RAVE Water Sports Equipment User Manual
Contents
1. attach It may be easier to attach to bouncer before inflating Remove grey cap from PVC tube run cap attachment cord below the loops Thread the tube through the loops Place grey cap back onto open end of tube to secure it in place Attaching the Log Wrap the black straps from attachment around the main tube of the bouncer If one strap is longer than the other always wrap that one over the top of the trampoline and the shorter one under They will meet on the inside of the trampoline and under the jump mat Thread the straps through the buckle as shown below Pull tight Log Attachment Anchoring Due to extreme varieties of conditions anchor line and anchors are not included with the product and must be purchased separately Attach the anchor line not included securely to the Anchor Plate of the product Please Note There are many ways to anchor your products Before moving forward it is best to consult your local regulations regarding what types of anchors can be used in your area Every location has different conditions and demands so you will have to determine what will work best for your situation Here are a few anchoring tips to get you Started e Choose a location that is most protected from the wind of Sufficient water depth 8 feet minimum and free of obstructions a safe distance in all directions e A minimum of 150 200 Ibs of anchor weight is recommended for most applications however larger bod2. children under the age of six DO NOT OVER INFLATE Over inflation can cause seam rupture Keep objects that could interfere with jumping away from the jump Surface Stop your bounce by flexing your knees as your feet come in contact with the jump surface Learn this skill before you attempt others Learn fundamental bounces and body positions thoroughly before trying other jumps Avoid bouncing too high Stay low until you can control your bounce and repeatedly land in the center of the jumping surface Focus your eyes on the jump surface to help control your bounce Do not use the jump surface as a springboard on to other objects Liability While every attempt is made to embody the highest degree of protection in all equipment we cannot guarantee freedom from injury The user assumes all risk of injury due to use All merchandise is sold on this condition which no representative of the company can waiver or change Inflation RAVE recommends inflating your Splash Zone Plus with the High Speed Inflator Deflator Item 01083 for maximum performance High Speed Inflator Deflator is not included Package Contents 1 12 Water Bouncer 1 Slide 1 Log 1 EZ Up Platform 1 Repair Kit consisting of 2 oz of Glue 5 3 round patches in White and Blue 1 Owner s manual Recommended Maximum Weight When Jumping 250 Ibs When Lounging 700 Ibs Recommended Number of People 2 Adults or 3 Children Recommended Wat
3. Splash Zone Plus Owner S Manual hha TIN CENH IRAT EI al NY Tn Im MNH s T ie s Introduction Thank you for purchasing the Splash Zone Plus Water sports can be safe and fun for all levels of enthusiasts This Owner s Manual is presented to enhance your enjoyment of the Sport It is intended to alert you to some of the potentially dangerous conditions that can arise in all water sports Please take a few minutes to read this manual before assembling and using the product Although the product is simple to use this manual contains important safety information that you and all users must understand to safely enjoy the Splash Zone Plus If you have any questions regarding this product please call RAVE Sports at 1 800 659 0790 Please have your serial number available A WARNING Read these materials prior to assembling and using your RAVE Product Failure to follow these instructions could result in serious injury or death RAVE inflatables are not life saving devices Never leave children near water unattended and be sure they are supervised by a mature and knowledgeable adult RAVE highly recommends the use of U S Coast Guard approved personal flotation devices life jackets by those near or in the water AWARNING UNSAFE USE OF THE SPLASH ZONE PLUS CAN RESULT IN PERSONAL INJURY OR DEATH To reduce the risk of injury read and follow all instructions and warnings in this ma
4. Unit Wipe the product off with a terry cloth towel and allow to dry completely Store for next use See Storage Section for details Maintenance Maintenance is essential to increase the life of your product Please follow all maintenance and repairs according to this manual If you are unsure please contact your local dealer service center or RAVE Sports directly e Inspect product regularly for potentially unsafe conditions particularly after storms and suspected misuse of product e Do not use product if repair is needed e Clean product regularly per the Cleaning section of manual e Check storage area Make sure it is rodent free and dry e Black rubber portion of Valves and Plugs should be lightly coated with a petroleum based product before Storage to prevent drying and cracking e When disposing of product do so in such a manner that no hazardous conditions exist at the time the product is discarded e To extend the life of your product keep out of sunlight when not in use For additional protection we recommend using UV protectant Cleaning If your inflatable is used intensively then it should be cleaned on a weekly basis It is also important to clean and dry the product before it is packed away When cleaning your product never use strong detergents or silicone based products e NEVER use high pressure cleaning equipment such as a oressure washer This will result in damage to your product and void y
