX control C Electrical Power Set up Connect 12V DC power supply to DC input cable on FiberLamp e DC connector Use mating female 2 1mm x 5 5mm DC barrel connector e Fly leads Connect polarity to white lead Connect polarity to black lead D Using Pushbutton 1 Press Pushbutton several times until light turns on 2 Light changing sequence is as specified in the following table Generic Mode Description RGBW Single Color 0 Off Blank Blank 1 Static Color Red 100 Intensity 2 Static Color Green 90 Intensity 3 Static Color Blue 80 Intensity 4 Static Color Cyan 70 Intensity 5 Static Color Yellow 60 Intensity 6 Static Color Magenta 50 Intensity 7 Static Color 6500K White 40 Intensity 8 Timed Color Rainbow Default Blank Sequence 9 ies Default Blank Default Blank 10 ty Default Blank Default Blank Timed Color 11 Sequence Default Blank Default Blank E Connecting to LightMix 1 Run LightMix installer from CD or FiberLamp com on a2. computer running Windows XP Windows Vista or Windows 7 LightMix is not compatible with Macintosh operating systems 2 Use USB to mini USB cable to connect FiberLamp to computer 3 Open LightMix F Connecting to DMX 1 Connect the DMX line to FiberLamp using Cat 5e cable with an RJ45 connector 2 The Cat 5e wiring configuration for the RJ45 connection to DMX is as specified in the following table RJ45 Pin Cat 5e Wire DMX Line 1 White Green Data 2 Green Data 3 White Orange Not Assigned 4 Blue Internal use only 5 White Blue Internal use only 6 Orange Not Assigned 7 White Brown DMX Ground 8 Brown DMX Ground G DMX Channel Definitions The DMX channels below represent the sequence in which the controls appear on the DMX controller Use LightMix to set the DMX address of the first control in the table below The controls that follow in each sequence will automatically be set to corresponding DMX addresses that follow the setting of the first control example for an RGB unit by setting red to DMX address 6 green will automatically be set to DMX address 7 blue to 8 etc Control Sequence RGB Single Color 1 Red Master Intensity 2 Green Strobe 3 Blue NA 4 Max 6500K White NA 5 Strobe NA Note Strobe values 0 1 No Blinking 2 255 blink rate increases from slow 2 to fast 255 H Troubleshooting Problem Remedy Make sure that the FiberLamp is conn
3. ected to a constant 12V DC source that can provide at least 3A LightMix does If LightMix was previously installed uninstall all not work versions of LightMix and reinstall the latest version Click on the refresh button in the right corner of the LightMix window Use LightMix to reset the desired DMX channels DMX does not work Use LightMix to reset the FiberLamp to DMX Slave mode Make sure that the DMX wiring configuration matches the DMX wiring configuration of the DMX controller Note Not all DMX controllers and devices use the same wiring configuration Make sure the wiring configuration of the FiberLamp and the DMX controller match F be r La Mm o 1689 Regatta Blvd Richmond CA 94804 http www fiberlamp com sales diconlighting com 510 620 5000 5870028A1
Download Pdf Manuals
Related Search