Quick Start
Contents
1. Quick Start Safety Use secure and appropriate lifting and battery loading techniques Ask for help if it is too heavy for you to manipulate How does it works Remote The wireless remote control regulates the speed of your Maverix Skateboard Pulling the trigger toward you will accelerate the board Releasing the lever will return it the the near neutral position and allow you to coast downhill Pushing the trigger away from you will engage braking Quick start Note When synchronizing skateboard to remote do it apart and one at atime so there is no confusion into frequences Once remote and skateboards are synchronized they are communicating exclusively together Step 1 Check that you are on the low speed mode see instructions below Select your speed level in remote s handle Three speed positions are available under the 9 volts battery as follows e Position 1 Maximum speed e Position 2 Medium speed e Position 3 Low speed Always start your experience on Position 3 Low speed Once familiar with the control you can pass to higher speed Make sure the power button on your Maverix electric skateboard switch located on front of the battery is set to ON and the power of the remote is set to O off Step 2 Get on the board connect your safety leash and make sure to have a comfortable and adequate position before starting The chest straight the knees slightly bent the body weight sl2. MAVERD lt ELEGTRIG SKATEBOARD Quick Start How to change pre set performance level Comment changer de niveau de performance Speed and acceleration rate Niveau de vitesse et acc l ration Always start your experience on the default Toujours faire votre premier essai au niveau initial a la setting Low speed livraison basse vitesse 1 Turn off remote 1 Eteindre la manette 2 Remove 9 volts Battery from bottom of remote 2 Retirer la pile 9 volts du compartiment kase read your user manual 3 A little switch is place behind the battery 3 Un petit commutateur est plac derri re la Select level pile Choisir une des trois positions 3 Low speed 3 vitesse basse 2 Medium speed 2 vitesse moyenne E 1 High speed 1 Vitesse maximal O t g 4 Replace battery and cap 4 Replacer la pile et fermer le Turn On the remote to synchronized compartiment Remettre la manette en new signal to your board fonction pour synchroniser votre nouveau niveau MES op JenuewW OA alj zanean ajOUUONIppe UONEWOJU Important When synchronizing your remote make Important Lorsque vous synchronisez votre manette assurez sure you are at least 10 from other Maverix vous d tre plus de 3metres 10 d une autre planche Maverix Note Ne pas retirer le rev tement d aluminium C est votre antenne MAVERD lt Note do not remove foil tape It is your antenna MAVERD lt MAVERIX ELEGTRIG SKATEBOARD
3. ighly forward Step 3 Without putting your finger on the trigger turn on your remote control setting the knob to I or if you want to use the remote control light Step 4 Lightly squeeze the trigger in order to make your Maverix skateboard gain speed MAVERD lt ELEGTRIG SKATEBOARD Quick Start Step 5 Slighty push the trigger forward in order to brake Step 6 Be sure you are thoroughly familiar with all the features and controls discussed in the manual before you ride your Maverix electric skateboard Know your limits and ride within them Charging the battery In order to charge your Maverix the charger provided plugs into an ordinary outlet 120 volts and into the battery block below the deck The batteries are fully charge when the light on the charger turns from red to green Caution When the light turns green disconnect the charger from the battery and the wall outlet If the battery remains in charge too long you may damage the charger and battery
Download Pdf Manuals
Related Search