5804BDE User`s Manual
Contents
1. In Enable or Disable High Security encrypted Mode eee eres Multiple Button Operations The 5804BDE can generate the same responses as keypad panic key pairs of and 1 by depressing A C and B D button pairs respectively You must depress the button pair for at least 2 seconds for the 5804BDE to recognize the button pair command These button pairs allow you to activate panic fire and medical alarms depending on control panel programming Low Battery Indication When the unit goes into a Low Battery condition the yellow LED will not flash when a button is pressed Change both batteries immediately To Replace the Batteries Remove the screw from the back case Remove case back by using the blade of a small screwdriver to pry open Place batteries as shown on diagram Use CR2430 or DL2430 Lithium batteries only Close case by snapping case front and back together Replace the screw to secure the case m RON Improperly installing the batteries will cause damage to the batteries LIMITATIONS STATEMENT Signals sent by wireless transmitters may be blocked or reflected by metal objects before they reach the alarm receiver Even if the signal path has been recently checked during a weekly test blockage can occur if a metal object somehow blocks the signal path Wireless button type transmitters that have visual and audible indications of status must be used to confirm that the desi2. K3644 12 99 5804BDE ADEMCoO TWO WAY WIRELESS KEY USER GUIDE About the 5804BDE The 5804BDE is a four button remote control for your alarm system It can send a command to the alarm system such as to arm or disarm as well as receive system status Two LEDs and a speaker indicate system status The 5804BDE is typically used for arming disarming and home automation Check with your installer to understand which functions the buttons have been assigned on your unit Operating the Buttons Activating a Function To activate a function press and hold the appropriate button down until the yellow LED flashes 2 beeps will be heard and then release it Requesting System Status You can check system status before arming or disarming your system Check your system status by momentarily pressing and releasing any button The yellow LED will flash after you release the button 1 beep will be heard After a second or two the 5804BDE will display the system status through the LEDs and speaker see the System Status Indications Table below If the 5804BDE does not receive system status from the panel for approximately 5 seconds it will generate a long 1 second beep and shut itself down It will also shut itself down if you do not press a button within 5 seconds of receiving a status update System Status Indications Table Yellow left Indicates RF transmission encrypted _f Red amp Green Alternately Flashing Pores ipemene a
3. red action such as arming has occurred after pressing a function button on any of these transmitters Be sure to listen for appropriate audible and visual indications that such action has occurred Otherwise you could inadvertently leave yourself or your premises unprotected External factors such as humidity high or low temperatures or constant activation of a programmed button may reduce battery life in a given installation If the button unit is used infrequently activate it regularly once per week to confirm operation A button type transmitter will report a low battery condition to the alarm control when a low battery status is detected ALARM DEVICE MANUFACTURING CO A D E Mi OC O DIVISION OF PITTWAY CORPORATION 165 Eileen Way Syosset NY 11791 COPYRIGHT 1999 PITTWAY CORPORATION K3644 12 99
Download Pdf Manuals
Related Search