5. emperature Range between 62 77 F e Avoid performing repairs in direct sunlight or rain Step 1 Locate the damaged area The easiest way is to fully inflate the product and listen for the leak or to spray with soapy water and look for bubbles Mark the damaged area with a crayon or wax pencil and deflate the product Step 2 Cut out a patch approximately 2 inches larger than the leak Clean the damaged part of the product and patch and allow to dry thoroughly TIP It is a good idea to always use a circle or rectangle patch with rounded corners Pointed corners tend to pull off Step 3 Next clean the area and patch with alcohol grease remover or fingernail polish remover and allow to dry thoroughly Step 4 Apply glue in a very thin layer to the patch and then to the area of the leak Let the glue stand until tacky usually 30 seconds 1 minute TIP Place glue on the dull side of the patch and to the shinny side of the unit Then when you apply the patch it will match TIP Use a short brush just cut the length off as this digs into the material better to spread the glue Also try to use a brush with real hair instead of synthetic Step 5 Place the patch over the leak Step 6 Press out the air pockets which may have formed under the patch You can use any round object such as a spoon starting in the center and then working outwards towards the edges You can keep the repair tight by clamping toget
6. er Depth amp Clearance 8 Feet Minimum There should also be a minimum of 16 feet clearance all around the unit Recommended Ages 6 INFLATION SET UP AND SUPERVISION MUST BE DONE BY A MATURE AND KNOWLEDGEABLE ADULT You can use the following devices to inflate the Product High Speed Inflator Deflator Item 01083 Not included Inflator Deflator that plugs into a DC outlet in your vehicle Any other inflator designed for inflatable boats rafts pool floats air beds camping mattresses and other low pressure inflatables Foot hand pump Some RAVE products are too large for Foot hand pumps to inflate We do recommend using them to top off the air in the Product RAVE does not recommend inflating their products by mouth Please note Size your inflation connection to the approximate size of the valve Do not use bicycle connections Or pumps CAUTION Use extreme care when using an electric inflator anywhere near water Beware of the dangers of electrocution when using electric powered inflators Precautions should be observed during use and handling to prevent shock DO NOT inflate with an air compressor or other high pressure pump This unit is designed to be inflated with a high volume of air but at a low pressure Use of an air compressor or other high pressure pump will void your warranty DO NOT allow children to play with the product until it is fully inflated Insert the appropriate attachment of yo
7. her with spring pliers Step 7 Allow repair to cure for 24 hours before re inflating Step 8 Inflate the repaired product TIP It is a good idea to check again for leaks If you have multiple leaks the air will rush out of a larger hole before a smaller one CAUTION When using glue remove unused glue from threads of tube and cap and carefully replace the cap on the tube If properly sealed it will keep perfectly Do not leave the tube in the sun or next to heat sources or direct flames e Check that the room is properly ventilated avoid inhaling or ingesting the glue and avoid contact with skin DO NOT RETURN YOUR PRODUCT TO THE RETAILER CONTACT RAVE SPORTS FOR WARRANTY REPAIR AND RETURN INFORMATION RAVE Sports Raft Water Sports
8. ies of water may require more e Bell anchors are not typically recommended since they are easily dragged especially on flat sandy bottoms Screw type or more permanent toggle type anchors may be necessary in more extreme conditions e Attaching a heavy duty shock cord to the anchor line is recommended to help absorb vertical movements e Please consult with local authorities regarding any specific anchoring restrictions in your area e All Units Adjust length of anchor line so that it is approximately 1 2 ft longer than the depth of the water To help prevent flipping of your product in high wind conditions do not exceed 3 ft of total slack in the anchor line NOTE More slack will improve anchor holding performance but too much slack may allow the product to stand on edge and flip over in Strong winds For best results maximize your anchor holding power via more weight or a different type of anchor and minimize your anchor line length Types of Anchors Bucket Anchor Tire Anchor S EA Screw Anchor A Deflation Use one of the Inflator Deflator devices recommended in the Inflation Section for faster deflation Unscrew the cap by twisting counterclockwise to expose the air valve stem Open the air valve by pushing in the stem and rotating counterclockwise Allow air to escape Pushing on the stem and rotating clockwise will seal the valve Replace cap making sure it is tightened securely Completely Dry
