L42A I-I Rev (3) (2009.11.02)
Contents
1. GENUINE PARTS iPod INSTALLATION INSTRUCTIONS 1 DESCRIPTION iPod Interface 2 PART NUMBERS iPod Gateway Module Kit 999U7 ST002 N Bus harness for iPod Gateway 999U7 VTO0O N Bus harness for SAT with factory SAT only 999U7 VTOO1 3 MODEL APPLICATION Altima with CD1 audio system only 2010 4 iPod GATEWAY MODULE KIT CONTENTS 999U7 ST002 No Parts B Cabletie s 12 C Cabletie 15 6 D Double SidedTape 1 _E FoamTape Quick Reference Card 1 Parts View 5 PRE INSTALLATION CAUTIONS NOTES N CAUTION Dealer installation recommended This installation instruction will reference the service manual Cut the excess cable tie s as flush with the head as possible Face head of cable tie away from sheet metal and other objects Use caution when removing re installing interior components to avoid damage scratches or breaking of mounting clips This is a universal installation kit so all parts may not be used Refer to the vehicle specific SAT radio Installation Instructions on ASIST NET for further information Ensure the Owners Manual and Quick Reference Card are placed in the customers glove box Check the customer s iPod to make sure it has the most current software version before starting the install www apple com ipod In the event the iPod system needs to be ser2. position module between these points 6 Before mounting permanently connect the iPod cable and ensure clearance of the rising metal feature near the mounting location Fig 17 amp 18 7 Module should fit in low flat area between the rising metal feature to the front and rear Fig 17 amp 18 NOTE The module may need to be positioned to the right of center to have the clearance Fig D 8 11 999U7 UU100Il 3 11 2 09 P y 4 __ ay pay ye le 8 Confirm the mounting location then remove the tape liner and put the module into place on the sheet metal Fig 19 amp 20 9 Apply equal pressure to the module for at least 20 seconds After attaching to metal frame let the module sit for 5 minutes to ensure good adhesion before applying any shear pressure 10 Connect the pre threaded cable ties to the cable ties routed under the sheet metal Fig 19 amp 20 11 Tighten cable ties down Front of Vehicle ie 12 Connect the routed cables harnesses to the connectors on the iPod module NOTE When re installing the glove box any slack needs to be pulled out When putting the glove box in place pull the cable from the inside of the glove box 9 11 999U7 UU100Il 3 11 2 09 14 OPERATION CHECK E 1 Connect the battery negative terminal E 2 Turn vehicle ignition switch to the ACC position E 3 Reference the vehicle specific Satellite Radio Installation Instructions for further information
3. Take the ground cable tear taped to the N bus harness and route towards the RH side of the head unit cavity 7 Using a 10mm socket remove the nut on the ground point below the steering member assembly Attach eyelet connector and tighten nut Fig 9 SE I Fig 9 8 Secure ground cable to the harnesses with one 1 I cable tie Fig 9 9 Secure harnesses with one 1 cable tie in between the first cable tie and foam tape Fig 8 10 Connect both of the iPod gateway harness connectors to the head unit Place head unit back into place foam tape Ik cable tie al Hi Nieo 5 11 999U7 UU100Il 3 11 2 09 11 Route harnesses down and towards the front of the vehicle Fig 10 12 Route to the right of the duct near floor 13 Continue routing to front of vehicle under instrument panel to module mounting location Fig 10 cable tie 14 Allowing enough slack to make the connection bundle the harnesses and secure with one 1 cable tie Fig 10 NOTE The drain hose can be removed to assist routing the harnesses 6 11 999U7 UU100Il 3 11 2 09 12 CABLE ROUTING iPOD CABLE 1 Drill a 1 8 pilot hole on the LH side of the glove box 30mm 2mm 1 2in from the back edge and 20mm 2mm 0 75in from the bottom edge of the box Open up the hole to 11 16 Fig 11 amp 12 2 Mark the iPod cable 970mm 25mm 38 2in 1in from the iPod connector rectangular connector with electrical tap
4. If Satellite radio was part of installation turn radio on then select satellite radio mode Acquiring Sirius or Loading XM will display for a while If not move vehicle to outside and try again 4 If Satellite radio was part of installation tune to preview channel XM channel 1 Sirius channel 184 to make sure receiving preview channel correctly For Sirius tuner installations the preview channel may not be accessible For further information reference the Operation Check section of the vehicle specific Satellite Radio Installation Instructions E 5 Confirm proper audio operation AM FM SAT TAPE CD 6 If no iPod is present the head unit display should show NO IPOD If an iPod is connected to the system a check mark should be displayed on the iPod screen and audio should start playing in 5 20 seconds E 7 A full diagnostic tree is available on the next page for troubleshooting the system 15 REINSTALLATION OF REMOVED PARTS E 1 Re install all removed vehicle parts referring to the service manual for the vehicle N CAUTION Use caution when re installing interior components to avoid damage scratches or breaking of mounting clips Refer to the vehicle specific service manual for more information E 2 Clean interior of vehicle 16 FINAL INSPECTION E 1 Inspect the vehicle interior and exterior for damage E 2 Confirm proper operation of vehicle systems E 3 Reset radio presets to the recorded setti
