Water Logger Housing Manual (HOUSING-U2x)
Contents
1. Water Logger Housing Manual Part HOUSING U2x The water logger housing is designed for HOBO U20 and U20L water level loggers and HOBO U24 conductivity loggers to provide Inside this package e Water logger housing Specifications 229 8 102 added protection from debris while allowing water to move freely in and out e 6 Cable ties Recommended Installation Method Step 1 Unscrew cap from housing Step 2 Install one of the supplied cable ties through the hole in the lanyard end of the U20 or U20L or the a sensor end of the U24 Create a loop large enough to hook your finger through the loop only acts as a handle when removing logger from housing Trim excess Step 3 Feed one of the supplied cable ties through opposite holes at the middle of housing and then loosely loop as shown Note The cable tie will be tightened in step 5 to help prevent the logger from moving around in the housing Securing the logger in the housing is strongly recommended for the U20 to help ensure accurate water level measurements Use is optional for the U24 Step 4 With housing on a flat surface and while pressing down on cable tie so that it curves along inside bottom of housing insert logger with its cable tie handle closest to open end Logger should rest on top of curved cable tie and its handle should be fully inside housing U20 or U20L aN Dimensions 5 1 cm 2 0 in maximum d2. iameter 23 5 cm 9 25 in length U24 Press down on cable tie so that it curves along inside bottom of housing before inserting logger a view into housing Step 5 Step 6 Tighten cable tie to secure logger in Reinstall cap Hand tighten housing Trim excess securely 2010 2014 Onset Computer Corporation All rights reserved Onset and HOBO are registered trademarks of Onset Computer Corporation 14313 C MAN HOUSING U2X Water Logger Housing Manual Deployment Considerations e Using the supplied cable ties the housing can be secured to a post or other suitable structure A tethered mounting arrangement can also be used ye N LT TTT cao Post Mount Tether Mount e Refer to the logger user manual for additional deployment information Removing Logger from Housing e f necessary use an adjustable wrench to remove the cap e Use cutters to snip the cable tie securing logger if one is present e Remove the logger to perform readout and any required maintenance Refer to the logger and software user manuals as needed
Download Pdf Manuals
Related Search