Dia 20 Pocket Diamond Scale User`s Manual
Contents
1. Press ON OFF key Wait until 0 0 is displayed Put the object s on the weighing platform Using the MODE key you can switch between the weighing units BRWN Il Tare Weighing 1 Turn on scale as described above 2 Place the tare item on the platform 3 Press TARE and wait until 0 0 is displayed 4 Add the net weight item Ill Add Up Feature 1 In normal weighing mode place an object on the platform 2 Once weight is displayed press ADD UP key and replace item with another and press ADD UP again 3 The scale will display the sum of the two weights 4 You may repeat until scale reaches max capacity display will show 0 when capacity is exceeded IV Calibration 1 Turn the scale on as described above and wait for the display to show 0 000g 2 Press and hold the TARE key until the display shows CAL then a random number will be displayed ISN number 3 Make sure no weight is on the platform and press the TARE key again The display will flash CAL followed by 0 000g 4 Now place a 10g calibration weight on the platform and press TARE again when the number stabilizes The display will flash 10 000g followed by the ISN number again 5 At this point place another 10g on the platform to make a total of 20g on the scale and press TARE when the number stabilizes 6 The display will show 20 000g followed by PASS Press ON OFF to turn2. AWS American Weigh Scales Inc DIA 20 Precision Pocket Scale 20g x 0 001g USER S MANUAL American Weigh DIA 20 User s Manual 20g x 0 001g Thank you for purchasing the DIA 20 Precision Digital Pocket Scale Please read all operating instructions carefully before use Scales are precision instruments and should always be handled with proper care To ensure years of reliable service keep these simple tips in mind e Do not exceed the scales maximum capacity Overloading your scale can permanently damage it e Avoid exposure to extreme heat or cold Scales perform best at normal room temperature If temperatures have changed dramatically recalibration may be necessary e Allow your scale to warm up for 30 60 seconds before performing calibration if available e Store your scale in a clean dry location Dust dirt and moisture can accumulate on the weighing sensors and electronics causing innacuracy or malfunction e Avoid using your scale in close proximity to strong radio wave emitting devices such as computers cash registers and cordless phones e Always weigh on a flat and level surface free from vibrations and drafts The corner of a room is usually the most stable e Gently apply all items to be weighed Do not drop items onto the weighing platform e Avoid dropping your scale The warranty does not cover damage due to rough treatment or overload I Operation Place the scale on a flat and stable surface
3. the scale off and accept the calibration Calibration is complete V Troubleshooting The primary reason for innaccuracy or malfunction are low batteries improper calibration overload or operating on an unstable surface Please keep this in mind and maintain and operate your scale properly This scale is a precision instrument and must be handled with care Error Code Descriptions Error Nothing on screen LO Solution Replace Batteries Error EEEE Solution Load is in excess of 20g remove the extra load VI Specifications Capacity 20g 100ct 308 8gn 12 86dwt Graduation 0 001g 0 005ct 0 02gn 0 001dwt Units grams g carats ct grains gn pennyweight dwt Calibration Auto Calibration User Calibration with 2 10g weights Tare Range Tare full capacity Auto Off 60 seconds Display 5 digits 1 2 in height
Download Pdf Manuals
Related Search