KeContact P20-U User manual
Contents
1. Ready for charging with IS015118 charging cable is plugged in External enable still required authorization with external enable on the enable input still necessary Hardware error disconnect the vehicle and turn off the mains of the charg ing station Charging procedure is carried out applies for SAE J1772 charging pro cedure Charging procedure is carried out applies for S015118 charging proce dure Temperature limit exceeded charging procedure temporarily interrupted charging continues after cooling down Malfunction for details see Troubleshooting User manual Version 1 00 Article no 90664 KEBA 2012 KeContact P20 U 3 Troubleshooting PROBLEM Status LED does not light up Charging procedure is not started Vehicle is not fully charged Increased charging time Car error after starting the charging proce dure Status LED flashes red Status LED lights red User manual Version 1 00 Article no 90664 KEBA 2012 Troubleshooting Possible cause remedy No voltage supply Check line circuit breaker and switch on if necessary Defective please contact your service partner The vehicle does not need any power or has an error check the vehicle The vehicle is programmed to a later start time for charging The plug is not inserted correctly Pull out the plug and insert the plug again The charging procedure was not performed correctly follow the in2. 4 Maintenance s unnnannnnnnnnnnnnnnnnnnnnnnvnnnnnnvnvnvnnnnnnvnvnvnnnnnnvnvevannnnnvnvnvnnnnnnvnvnnnnnnvnvnnnnnnnnnnvnvnnnnnnnnvnnnnnnvnvnnen 11 4 1 Cleaning the fosfuvv4v4v4v42724vv474ervr4vdj4erervv74vvr4ve eee 11 4 2 Customer ServiCe ccccccecccceccececcecsccccececaucecuccacuecacsececseautecausecaucacsuceuscsucusseunecausecauseceteas 11 4 User manual Version 1 00 Article no 90664 KEBA KEBA 2012 KeContact P20 U Important information 1 Important information 1 1 Safety instructions WARNING A Not observing the safety instructions can result in risk of death injuries and dam age to the device KEBA AG assumes no liability for claims resulting from this e Electrical hazard The installation commissioning and maintenance of the charging station may only be performed by correctly trained qualified and authorized electricians who are fully responsible for the compliance with existing standards and in stallation regulations For details see KeContact P20 U Installation manual for the specialist Electrical hazard fire hazard Never use damaged worn or dirty charging plugs e The charging station does not have its own power switch The line circuit breaker of the building installation panel serves as mains disconnector The owner must ensure that the charging station is only ever operated in per fect condition The charging station must be checked regularly for faulty sockets and con nector
3. KeContact P20 U User manual NK f 13 TA Automation by innovation General notes for this manual At various points in this manual you will see notes and precautionary warnings regarding possible hazards The symbols used have the following meanings A DANGER Indicates that death or serious bodily injury will occur if appropriate precau tionary measures are not taken WARNING A Indicates that death or serious bodily injury can occur if appropriate precau tionary measures are not taken CAUTION Indicates that damage to property or minor physical injury can occur if appro priate precautionary measures are not taken gt ATTENTION Indicates that damage to property can occur if appropriate precautionary measures are not taken e This symbol reminds you of the possible consequences of touching electro statically sensitive components Note Notes on use of equipment and useful practical tips are identified by the Note symbol They do not contain any information that draws attention to potentially dangerous or harmful func tions This arrow marks working steps that you are to perform KEBA 2012 Specifications are subject to change due to ongoing technical development No guarantee is offered in respect of any of the specifications given here All rights reserved All intellectual property including trademarks and copyrights are the property of their respective owners Any u
4. does cause harmful interference to radio or television re ception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment to a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help CANADA This Class B digital apparatus complies with Canadian ICES 003 Cet appareil num rique de la classe B est conforme la norme NMB 003 du Canada For devices with optional BPL modem Complies with IC ICES 006 en conformit avec IC NMB 006 du Canada Revision history Modification Date modified Description from to Pages V1 00 221012 me Manual created User manual Version 1 00 Article no 90664 3 KEBA 2012 KEBA Contents KeContact P20 U Contents 1 iil clela ts alata Ko EEE une setae EE EN EE Stent anal n Seton 5 11 Fe COIS conp ae aE EET A EEE RT 5 1 2 intended USC cece cccececcccecsceccccecececcccucecscaucucecscaeaucusecseauausenseacseauausenseseusenenseauausenseataueauaeass 6 1 3 About thiS manual c cccc ccc cc eccccecscecsceccececsceccecececscaucusecseueausesscseaucuausesscseauausenseaeauaenseass 6 2 Using the charging SAN 7 PA 2 DEE 8 SD ME OUBDIOSIOO WING ia te hence A 9
5. and accident prevention measures appropriate to the situation in question must also be ob served 1 3 About this manual This manual is valid for devices of the type KeContact P20 U Use of this manual This manual is intended for the following groups of people e End users users of the charging station e Start up technicians service technicians in addition to the installation manual 6 User manual Version 1 00 Article no 90664 KEBA KEBA 2012 KeContact P20 U Using the charging station 2 Using the charging station Base model with charging cable type 1 A Status LED B Parking bay for charging plug C Housing cover D Hanger for charging cable Storing the charging plug charging cable If no charging procedure is being performed the charging plug must be plugged into the parking bay B for safe storage The charging cable must be coiled up and placed on the hanger D TD 1609 041 a Charging station application example Starting the charging procedure Status LED gt The charging cable is not The charging station must be ready for operation the status plugged into the vehicle LED flashes green slowly every 3 seconds Ready for opera tion gt Plug the charging cable into The status LED lights up orange continuously for about 7 sec the vehicle onds Self test The status LED lights up green continuously Ready for charg ing The charging procedure can be started b
