TUSA WATERPROOF FLASHLIGHT USER MANUAL
Contents
1. Dimensions 0 1 49 x 5 12 inches 3 8 x 13 cm Dimensions 0 1 49 x 5 12 inches 3 8 x 13 cm Use environment 0 40 C a Use environment 0 40 C2. ODY BATTERY CRADLE SWITCH END CAP 1 Turn the switch end cap at the rear of the flashlight s body counter clockwise and remove it 2 Slide out battery cradle and remove depleted batteries 3 Install 3 fresh AAA batteries into the cradle Follow the polarity as shown 4 Clean by removing any sand or dirt from screw threads and O rings on switch end cap and then apply a small amount of silicone grease on O rings 5 Also check and clean if necessary the screw threads inside flashlight body 6 Slide the battery cradle back into the flashlight body spring end towards the flashlight head 7 Once you have inserted the battery cradle securely tighten the switch end cap back into place by turning clockwise SPECIFICATIONS TUL 400MDR wide beam TUL 410MBL concentrated beam LED CREE XPG 100 000 hour lifetime LED CREE XPG 100 000 hour lifetime Battery 3AAA Battery 3AAA Lumens 165 Lumens 220 Beam angle 50 60 degrees Beam angle 5 6 degrees a Magnetic tail switch 100 30 hold for strobe Magnetic tail switch 100 30 hold for strobe Burn time 100 2 hours consecutive Burn time 100 2 hours consecutive 30 7 hours consecutive 30 7 hours consecutive Waterproof to 400 feet 122 meters Waterproof to 400 feet 122 meters Net weight 5 82 0 35 oz 165 10g Net weight 5 82 0 35 oz 165 10g without battery and hand strap without battery and hand strap
3. TUSA WATERPROOF FLASHLIGHT USER MANUAL Model TUL 400MDR wide beam or TUL 410MBL concentrated beam FEATURES This stylish waterproof flashlight is compact yet bright using a long life CREE XPG LED for maximum effect The magnetic tail switch features variable power control push one time for 100 power 2 times for 30 power 3 times for off From any setting push and hold switch for 3 seconds to activate emergency strobe The magnetic switch eliminates water leakage often seen in conventional models and has a high capacity to withstand pressure USAGE CAUTIONS CAUTION Make sure to only use equally charged batteries do not mix and match Never mix Alkaline and Lithium batteries SWITCH CARE Because a magnet is used in the tail switch section tiny naturally occurring iron particles iron sand can accumulate on the switch during diving After every dive wash thoroughly in fresh running water to remove any such iron sand as well as dirt and salt The push button switch is designed to allow water to enter switch area It is very important to flush salt water from chamber Hold switch under flow of cool fresh water Turn upside down and depress switch several times until no more water comes out Repeat process 2 3 times to ensure that all salt water is flushed from compartment Do not drop or place the flashlight on sand or dirt since iron sand may stick or go into switch section HOW TO REPLACE THE BATTERIES f v B
Download Pdf Manuals
Related Search