User Manual
Contents
1. 1 Open the case as shown Or lt b f 2 For code setting Open your existing transmitter or the cover on receiver located on your operator and follow the steps corresponding to your brand of garage door opener Then re close the cover BATTERY Batteries are included with transmitter to replace 1 2 3 Test the trans Open the top cover as shown Remove the screw and lift out the circuit board Replace two fresh CR2032 lithium batteries follow the polarity shown on the case mitter by press ing the button Fasten the board onto the case with the screw PROGRAMMING YOUR NEW TRANSMITTER FOR CHAMBERLAIN SEARS made by Chamberlain only LIFT MASTER WAYNE DALTON or MASTER MECHANIC OPERATORS 390 MHz 3 Use a pen to set the switches to positive 0 middle negative to match their corresponding positions of your existing transmitter or receiver 4 Testthe transmitter and then close the cover WARNING If this transmitter tirggers other garage doors in your neighbourhood change all your transmitters and receiver to a new code setting DO NOT let children use the garage door transmitter without adult supervision Children can injure them selves or others by the garage door Note Note LEARN CODE If your transmitter receiver does not have a DIP switch that means it can LEARN new code settings Set your new2. es the unit will determine how to set the number 1 dip switch of the Skylink transmitter If the large button is used to operate the unit set the 1 dip switch to position if the middle button is used set the 1 dip switch to the center position if the button at the end is used set the 1 dip switch to position Set the other dip switches dip switch 2 onward to match the setting of your existing transmitter SKYLINE xO GARAGE DOOR REMOTE CONTROL USER S INSTRUCTIONS MODEL 200C Skylink will not be liable or responsible for any misuse or application of this product other than for its intended use Ei RSS CUSTOMER SERVICE nl 17 Sheard Avenue Brampton Ontario Canada L6Y 1J3 Fax 800 286 1320 Email support skylinkhome com Customer Service 800 304 1187 From 9am to 5pm EST Mon Fri http www skylinkhome com US Patent D377458 5680134 6005508 2005 SKYLINK GROUP 101A066 001 are registered trademark of their respective corporations
3. transmitter to any code combi nation Then simulttaneously activate both the transmitter button and the If your existing trans mitter has an 8 posi tion DIP switch set the first 8 switches of this new transmitter to match the switch settings of your existing transmitter Then make sure you set the last switch position 9 to 0 center position on your new transmitter ximately two seconds The receiver in dicator light will flash verifying that the new code set ting has been learned Learn Button Indicator Light Green FCC The Garage Door Remote Control is approved by the FCC and it com plies with Part 15 of the FCC Rules Its operation is subject to the follow ing two conditions 1 This device may not cause harm ful interference 2 This device must accept any inter ference that may cause undesired operation WARRANTY If within one year from date of purchase this product should become defective except battery due to faulty workman ship or materials it will be repaired or replaced with out charge Proof of pur chase is required WARNING Changes or modifications to this unit not expressly approved by the party responsible of compliance could void the user s authority to operate the equipment learn button on the receiver for appro 5 If your Sears Chamberlain or Lift Master transmitter has three buttons two small one large then the button that operat
Download Pdf Manuals
Related Search