5. e 3 Start routing iPod cable from inside of glove box with DIN barrel shaped connector end Route out of glove box through the drilled hole Fig 12 4 Place split grommet over wire and feed into drilled hole in glove box A PGF stick or other plastic prying tool may be helpful Fig 12 Fig 13 5 From the module end DIN connector route iPod cable slightly towards the rear of the vehicle Then route up to the above ducts Continue to route towards the front of vehicle under microfilter opening Fig 13 6 Secure cable with two 2 foam tapes Fig 13 7 Route cable up to small plastic beam and secure on tape mark with one 1 cable tie Fig 14 7 11 999U7 UU100Il 3 11 2 09 13 iPOD GATEWAY MOUNTING 1 Clean the bottom of the module and mounting location with provided alcohol wipe 2 Cut the double sided tape into three equal pieces 3 Stack two 2 pieces of double sided tape on the connector end on the bottom of the module Place the other piece on the opposite end on the bottom Fig 15 4 Thread the two 2 large cable ties through the holes in the chassis from right to left label facing up Ensure that the cable ties are not pulled through completely Leave about 2 5 3 inches 63 5mm 76 2mm of slack on the right side Fig 16 5 Route two 2 large cable ties from left to right under the metal structure along the carpeted area in the front most part of the cabin Fig 17 o gt r a
6. issan Satellite Radio Diagnostic Information Cycle Ignition Reboot iPod Press amp Hold center button amp Menu button simultaneously until Apple Screen appears Call TECH LINE for further diagnosis Disconnect Does iPod have check us screen Pod 24 Zz OK to disconnect Is music playing from iPod NOTE When the iPod battery is very low it is possible that the system will not be able to charge it The system may not work at all in this case If this occurs please try to charge your iPod using the iPod power adapter No further diagnosis needed 11 11 999U7 UU100Il 3 11 2 09
7. ngs E 4 If equipped verify proper sunroof operation and perform the reset procedure if necessary Refer to Service Manual requirements E 5 Place the Owners Manual and Quick Reference Card in the glove box E 6 Check the trim for a proper flush fit after re installing the interior components 10 11 999U7 UU100Il 3 11 2 09 NISSAN IPOD INTERFACE DIAGNOSTIC FLOW CHART 1 Verify iPod module is installed by looking in glove box for iPod cable 2 Confirm the audio system is otherwise OK AM FM CD works normally Can SAT be selected on the audio system Push the SAT button if present If no SAT button push Radio NO SAT is shown on the audio display Is an iPod connected NO After pushing Radio display says YES AM FM AM Update iPod Check software to the Is music playing from iPod connections to latest version Connections Okay iPod amp SAT NO YES modules NO YES Does iPod have check No further mark screen oe Connections Okay NO OK to disconnect Fix Disconnect amp reconnect iPod Replace iPod Does iPod have check module mark screen iPod Z Is music ae Reconnect ae iPod iPod OK to disconnect NO YES No further Is music diagnosis playing from needed Pou iPod sofware latest version See apple com ipod Does radio show RADIO ID gt NO POD Check connections to iPod amp SAT modules See service bulletin for N
8. ual a RH Instrument Side Mask b RH Front Kicking Plate c RH Dash Side Lower Finisher d RH Console Side Finisher clip points 1 Metal Clip f A iia m Clip 3 11 999U7 UU100Il 3 11 2 09 10 TRIM REMOVAL 1 Add masking tape outside the edges of the center ventilator grills Fig 3 2 Remove center vent grills with PGF stick starting at the lower corners and work up Fig 4 3 Remove the head unit bracket from the frame Fig 5 4 Remove cluster lid D to expose the screws Fig 6 5 Unscrew remain fasteners securing head unit 6 Remove head unit Disconnect all harnesses from head unit and heater controls 4 11 999U7 UU100Il 3 11 2 09 11 CABLE ROUTING iPOD GATEWAY amp SATELLITE RADIO 1 Attach connector of iPod gateway harness to the main i I harness Fig 7 cable tie i l 2 Attach the connector of the satellite radio harness to the N Bus behind the head unit Fig 7 df 3 Secure harnesses to existing harness with one 1 cable tie Before cinching pull the harnesses even with the shortest existing audio harnesses Fig 7 aT Front of Vehicle i cable tie outside of picture 4 Wrap one 1 piece of foam tape around the connectors of the satellite radio harness and pre wired N Bus Fig 7 5 Secure harnesses to the plastic wall at the RH side of the head unit cavity with one 1 piece of foam tape and route to floor Fig 8 amp 9 6
9. viced order the iPod Service Kit below iPod Gateway Service Kit 999U7 VSOO2SP 999U7 UU100Il 3 11 2 09 TOOLS amp MATERIALS REQUIRED Oo Phillips screwdriver 2 Electrical tape Masking Tape Drill 1 8 11 16 drill bits a a CRITICAL INSTALLATION STEPS J 1 4 driver w 10mm socket Plastic Pry bar PGF Stick Diagonal Cutter 1 Ensure the installed harnesses are pulled even with the shortest existing audio harnesses 9 The iPod module placement is important to avoid clearance problems It needs to be installed to the right of center of the rising metal feature 3 The iPod cable routing needs to be followed as described to avoid interferences 8 INSTALLATION OUTLINE iPod Gateway Module Vehicle Front 999U7 VTO00 l l l 1 l l l l Head Unit iPod cable SAT Pre wired N Bus Fig 1 harness Trunk iPod glove box 999U7 VT001 with factory SAT Satellite Radio Tuner Trunk factory installed 2 11 999U7 UU100Il 3 11 2 09 9 VEHICLE PREPARATION 1 Apply parking brake 2 Record the customer radio presets Preset 1 2 3 4 5 6 7 3 Make sure that the shift lever is engaged in the P position 4 Turn the ignition switch OFF 5 Open engine hood 6 Disconnect the battery negative terminal to prevent short circuits during installation 7 Remove the following interior parts as shown in Fig 2 Refer to vehicle service man
Download Pdf Manuals
Related Search