User Manual
Contents
1. 110V unit ONLY Plug unit into grounded 110V A C outlet 7 NOTE 220V unit ONLY Plug unit into grounded 220V A C outlet 8 Turn master power switch located on the side of the unit on 9 Press the Autofirm button for quick inflation 10 Place the patient on the bed after inflation to insure the air cells do not become twisted or kinked 11 To get the control unit out of Autofirm mode press Autofirm button again 12 Static Mode a Press the Mode button until the Static option light comes on b Set the desired comfort level with the Soft Firm buttons 13 Alternating Mode a Press the Mode button until the Alternate option light comes on b Set the desired cycle time with Cycle Time buttons 3 20 minutes c Set the desired comfort level with the Soft Firm buttons 14 Fowler Mode a When elevating the head section of the mattress press the Fowler button to increase airflow for seat inflation 15 Auto Fowler attachment Optional a When elevating the head section of the mattress Fowler mode will automatically turn on This is where the Auto Fowler attachment connects to the control unit 16 Lock out Feature a After 3 minutes if there are no changes to the blower settings the lockout feature will activate b Press and hold the Lock out button for 3 seconds to disengage the lock out feature 17 For quick deflation or for CPR use a Turn power off b Twist CPR plug on the mattress to open c Rem2. Y MOBILITY Baros Sapphire Mattress User Instructions Maximum User Weight 70st 450kg Tel 01279 425648 Fax 01279 425653 Email salese1stcallmobility co uk www 1stcallmobility co uk General Warnings and Precautions WARNING DO NOT use this device if the power cord is cut frayed or loosely connected to the device WARNING 110V unit Electrically Powered Mechanism Electrical Hazard may occur if device is plugged into inadequate electrical outlet To avoid electrical shock hazard make sure unit is plugged into a grounded A C 110V outlet WARNING 220V unit Electrically Powered Mechanism Electrical Hazard may occur if device is plugged into inadequate electrical outlet To avoid electrical shock hazard make sure unit is plugged into a grounded A C 220V outlet WARNING DO NOT remove cover Refer servicing to qualified service personnel Disconnect power supply before servicing or cleaning WARNING Be sure to secure mattress to the bed frame with the straps provided Failure to do so could result in personal injury or equipment damage CAUTIONS CAUTION Overheating may cause equipment damage or failure Monitor the unit to ensure that it functions in the proper operating temperature CAUTION Keep out of direct sunlight CAUTION DO NOT store in temperatures below 0 F 18 C or above 95 F 35 C CAUTION DO NOT expose to moisture or areas of humidity greater than 95 CAUTION Ensure that strap placement does
3. not interfere with the operation of the bed functions CAUTION Medical Electrical Equipment needs special precautions regarding EMC and needs to be installed and put into service according to the EMC information provided in this manual Portable and mobile RF communications equipment can affect Medical Electrical Equipment The use of Accessories transducers and cables other than those specified by the manufacturer may result in increased emissions or decreased immunity of the equipment or system The equipment or system should not be used adjacent to or stacked with other equipment and that if adjacent or stacked use is necessary the equipment or system should be observed to verify normal operation in the configuration in which it will be used CAUTION DO NOT use around an open flame Operating Instructions 1 Remove standard mattress from the bed 2 Replace standard mattress with the SAPPHIRE SERIES 1100 or 1100EC mattress Be sure air tubing is at the foot end of the bed 3 Strap air support mattress to bed frame on all four sides 4 Place control unit on the footboard of the bed using the two retractable hooks located on the back of the unit If no footboard is available put blower on the floor away from traffic To avoid blocking the air intake DO NOT place control unit on its back 5 Attach the air tubing to the blower unit being sure it snaps in tight Be sure air tubing is not kinked and is unobstructed 6 NOTE
