USER MANUAL
Contents
1. flashlight and remove he batteries reassemble and rinse with reshwater Dry thoroughly and install new batteries Do not attempt to disassemble or repair this product It is dangerous and will also void the warranty Keep this product away from children Do not eave children unattended near this product Use only parts provided by the manufacturer Make sure that this product is intact and that here are no missing parts To avoid damage to this product be careful not to overtighten or improperly thread any of he threaded fittings All photos are for illustrative purposes only VULTA TORNADO 0 5 PRODUCT DIAGRAM LED LAMP HEAD HEAT SINK AREA VARIABLE CONTROL RING EJ TACTICAL RING I LANYARD EYELET O RING TAILCAP M BUTTON LANYARD SLOTS Also Included HOLSTER WB LANYARD Wi SPARE O RING m m 0 USER MANUAL TWO YEAR LIMITED WARRANTY 06 VULTA TORNADO A Note about Maximum Output When the flashlight is in High mode the battery discharge drive circuit and LED will all be producing heat and the lamp head may become extremely hot Please be cautious when touching it To protect the battery circuit and LED and to extend the lifetime of the flashlight we do not recommend continuously running the flashlight on High mode for more than 10 minutes INSTALLING BATTERIES The Tornado FL E25P can be powered by two CR123 or2. RCR123 3 or 3 7 V batteries or a single 18650 3 7 V battery When using an 18650 battery 2600 mAh capacity with overcharge protection is recommended To install a battery follow these steps 1 Make sure the flashlight is turned off 2 Unscrew and remove the tailcap from the flashlight 3 Insert the battery or batteries with the positive terminal s facing the lamp head 4 Screw the tailcap back onto the flashlight until secure VULTA TORNADO 0 OPERATION The FL E25P employs a tailcap button for temporary and constant on and a variable control ring to control output power and engage strobe mode POWERING ON FL E25P Constant On To turn on the FL E25P press the tailcap button all the way until it clicks Use the variable control ring to set the flashlight to the desired output see Adjusting the Output Temporary On Temporary on mode is ideal for a quick burst of light To engage this mode make sure the variable control ring is set to the desired output see Adjusting the Output and press and hold the tailcap button halfway until the light turns on The flashlight will remain on until you release the tailcap button SETTING THE MODE Adjusting the Output Rotate the variable control ring to adjust the flashlight s output between 0 5 and 547 lm The variable control 08 VULTA TORNADO ring operates in both temporary on and constant on modes Standby Mode In constant on mode you can
3. U TORNADO 547 LUMEN LAW ENFORCEMENT LED FLASHLIGHT VULTAY Thank you for choosing Vulta enue which CONDES high effi 7 VULTA TORNADO rnado FL E25P_ cn be be fitted with functionality a PRECAUTIONS A Please read and follow these instructions and keep this manual in a safe place This flashlight is extremely bright and can cause temporary or even permanent blindness Do not shine the flashlight in the eyes of any person or animal When powering on the flashlight make sure to point it down or away from you and anyone else The surface of this product can become hot after prolonged use Be careful when touching it and make sure to keep it away from anything flammable or combustible Do not stand the flashlight upright on its lamp head when powered on In this position the lamp head can become dangerously hot and damage the flashlight and anything nearby Never leave the flashlight unattended when it is powered on Before long term storage remove the batteries and store them in a cool and dry place to avoid leakage Always install batteries of the same type brand and age Do not combine different types OA VULTA TORNADO or brands or old and new batteries Install the batteries in the proper orientation as indicated by the instructions in this manual This product is waterproofed for freshwater only If it comes into contact with salt water immediately dry the
4. ne of the lanyard slots on the flashlight s tailcap or the lanyard eyelet in the metal tactical ring 0 VULTA TORNADO SPECIFICATIONS OUTPUT BEAM INTENSITY LED TYPE POWER SOURCE RUNTIME CONSTRUCTION IMPACT RESISTANCE WATERPROOFING EFFECTIVE RANGE DIMENSIONS WEIGHT Maximum Strobe 547 lm Minimum 0 5 lm 22 500 cd CREE XM L2 Two CR123 or RCR123 3 or 3 7 V batteries or one 18650 3 7 V 2600 mAh capacity with overcharge protection battery Maximum 2 hr Minimum 120 hr Body MIL SPEC Type hard anodized aerospace grade aluminum alloy Bezel Stainless steel Lens Tempered glass Up to 5 2 m IPX 8 standard up to 6 5 2m submersion 984 300 m Length 5 2 13 4 cm Head Diameter 1 3 2 3 cm Tail Diameter 1 2 6 cm Without batteries 4 2 oz 120 g With batteries 6 oz 170 g VULTA TORNADO TWO YEAR LIMITED WARRANTY This VULTA product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of two 2 years from the original purchase date or thirty 30 days after replacement whichever occurs later The warranty provider s responsibility with respect to this limited warranty shall be limited solely to repair or replacement at the provider s discretion of any product that fails during normal use of this product in its intended manner and in its i
5. ntended environment Inoperability of the product or part s shall be determined by the warranty provider If the product has been discontinued the warranty provider reserves the right to replace it with a model of equivalent quality and function This warranty does not cover damage or defect caused by misuse neglect accident alteration abuse improper installation or maintenance EXCEPT AS PROVIDED HEREIN THE WARRANTY PROVIDER MAKES NEITHER ANY EXPRESS WARRANTIES NOR ANY IMPLIED WARRANTIES INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE This warranty provides you with specific legal rights and you may also have additional rights that vary from state to state i To obtain warranty coverage contact the Vulta Customer Service Department to obtain a return merchandise authorization RMA number and return the defective product to Vulta along with the RMA number and proof of purchase Shipment of the defective product is at the purchaser s own risk and expense For more information or to arrange service visit www vultagear com or call Customer Service at 212 594 2353 O Product warranty provided by the Gradus Group www gradusgroup com VULTA is a registered trademark of the Gradus Group 2014 Gradus Group LLC All Rights Reserved GGI
6. rotate the variable control ring to the OFF position to enter standby mode This lets you work directly with the variable control ring to turn the light on and off and to adjust brightness Strobe Mode Strobe mode continuously emits quick flashes of bright light To enter strobe mode rotate the variable control ring clockwise until the arrow is aligned with the strobe symbol X The ring will click into position at this point You can access the strobe from both temporary and constant on THE TACTICAL RING The metal tactical ring provides an enhanced grip over a smooth metal surface and also helps when holding the flashlight with cold or wet hands or while wearing gloves If desired you can remove the ring by unscrewing the tailcap and then unscrewing the tactical ring VULTA TORNADO 9 O RING MAINTENANCE The Tornado FL E25P s O ring is installed on the threaded portion to help seal out water The O ring is prelubricated to extend its lifetime ensure smooth operation and increase water resistance If the O ring dries out or there is little or no lubricant remaining we recommend applying a small amount of O ring lubricant The FL E25P comes with a replacement O ring If the original wears out after long term use replace it with the included spare THE LANYARD You can attach and wear the included lanyard to help prevent accidental drops and to free up a pocket To attach the lanyard clip it onto either o
Download Pdf Manuals
Related Search