QUIET OPTION QUICK START UP PROCEDURE
Contents
1. M5 Serial Cntrl or M6 Parallel Ctrl is displayed Use Feature Value and Enter keys to change settings Repeat step 30 to save settings 33 If QUIET MODE is desired press Next Menu key until M8 Forms Thickness is displayed Use Feature Y key until Quiet LOW is displayed Whisper LOW will provide the lowest sound level possible however print speed will be approximately 1 4 normal speed Press the Enter key and close the door 34 Press Profile to save your changes NOTE Quiet LOW impact is sufficient for most 1 2 part forms the Quiet MED setting is for 3 4 part forms and the Quiet HI setting is for 5 9 part forms For Detailed Instructions See User s Manual REPACKAGING DIAGRAM Save Carton And All Shipping Materials SHIPPING INSERT OPTIONAL QUIET IPPIN HOUSING a Bar C f LEVARA UO UI M SH TOP SHIPPING FOAM ANTI STATIC DISSIPATING BAG y D 20 PINK POLY J si FRONT ACOUSTIC DOOR BUBBLE WRAP BOTTOM SHIPPING FOAM lt SHIPPING INSERT SHIPPING CARTON2. QUIET OPTION QUICK START UP PROCEDURE For Detailed Instructions See User s Manual BBF 104793 Rev 1 Remove top packing material and acoustic door Place acoustic door to the side 2 Using the midpoints as indicated carefully lift printer from box and remove bag Printer Weighs Approximately 45 Ibs 3 SAVE SHIPPING BOX AND PACKING MATERIALS 4 Install ribbon using instructions provided with ribbon box 5 Align lower front of printer with table edge or place on printer stand For improved forms loading and feeding use the TG DOC printer stand available from your distributor 6 Attach appropriate communication cable from your computer 7 Verify correct voltage setting U S A 115v 8 Attach power cord and turn power on 9 Load Main Path before attaching the Acoustic door 10 Move alternate path tractors to center Unlock right tractor and position for form width 11 Equally space Main Path paper guides and supports 12 Open both tractor doors load form and close tractor doors 13 Verify that left form edge is in line with alignment mark 14 Adjust right tractor SLIGHTLY to remove slack in form and lock tractor Do Not Over Tension Form 15 Acoustic door MUST be attached to load the Alternate Path 16 Attach front acoustic door by hooking over pivot points and leave open to r
3. est on the table top or stand lt STAND TOP 17 To load the Alternate Path feed the paper through the slot in the door 18 Load paper into the Alternate Path tractors following steps 10 14 19 Forms should be positioned to feed straight if not reposition forms For dual path printers see User s Manual 20 Press Load key to load form 21 Open keypad door to access Setup Mode 22 Press Adjust Form key 23 Use Value keys to position bottom of FIRST PRINT LINE to the rear of top exit cover Press Adjust Form key again 24 If your form is 9 5 x 11 close keypad door and go to step 31 Press Quick Access key until Form Length 66 is displayed 25 Use Value keys to set form length in number of lines Example 3 5 long x 6 lines inch default 21 26 Press Enter key to save new value 27 Press Quick Access key until Right Margin 80 is displayed CAUTION NEVER PRINT OFF EDGES OF FORM 28 Use Value keys to set right margin position in number of characters Example 6 wide x 10 char inch default 60 29 Press Enter key to save new value 30 Close keypad door and press Profile key to save settings 31 Press On Off Line key to display On Line Green light will remain on 32 IF NO PRINTING OCCURS open keypad door press Next Menu key until
Download Pdf Manuals
Related Search