Laparoscopic Retractor
Contents
1. a standard cannula diameter of 5 5 5 mm by means of the Virtual Ports Applier It is attached to the organ requiring retraction with the organ clip and then to the internal operating cavity wall with the anchoring clip thereby exposing the operative field The Applier is then removed and the port is available for use by other instruments When the Device is no longer required it is removed from the internal operating cavity by means of the Applier INDICATIONS The Virtual Ports EndoGrab System is indicated for internal organ retraction during minimally invasive surgery WARNINGS AND PRECAUTIONS It is important for the EndoGrab System operator to be familiar with this manual its precautions procedures and safety issues The following labels are used in this manual to identify important concerns Warnings A Warning indicates a situation in which the user or the patient may be in danger of injury or death Epec Any special care to be exercised by a practitioner or patient for the safe and effective use of the device NOTE Emphasize important instructions AN mins e Lack of familiarity with the device prior to use could result in damage to the device and serious injury e The EndoGrab Retractor is provided STERILE and is intended for SINGLE PATIENT USE ONLY DO NOT RESTERILIZE Re use of the EndoGrab Retractor may lead to serious infections e The Virtual Ports Applier is a reusable instrument It MUST be processed before2. each use according to the instructions in the User Manual supplied with the device e Inspect the Applier after each cleaning and sterilization cycle to be sure it is clean functioning properly not damaged and does not have any loose bent broken cracked worn or fractured components e The accompanying instructions only describe the proper use of the EndoGrab System and are not recommending any surgical procedure The System should only be used by persons with adequate training and experience in minimally invasive and general surgery e Do not use the EndoGrab for the retraction of the liver e Do not attach the anchoring clip B to anchor the retraction to tissues other than the internal operating cavity wall the peritoneum e Do not make contact between the Device and an electrosurgery electrode Accidental application of electrosurgery on the Device could cause tissue damage and further complications Pi EEE e Do not attempt to operate the EndoGrab Retractor with any instrument other than the Virtual Ports Applier Doing so could damage the product and cause tissue injury e Do not attempt to use the Virtual Ports Applier to any means other than the instructed application of the EndoClear Lens Cleaner or other Virtual Ports devices STERILITY CARE AND HANDLING e Each product is packaged individually in sterile sealed pack e The product is disposable for single use only and should not be reused e Sterility of the produc
3. Virtual Ports Laparoscopy Systems _ EndoGrab Laparoscopic Retractor Israel Corporate Office U S A Corporate Office Virtual Ports Ltd Virtual Ports Inc 20 Alon HaTavor St Virginia Biotechnology Research Park Caesarea 38900 Israel 800 East Leigh Street Phone 972 4 6277506 Richmond VA 23219 Fax 972 4 6275390 Phone 1 877 226 9704 e mail info virtual ports com LBO14 01 rev 2 ee INSTRUCTIONS FOR USE NOTICE It is important that you read these instructions for use before you use the EndoGrab System It is unsafe to use this device before you have read and are thoroughly familiar with this document SYMBOLS Virtual Ports Ltd MANUFACTURER NAME 20 Alon HaTavor St Caesarea 38900 Israel MANUFACTURER ADDRESS Wo Ports MANUFACTURER LOGO ATTENTION SEE INSTRUCTIONS FOR USE EXPIRATION DATE REFERENCE NUMBER LOT NUMBER DATE OF MANUFACTURE DO NOT REUSE STERILIZED BY GAMMA ISTERILE R DO NOT USE IF PACKAGE IS OPENED OR DAMAGED This device complies with applicable requirements of the 1023 Council Directive 93 42 EEC Caution Federal law restricts this PRESCRIPTION USE device to sale by or onthe order STATEMENT alga e of a physician Applicable for U S A only Mr Alfred Eckert AUTHORIZED Zum Klosterbruehl 32 REPRESENTATIVE IN THE D 66636 Tholey Germany EUROPEAN COMMUNITY WHEN THE SYSTEM ARRIVES As the box is unpacked check the content of the box against the item li
4. evice away from the tissue where it lay to avoid accidental injury 4 If the organ clip A is now fixed on the Applier proceed from step 7 retraction or 29 removal 5 If the anchoring clip B is now fixed on the Applier proceed from step 29 removal and then start over from step 1 if needed STORAGE AND SHELF LIFE The EndoGrab Retractor is a sterile device and intended for single use only The EndoGrab Retractor s shelf life is 24 months The product should be stored in a clean and dry place Environmental storage and use conditions Temperature range 10 C to 60 C Relative humidity range 10 to 40 RH Atmospheric pressure 500 to 1060 hPa
5. into the detachable tube 15 Problem When pulling the trigger 13 to activate either one of the Device clips nothing happens i e the flap 4 or jaws 3 don t open Corrective action The Applier loop 16 might not be engaged correctly with the clip hook 1 or 2 1 Press the release button 9 to release the Device 2 Carefully re engage the hook 1 or 2 of the Device with the Applier loop 16 and pull back slightly to ensure the Applier loop 16 is engaged at the curved end on the hook 23 3 Pull the trigger 13 to verify the Device clip is activated Problem While approaching the desired anchoring site on the internal operating cavity wall the connecting wire 6 gets tangled between the anchoring clip jaws 3 Corrective action The open the jaws 3 and maneuver the anchoring clip to correct the situation Problem When removing the Device from the internal operating cavity the anchoring clip B does not fit into the EndoGrab sleeve 12 after the organ clip A Corrective action Release the organ clip A and engage the anchoring clip B and proceed to encase the anchoring clip first and then the organ clip Problem The Device is accidentally released and dropped within the internal operating cavity Corrective action Take action as soon as possible 1 Find and engage the hook of either one of the Device s clips 1 or 2 with the Applier loop 16 2 Pull the trigger 13 until the safety clicks into position 3 Carefully move the D
