Installation Instruction Maxima Fog Lamps.4-1-2010
Contents
1. GENUINE PARTS INSTALLATION INSTRUCTIONS 1 DESCRIPTION Fog Lamp Kit 2 APPLICATION Maxima 2010 3 PART NUMBER 999F1 MVOOO Sedan w Auto Headlamps 999F1 MVOO1 Sedan w out Auto Headlamps 4 KIT CONTENTS Item QTY Description Application Service Part Number Combi Sw w Auto Headlamps Combi Sw w o Auto Headlamps B 1 Sedan RH foglamp assembly Sedan LH foglamp assembly N N TOOLS REQUIRED e Flat tip screwdriver e Ratchet e 10mm socket e Phillips screwdriver e Socket extension e Torque Bit e 10mm wrench e Optional 10mm ratcheting box wrench PRE INSTALLATION CAUTIONS NOTES e Dealer Installation Recommended Instructions refer to Service Manual 999F1 MVOO1II A REV Page 1 of 5 DTH 03 31 2010 INSTALLATION INSTRUCTIONS Fog Lamp Kit 7 INSTALLATION PROCEDURE Philips O Hga Philips Screws 1 Remove engine under cover a Use care when removing the retaining clips B and bolts A Fig 1 and Fig 2 Note There may be clips at positions A instead of bolts 2 LH RH Remove fog lamp covers Fig 3 a Use a Philips screwdriver to let loose the front of the LH RH wheel wells b Lower the front wheel well to get better access to the fog lamp area c Remove the 10mm bolt from each side re use screws 3 Locate and untape the fog lamp wiring harness connections Driver s side Fig 4 Tech Note Driver s side connector is near the horn 999F1 MVOOL1I2. I A REV Page 2 of 5 DTH 03 31 2010 INSTALLATION INSTRUCTIONS Fog Lamp Kit 4 Locate and untape the fog lamp wiring harness connectors passenger s side Fig 5 Tech Note Passenger s side connector is located near the washer fluid reservoir 5 LH RH Install fog lamp provided with kit a Separate the fog lamp from the housing by removing 2 Torque screws b Using a 10mm wrench install 2 bolts through the bracket to the fascia One on the side and one on top c Place the fog lamp in the housing and secure it with the 2 Torque screws removed earlier d Do this for both sides 6 Finish install a Connect the wire harness to each fog light by pressing the connector into the back of each lamp b Install engine under cover and retaining clips B and 10mm bolts A Fig 7 and Fig 8 c Secure the front of each wheel well Note Fasteners at location s A maybe push in clips similar to B 999F1 MVOO1II A REV Page 3 of 5 DTH 03 31 2010 INSTALLATION INSTRUCTIONS Fog Lamp Kit 7 Unlock steering wheel 8 Disconnect the negative battery cable then wait at least 3 minutes A CAUTION e Before servicing disconnect both battery terminals and wait at least 3 minutes e Do not use air tools or electric tools for servicing e After the work is completed make sure no system malfunction is detected by air bag warning lamp e In case a malfunction is detected by the air bag warning la
3. fy both headlamp and fog lamps turn off Verify turn signal wiper washer and high beam functionality 999F1 MVOO1II A REV Page 50f 5 DTH 03 31 2010
4. mp reset with the self diagnosis function and delete the memory with CONSULT III e If a malfunction is still detected after the above operation perform self diagnosis to repair malfunctions Refer to Service Manual 9 Remove upper steering column cover a Rotate steering wheel counterclockwise to access LH screw A and remove Fig 9 10 Rotate steering wheel clockwise to access RH screw A and remove Fig 10 11 Remove lower steering column cover screw B located under the steering column and remove upper and lower cover Fig 11 999F1 MVOO1II A REV Page 4 of 5 DTH 03 31 2010 INSTALLATION INSTRUCTIONS Fog Lamp Kit 12 Remove 2 screws from the combination Switch and pull upwards for electrical connection Disconnect electrical connector from combination switch by prying release tab and pulling up on the combination Switch Fig 12 13 Remove combination switch by lifting up and out of steering column 14 Install kit supplied combination switch using original mounting screws and reconnect wiring Connector should Click 15 Install the steering column upper and lower covers using the original screws 16 Check all screws are in place and secure 17 Connect the negative battery cable FUNCTIONALITY TEST PROCEDURE Turn ignition switch ON Turn headlamp and fog lamp switches ON Verify headlamps and fog lamps are illuminated Turn headlamp switch OFF leaving fog lamp switch ON Veri
Download Pdf Manuals
Related Search