9. nual Do not use this product unless you understand and accept the risk Safety Rules and Information Read and understand all of the information contained in this owner s manual before assembling and using your product Make sure that everyone who uses the product is provided with and understands these safety rules and information The Splash Zone Plus is designed to be used only in large bodies of water with depths of at least 8 feet Do not use or allow anyone else to use the product on land or any other hard surface in swimming pools or shallow water Consider the height and weight of the users of the Splash Zone Plus as well as the activities performed on the product when you are selecting a safe location Always maintain a safe distance between the Splash Zone Plus and any dock platform boat or pier Choose a location for your product that is most protected from wind of sufficient water depth and free of obstructions above and below the water Always anchor the Splash Zone Plus securely before it is used Always wear a U S Coast Guard approved Type III PFD vest when using the product Never use the product after sunset before dawn or any other time in poor lighting conditions Never use the product in rough surface water conditions during Storms or when there is lightning If an unexpected storm arises while using the product seek shelter on shore Do not stay on the product Never use the product under
10. our warranty Clean the outside surface only with mild soap and fresh water and check that the valves are clean and not damaged U V protectant may be used to prolong the life of your inflatable e To remove algae and other hazards from the ocean you can use a Special cleaning agent from your local marina Following the directions carefully All hardware O rings springs and such should be rinsed with fresh water weekly Although normal wear and tear is unavoidable this will increase the life of your product Storage When storing your inflatable keep it in a clean and dry place that is not affected by major variations in temperatures and other damaging factors You can store your inflatable deflated and rolled up or lightly inflated Be careful never to Stack anything on top of inflatable It is recommended that you allow the unit to completely dry before storage It is recommended to lubricate the rubber on the valves with a petroleum based product to increase the life of the valve Please note rodents such as mice chew on fabric including inflatable material As a precaution you can place moth balls or fabric softener sheets around the products during storage to deter them Repair All of the inflatable products include a repair kit You can easily repair minor punctures and cuts and even anchor plates or handles Conditions necessary for a successful repair are Relative humidity less than 65 T
11. the influence of alcohol or drugs Always stay under control while using the product Jump or bounce in the center of the trampoline surface and away from edges Never dive off of the Splash Zone Plus head first If you jump off the product always enter the water feet first Never use the product while tired or fatigued Use extreme caution while swimming between the shore and the product Do not attempt to swim this distance if you are tired or fatigued Never swim or play under or around the Splash Zone Plus Always inspect the areas around and under the product before each use to ensure the water is deep enough and free of all rocks logs sand bars and underwater obstructions and that the product is a Safe distance from hard objects above water Ask about local water conditions before using the product in unfamiliar water When not in use secure the product against unauthorized or unsupervised use Never use the Splash Zone Plus unless the safety pad is in place and securely fastened Inspect your product for any worn defective or missing parts Do not attempt flips somersaults or other acrobatic maneuvers on the product Most debilitating spinal cord injuries that occur during trampoline use involve somersaults Improper landing during a somersault produces serious risk of broken bones cuts nerve damage spinal cord or brain injury or death Use only under mature knowledgeable adult supervision Not recommended for
12. ur inflation device and inflate until firm but allow a small depression when pushed with our hand Inflate the main body of the inflatable first unless noted otherwise on Product Page Please Note Keep in mind the temperature of the air going into the product and the outside air If your inflator is hot and sending warm air into the product when it cools it will seem like your Product is losing air This is normal The product should be firm when completely inflated but allow a small depression when pushed on with your hand while in use This is a good evaluation of proper inflation Proper inflation should be checked often if the product is left inflated for consecutive days Be aware of your temperatures Heat causes air to expand while cold causes air to condense Variations of temperatures can make inflatables seem to lose air This is normal When the sun comes out and the temperature rises the air will again expand in the unit If you are experiencing a cool span you may want to add additional air Be careful when the temperature rises that the unit does not become over inflated Damage due to over inflation voids the warranty All inflatables are sensitive to cold therefore never unfold or inflate in temperatures below 50 F Product Assembly Attaching the Slide Connect the Slide attachment to the bouncer by placing both units against each other and lining up the loops on each side Unit must be on level ground to
Download Pdf Manuals
Related Search