6. r loop 16 see Figure 6 11 Pull back gently on the Applier trigger 13 until the safety clicks into position 12 When the desired anchoring site on the internal cavity wall 22 is reached pull the trigger 13 to open the jaws 3 of the anchoring clip B see Figure 7 13 Release the Applier trigger 13 and pull back slightly in order to close the jaws 3 of the anchoring clip B on the anchoring site 22 There is no need to apply excessive force onto the internal wall during the anchoring procedure 14 Press the release button 9 in order to release the anchoring clip B from the Applier see Figure 8 15 Visually inspect the retraction before continuing with the surgical procedure The connecting wire 6 may stretch and change shape during the retraction 16 If the retraction is satisfactory remove the Applier from the internal operating cavity If not see step 21 below e Adjust the retraction or remove the EndoGrab 17 Insert the Applier through the cannula into the internal operating cavity 18 Engage the hook 2 of the anchoring clip B with the Applier loop 16 19 Pull the trigger 13 to open the jaws 3 of the anchoring clip B and move it away from the internal cavity wall 20 Release the trigger 13 to close the jaws 3 21 Proceed with one of the following options a Adjust retraction by repositioning the anchoring clip B on the internal cavity wall 22 Follow steps 12 16 b Adjust retrac
7. sted on the packaging slip If the content is incomplete notify Virtual Ports Check the content condition If the content is damaged notify Virtual Ports Do not use if the package suffered any damage ILLUSTRATIONS Figure 1 The EndoGrab Retractor consists of Organ Clip A and Anchoring Clip B Figure 2 Engaging the organ clip hook 1 with the Applier loop 16 Figure 3 Encasing the Device both clips A and B within the EndoGrab Sleeve 12 Figure 4 Approaching an organ 21 with the organ clip body 5 and the flap 4 opened Figure 5 Grabbing an organ 21 with the organ clip A Figure 6 Switching to the anchoring clip B by engaging anchoring clip hook 2 with Applier loop 16 Figure 7 Approaching the anchoring site on the internal operating cavity wall 22 with the jaws 3 of the anchoring clip B opened to attach onto the anchoring site Figure 8 Completed retraction The organ clip A is holding the retracted organ 21 while the anchoring clip B is attached to the internal operating cavity wall 22 Figure 9 The Virtual Ports Applier DEVICE DESCRIPTION The Virtual Ports EndoGrab Laparoscopic System the System is an internally anchored hands free organ retracting device for use in minimally invasive surgery The System comprises the EndoGrab Retractor the Device and the Virtual Ports Applier the Applier as is described below The EndoGrab Retractor is introduced into the internal operating cavity via
8. t is ensured until the expiration date printed on the pack unless the sterile sealed pack has been damaged or previously opened e The product should be stored in a dry location SAFE OPERATION L oad the EndoGrab Retractor on the Virtual Ports Applier The Applier loop 16 should be visible at the distal end If it is not release the trigger 13 and press the release button 9 Engage the hook 1 of the organ clip A with the Applier loop 16 see Figure 2 Pull back gently on the Applier trigger 13 until the safety clicks into position Push the EndoGrab sleeve 12 forward until both clips of the Device are encased within the sleeve see Figure 3 The EndoGrab Retractor is now loaded and ready to be used e Insert the EndoGrab into the internal operating cavity 5 Insert the loaded Applier into the internal operating cavity through a 5mm or larger cannula 6 Pull back on the EndoGrab sleeve 12 to expose the Device Continue until both clips are fully exposed e Retract an organ with the EndoGrab re 8 9 When the desired organ for retraction 21 is reached pull the trigger 13 to open the flap 4 of the organ clip A see Figure 4 Grab the desired organ 21 in between the organ clip s flap 4 and body 5 and release the trigger 13 to attach the clip to the organ see Figure 5 Press the release button 9 in order to release the organ clip A from the Applier 10 Engage the hook of the anchoring clip 2 with the Applie
9. tion by attaching the organ clip A at a different position on the same organ OR perform retraction of a different organ 23 Press the release button 9 in order to release the anchoring clip B from the Applier 24 Engage the hook 1 of the organ clip A with the Applier loop 16 25 Pull the trigger 13 all the way in order to open the flap 4 of the organ clip A and move it away from the organ 26 Follow steps 7 16 Remove the EndoGrab Retractor from the internal operating cavity 27 Follow steps 23 25 28 Release the trigger 13 to close the flap 4 29 Push the sleeve 12 forward until both clips are completely C covered 30 Remove the Applier with the Device from the internal operating cavity 31 Pull back on the Applier sleeve 12 to expose the Device 32 Press the release button 9 in order to release the Device from the Applier TROUBLESHOOTING Problem When engaging either one of the Device clips and attempting to activate it it does not fit into the Applier detachable tube and gets stuck on the end of the tube detachable Corrective action The Device clip might not be aligned correctly 1 Press the release button 9 to release the Device 2 Carefully re engage the hook 1 or 2 of the Device and pull back slightly to align the Device with the Applier detachable tube 15 without pulling the trigger 13 3 Pull the trigger 13 until the safety clicks into position and the Device fits
Download Pdf Manuals
Related Search