6. ean the charging station using spray water from a hose high pressure cleaner etc to clean the charging station 1 2 Intended use KeContact P20 U is a charging station for the indoor and outdoor area at which electrically operated vehicles can be charged e g electric vehicles Additional optional features e Network capability e Switch contact for control of external additional equipment e g fan e Enable input for e g ripple control receivers time switches This permits a scheduled time controlled charging of the vehicle to be realized e BPL modem Broadband over Power Line according to GreenPhy standard e Mounting column for floor installation The intended use of the device always includes the compliance with the environmental con ditions for which this device was developed The device was developed manufactured inspected and documented in compliance with the relevant safety standards Therefore the products do not pose any danger to the health of persons or a risk of damage to other property or equipment under normal circumstances provided that the instructions and safety precautions relating to the intended use are properly observed The instructions contained in this manual must be followed precisely in all circumstances Failure to do so could result in the creation of potential sources of danger or the disabling of safety devices Apart from the safety instructions given in this manual the safety precautions
7. he charging station has cooled down Reset of an error If an error occurs during the charging procedure it must be acknowledged by the proper end ing of the charging procedure see section Ending the charging procedure On repeated occurrence of errors without any reason please contact customer service 10 User manual Version 1 00 Article no 90664 KEBA KEBA 2012 KeContact P20 U Maintenance 4 Maintenance The charging station is essentially maintenance free but it must be checked regularly by the owner for faulty charging plug including the charging cable and damage to the housing 4 1 Cleaning the housing gt If necessary clean the housing of the charging station using a moist cloth Stubborn dirt can be removed using a mild solvent free non scouring cleaning agent Never clean the charging station using spray water from a hose high pressure cleaner etc to clean the charging station 4 2 Customer service For questions or problems please contact the executive electrical installation company Before contacting customer service e Check the troubleshooting measures in the Troubleshooting chapter e Check the troubleshooting measures in the operating manual of the vehicle manufac turer e Make note of the model version on top of the device User manual Version 1 00 Article no 90664 11 KEBA 2012 KEBA www kecontact com
8. nauthorized use thereof is strictly prohibited Document Version 1 00 Article no 90664 KEBA AG Postfach 111 Gewerbepark Urfahr A 4041 Linz KeContact P20 U Contents This product is UL certified E350546 It complies with the required UL and CSA standards for North America and Canada This product meets the requirements of the ROHS Directive RL 2002 95 EC The corresponding Declaration of Conformity is located at KEBA AG FCC INFORMATION This device complies with Part 15 of the FCC Rules Operation is subject to the following two condi tions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation CAUTION Changes or modifications not expressly approved by the party responsible for compliance could avoid the user s authority to operate the equipment NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pur suant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment
9. s and damage to the housing visual inspection Ensure that the charg ing cable is not mechanically damaged bent pinched or run over and the connection area does not come into contact with heat sources dirt or water A damaged charging station must be switched off immediately and replaced Repair work to the charging station is not permitted and may only be per formed by the manufacturer replacement of the charging station Do not carry out any unauthorized conversion work or modifications to the charging station Do not remove any notices on the device such as safety symbols warning notices rating plates nameplates or cable markings No extension cables are permitted for connecting an electric vehicle to the power supply device for electric vehicles Only electrical vehicles or their chargers may be connected A connection of other loads e g electric tools is not permitted Read the information and instructions for your vehicle carefully before you charge the vehicle using the charging station e Pull the charging cable only at the plug and not at the cable out of the connec tor 1 Persons who due to their special training expertise and experience as well as knowledge of current standards are able to assess the work performed and the possible hazards User manual Version 1 00 Article no 90664 5 KEBA 2012 KEBA Important information KeContact P20 U CAUTION e Risk of damage Never cl
10. structions in section Starting ending the charging procedure Power reduction due high temperature by vehi cle or charging station Protect the vehicle and charging station from direct sunlight during the charging process carport garage Missing release by external controller energy supplier PV system Internal protective devices avoid charging charging power for car is not available please contact your service partner Malfunction first check the possible causes of error for the malfunction Switch off the supply voltage of the charging Station by installed line circuit breaker switch on the voltage supply again Defective please contact your service partner Hardware error disconnect the vehicle switch off the supply voltage of the charging Station by installed line circuit breaker and switch it on again contact your service partner if the status LED still lights red 9 KEBA Troubleshooting KeContact P20 U Possible causes of error for malfunction status LED flashes red Malfunctions must always be acknowledged by unplugging the plug and can be triggered for example by the following causes e The plug at the charging station sends an invalid state Hardware fault of the cable unplug the plug and plug in correctly if necessary e Temperature shut off The permitted temperature in the charging station was exceeded unplug the plug and wait until t
11. y the vehicle from this point of time then the status LED flashes green Charging procedure Ending the charging procedure The charging procedure is ended by pressing the release button on the charging plug gt Disconnect the charging plug from the vehicle Wait for unplugging gt Store the charging cable on the provided hanger of the device User manual Version 1 00 Article no 90664 7 KEBA 2012 KEBA Using the charging station KeContact P20 U 2 1 Status LED Status LED segments Status LED green Flashes slowly every 3 seconds blue orange green Lights up continuously She red Flashes green every Sec ond blue Flashes orange slowly every 5 seconds Flashes red 8 KEBA TD 1609 085 Status LED segments The status LED provides information about the current operating state of the charging station and consists of 4 segments S1 to S4 which can light up together or individually All segments can light up or flash in different colors If not otherwise specified all 4 segments light up together Function Ready for operation charging cable is not yet plugged in optional The charging station was authorized correctly Authorization is required charging station has not been authorized cor rectly yet authorization with external enable on the enable input still neces sary Self test internal CCID for about 7 seconds Ready for charging charging cable is plugged in
Download Pdf Manuals
Related Search