Home

Portable Evaporative Air Cooler User Manual

image

Contents

1. CLEANING THE CARBON DUST FILTER AND HONEYCOMB COOLING MEDIA i Figure 1 e The appliance is supplied with a Carbon Dust Filter and Fel ea i k ooling Media Honeycomb Cooling Media e The Carbon Filter and Honeycomb Cooling Media are located inside the Rear Grill See Figure 1 for instructions on how to remove them from the unit for cleaning and maintenance e Do not run the unit in COOL mode with stale water in the tank You must empty the water tank and refill with fresh water especially if the tank has not been cleaned in a long time Honeycomb Screws f Frame e The cleaning frequency for the Honeycomb media depends Removing the Carbon Dust Filter Honeycomb Cooling Media on local air and water conditions In areas where the mineral 1 Remove all the screws from the Rear Grill of the Air Cooler i 2 Carefully pull out the rear grill from the cooler content of water is high mineral deposits may build up on the 3 Slide out the Carbon Filter and clean with water Honeycomb Cooling Media and restrict air flow Draining the 4 To release the Honeycomb Media remove the Honeycomb ts Frame screws and pull the Honeycomb Frame out of the water tank and refilling with fresh water at least once a week unit will helo reduce mineral deposits If mineral deposits remain gt Remove the screws on the base of the Honeycomb Frame i and slide out the Honeycomb Cooling media Replace or on the Honeycomb Cooling Media
2. the media should be clean media with water and a damp cloth as needed removed and washed under fresh water The media should WARNING DO NOT operate the Air Cooler when the be cleaned every two months or sooner depending on your Rear Grill is removed from the Air Cooler or if there is a need loose fitting Rear Grill Doing so can cause serious injury or eeds dangerous electrical shock e For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool function 15 minutes before turning the unit off Carbon Dust Rear Grill Applicable for models with Carbon Dust Filter only 3 TECHNICAL SPECIFICATIONS Model CL151 Voltage 220 240V Frequency 50Hz Wattage 126 W Water Tank Capacity 15 Liters 3 96 Gallons Cooling Media Honeycomb 380 W x 365 D x 680 H mm See BIST 14 9 W x 14 4 D x 26 7 H in Net Weight 8 2 kg 18 1 Ibs ELECTRICAL WIRING DIAGRAM Version 220 240V 50Hz COOL SWING Sole Distributor in Malaysia KHIND ALLIANCES SDN BHD 811092 W No 2 Jalan Astaka U8 82 Bukit Jelutong 40150 Shah Alam Selangor Malaysia Service Center 1 800 88 0032 Email kas inquiry khind com Website http Avww khindalliances com AirTek International Corporation Limited JMATEK International Group of Companies Manulife Financial Centre Kwun Tong Hong Kong Phone 852 2559 5522 Email info honeywellaircoolers com Web www honeywellairco
3. Honeywell Portable Evaporative Air Cooler User Manual Read and save these instructions before use Honeywell www honeywellaircoolers com Model E mail info honeywellaircoolers com CL151 3 5 6 1 Control Panel 5 Water Level Indicator 9 Ice Compartment Lid 2 Louvers 6 Casters 10 Rear grill 3 Water Fill Door 7 Water Tank 11 Honeycomb Cooling Media 4 Power Cord amp Plug 8 Handle 12 Drain Plug WARNING READ AND SAVE THE AIR COOLER SAFETY amp MAINTENANCE GUIDE AND USER MANUAL BEFORE USING THIS PRODUCT FAILURE TO FOLLOW THESE INSTRUCTIONS MAY DAMAGE AND OR IMPAIR ITS OPERATION AND VOID THE WARRANTY CONTROL PANEL FUNCTION BUTTONS POWER Press the C button to turn the unit on The cooler will start automatically at medium speed After a few seconds the speed will switch to low SWING Press the SWING button until the SWING indicator light is illuminated on the control panel The louvers will begin to move left to right automatically Vertical Air Flow You can manually adjust the louvers to change vertical air flow LONER MOVEMENT TIMER Press the TIMER button until the desired time duration setting is selected When the set time has passed the unit will automatically turn off unit remains in Standby mode until power cord is un