4. conjunction with our Baros Acute Extendable Bed Depth 9 23cm Product Weight 11 9kg Pump Weight 6 1kg Maximum User Weight 70st 450kg
5. ove the hoses from the control unit Notice The mattress is equipped with a 2 inch foam pad in the mattress base for patient support and transport Keypad Quick Reference TIME REMAINING elelele E LOCKOUT 6 O MINUTES Q e LOW PRESSURE SOFT A ALARM SILENCE POWER FAILURE LEVELS 1100 EC 10000 BARIATRIC CYCLE TIME ww gt TIME REMAINING s a a o LOCKOUT MINUTES CA e LOW PRESSURE SOFT eo POWER FAILURE Lockout Alarm Silence Locks all functions Mutes the audible alarm automatically after 3 mins To Visual light will not turn off disable press and hold lockout until failure is resolved button for 3 sec ALARM Firm SILENCE Increases airflow for a firmer setting Soft Decreases airflow for a softer setting Autofirm Quickly inflates mattress to maximum firmness Fowler Used when head section of bed is elevated Increases airflow to the mattress AUTOFIRM CYCLE TIME Cycle Time Mode TIME REMAINING Increases or decrease the Press the MODE button to switch between Alternate and Static modes time of cycle between 3 to 20 minutes a MINUTES Refer to this page as needed for quick reference to the control panel functions Provides individual button illustration and function description Mattress Cleaning Instructions WARNING and CAUTION A It is recommended that gloves and protective clothing be wo
6. rn at all times during i cleaning and disinfecting h B Hypercarbonate and phenol based solutions should not be used During Operation For normal soil wipe down cover and interior sacs with a standard cleaning disinfectant and wipe off excess moisture with a towel Laundering Mattress 1 Disconnect the power from the Control Unit and deflate the interior sacs 2 Disassemble cover interior sacs connecting hoses and base Place them in different launder ing baskets 3 The interior sacs must be hand cleaned only DO NOT place in sterilization room or chamber Use a spray disinfectant to wipe down interior sacs Air dry sacs DO NOT expose to heat 4 Spray disinfectants and wipe down foam cover 5 Place cover and base ONLY in washing machine 6 Use standard hospital disinfectant detergent 7 Set washing cycles as recommended below Regular Cycle a Pre soak with disinfectant detergent with diluted bleach in cold water 10 minutes b Main wash for 15 minutes Time depending on soil level c Rinse Cycle 5 minutes minimum d Spin Drain Cycle 5 minutes minimum e Air dry or place in dryer at very low or no heat 8 After the cover interior sacs and base are dry store them in a sterilized bag and seal for next use NOTICE DO NOT use water temperatures greater than 150 F 65 C Blower Unit Cleaning Instructions WARNING and CAUTION A Hand clean only DO NOT place in sterilization room or chamber B It i
7. s recommended that gloves and protective clothing be worn at all times during cleaning and disinfecting C Hypercarbonate and phenol based solutions should not be used D Make sure unit is turned off and unplugged before cleaning AN For normal soil wipe down with a standard cleaning spray and wipe off excess moisture with a towel Spray with a disinfectant and let it stand for a few minutes before wiping down Check corners and creases for soil build up Look to see if any external parts are damaged or need replacing such as hooks foot pads and filter Replacement parts can be issued Contact your representative for servicing NOTE To keep your equipment working efficiently and effectively for an extended time period it is Maintenance 4 Air Filter The foam air filter on the back of the Control Unit must be cleaned weekly with soap and warm water Replacement of the foam filter is recommended every 6 months Instructions relating to the inflation of extension arms Within the sleeve A that contains the hose tubes are 2 additional tubes that operate the width expandable air cells as indicated in picture 1 To inflate one or either side you will need to connect these tubes as indicated in picture 2 To deflate extension arm s depress the grey button B and pull apart Picture 1 Picture 2 Technical Specification Mattress available with inflatable wings to 48 120cm amp can be used in
Download Pdf Manuals
Related Search