ProCair 9000 Quick Set Up Guide
Contents
1. Five different alarm signals are identified by five different Pressure Setting illumination sequences VISUAL ALARM AUDIBLE ALARM FAULT Power or onna Fuse issue Initial Ee elelo 0 A failure aona A e Pressure too high Brlelelelelclo lt A ue Alternation mode failure onnan Af olo o Refer to Trouble Shooting Guide or User Manual for further information on addressing faults Transport Function Press Mode button 4 to select static mode Wait at least 5 minutes for system to reach maximum pressure When fully inflated turn off Control Unit 1 switch off mains supply and unplug cord Remove the CPR handle from the Control Unit and quickly seal using the attached handle cap Make sure all four connectors are fitted firmly The length of time air is retained depends on weight height of the individual patient THERAPEUTIC DEVICE SHOULD ONLY BE USED IN ACCORDANCE WITH MANUFACTURERS INSTRUCTIONS amp UNDER THE CONSENT SUPERVISION amp MANAGEMENT OF A SUITABLY QUALIFIED HEALTH PROFESSIONAL ae medistore less pressure more support freecall 1300 882 194 freefax 1300 882 197 May15 www medistore com au2. Pro Ca1r 9000 quick setup guide Remove existing mattress and replace with ProCair Mattress Replacement printed top cover upwards air hoses towards bed base Secure to bed base using the adjustable straps Ensure there are no twists and tighten straps for a firm fit On profiling bed secure straps around AAA moveable bed base section Hang the control unit using the rear hanging hooks or place on a stable surface ie E floor beneath the bed Y Attach air hoses to the control unit Straighten any twists to ensure uninterrupted air flow between control unit and overlay Ensure the CPR tag sealing connector is fully inserted into air hoses tag is located on side near head end Feed the power cord through retention loops on side of mattress to keep cord off the floor kez Insert the power cord into control unit base then plug into power socket and switch 4 i on mains power 8 Press the Power button for two 2 seconds to switch on The Pressure Setting indicators Soft to Hard y flash to indicate the system is operational and inflating Allow up to 45 minutes for complete inflation When inflation is complete the fourth indicator togethe eo a with Alternating Mode E indicator will illuminate Once the mattress is inflated bedding can be replaced Secure sheets loosely enough to ensure they do not interfere with cell alternation 10 Lie patient face up and t
3. est pressure settings by performing a bottoming out test A a unzip one side of the top cover b slide your hand underneath the patient feeling for a deflated cell under the patient s lower spine your hand should easily slide between patient and base c for optimal pressure patient should be immersed 30 50 into fully inflated cells d if patient is not appropriately immersed decrease pressure setting and repeat test every 10 12 minutes until optimal pressure is reached ae medistore less pressure more support freecall 1300 882 194 treetax 1300 882 197 www medistore com au May15 Pro Ca1r 9000 control unit operation Oz Pro Car i 1 Power button Press and hold for two 2 or more seconds to turn on or off Always turn off before unplugging unit 2 Mute Alarm will continue to sound until fault is corrected Refer to trouble shooting guide to diagnose fault 3 Comfort controls Increase or decrease based on patient weight Refer to comfort guide for correct settings 4 Mode selections Press to switch between static or alternating mode Automatically returns to alternating after 20 minutes on static setting 5 Max inflate Press for auto set up rapid inflate to maximum pressure 6 Lockout Press and hold for five 5 seconds until beep is heard to lock or unlock 7 Alarm indicator Red light flashes and alarm sounds to alert when control unit or mattress fails
Download Pdf Manuals
Related Search