4. e water tank Open the Water Fill Door Water Fill Door The Water Level Indicator is located at the front of the unit Refill the water tank when water level is low Do not fill water above the Max water level mark Check the water level in the tank before running the COOL function Make sure that the water in the tank is above the minimum water level mark Running the unit in COOL mode with inadequate water may cause pump failure Note If ice is available you may add ice in the top ice compartment to enhance the cooling performance CLEANING amp DRAINING THE WATER TANK Below are instructions on how to clean and maintain your air cooler If the cooler will not be used for a long period of time please refer to the STORAGE amp MAINTENANCE GUIDELINES located in the separate Safety amp Maintenance Guide WARNING Before cleaning the unit switch the unit OFF and disconnect from the electrical socket Ice Compartment e Move the unit to a location where the water can be drained Remove the cap from the Drain plug located at the bottom of the unit Allow the tank to empty e Refill the water tank with clean water and drain it completely e Refill the water tank with clean water up to the maximum level e Use a damp cloth to remove the dirt and dust from the surface of the unit Never use corrosive elements or chemicals to clean this product e When the product is not in use store the unit in a dry place our of direct sunlight
5. olers com Made in China 2015 AirTek Int l Corp Ltd All rights reserved The Honeywell Trademark is used under license from Honeywell International Inc Honeywell International Inc makes no representations or warranties with respect to this product This product is manufactured by Airtek Int l Corp Ltd Honeywell
6. plugged from electrical socket The TIMER function allows you to program the unit for up to 7 5 hours of use FUNCTION BUTTONS CONTINUED SPEED Press the SPEED button repeatedly to change the speed between 3 2 1 The indicator light will show the selected speed High 3 lt gt Medium 2 Low 1 WIND Press the MODE button to select your desired wind type N R S NORMAL N You can select either High Medium or Low fan speeds RANDOM R The fan speed alternates between High Medium and Low and off to mimic a natural breeze SLEEP S This mode is for comfort during the night When SLEEP mode is selected the airflow will start at a higher speed for 30 minutes and reduce to a lower speed for 30 minutes When the speed reaches Low speed the fan will run in low speed continuously until you switch OFF the unit You may set the starting speed to be High Medium or Low If you start the SLEEP mode with High speed the fan will run for 30 minutes in High speed then 30 minutes in Medium speed and finally switch to Low speed continuously If you start the SLEEP mode with Medium speed then the fan will run for 30 minutes in this speed before changing to a continuous Low speed COOL Press the COOL button until the COOL indicator light is illuminated on the control panel This activates evaporative cooling The water pump will operate and you will feel the cooler air after the Honeycomb Cooling Media is completely
7. wet Note When the COOL indicator light is switched OFF the unit can still function in a fan only mode without evaporative cooling REMOTE CONTROL POWER ON OFF COOL Controls cooling or fan option SWING Controls the motion of the louvers TIMER Controls the Timer function for automatic shut off WIND Switch between Normal Random amp Sleep SPEED Low Medium High Note e The remote control requires AAA 2 x 1 5V batteries for replacement Open the battery compartment at the back of the remote control and insert the batteries inside Care must be taken to insert the batteries according to the correct polarity markings shown inside the battery compartment Always point the remote control signal transmitter towards the unit when operating Make sure that the signal path is not obstructed Remove the batteries if the unit is not going to be used for an extended period of time Do not drop the remote control Do not mix different types of batteries such as alkaline carbon zinc or rechargeable batteries Do not mix old and new batteries Exhausted batteries are to be removed from the product COOLER LOCATION Make sure to position the air cooler correctly before you set up and start using the product Please refer to the COOLER LOCATION section of the separate Safety amp Maintenance Guide FILLING WITH WATER CAUTION Unplug the unit from the electrical power outlet before emptying or refilling th

Download Pdf Manuals

image

Related Search

Related Contents

Bauanleitung LED-Leuchtbild mit Platine Niko V3 und Matrixplatine  油圧ショベル - Cat  MHL 115 ZOOM WASH 18X 9W 15DMX  refacciones originales italika  Samsung VP-D63 Camcorder User Manual  VAD-800取扱い説明書  MC9190-G Series Regualtory Guide [English] (P/N 72-139207  Manuel Podo PE823 - Francis Mountain  Untitled - Mémoire net  USB Multi- Channel Audio Converter User Manual  

Copyright © All rights reserved.
Failed to retrieve file