minfrs1 maxi - Neopost Technologies Ltd
Contents
1. 100 140 Franker Link Unit SECTION 1 Operation and Service Adjustments 100 140 Franker Link Unit Service Manual i i 100 140 Franker Link Unit 1 1 Preventative Maintenance Preventative maintenance is limited to examination at service intervals of the conveyor belt and eject wheel tyres for wear or damage Refer to section 1 2 below for details on replacement of either component Also check to ensure that the condition of the mains leads and connectors is sound and undamaged Check that the warning labels are visible these are located on both sides of the unit Exercise caution with moving parts and exposed electrical apparatus when covers are removed Remove power lead from mains supply before performing any maintenance functions 1 2 Service Operations 1 2 1 Replacement of Conveyor Belt 1 Cut the belt and remove it 2 Remove the top plate 6 x Csk head screws 3 Remove the C clips at the stepped end of both shafts and slide the shafts towards the T bearings Slip the new belt over the other ends of the shafts and replace the shafts and C clips 4 Slide the top plate under the belt and back into place Replace the screws 1 2 2 Replacement of Pivot Wheel Tyres If the pivot wheel tyre requires replacement due to wear or damage these can easily be replaced by prising off the old items and fitting the new ones They should not be glued in place 1 2 100 140 Franker Link Unit Service Manual 1002. 12 x 12 PL OILITE 90XL BELT FOLD ROLLER SPRING 3 8 T BEARING CONVEYOR BELT O RING No 329 FUSE 20mm 5A ANTI SURGE ANe ANEH 100 140 Franker Link Unit Service Manual
3. 140 Franker Link Unit 1 2 3 Replacement of Drive Belt The unit is driven via a toothed XL drive belt from the motor If this requires replacement proceed as follows referring to Fig 1 below Drive belt C clip Base plate nuts NI el Ep I Tel Fig 1 Remove the top plate by sliding it out under the conveyor belt after removing the 6 x Csk head screws Slacken the 4 screws retaining the motor base plate to the chassis and slide the plate to release tension from the belt Removethe C clip next to the T bearing at the stepped end of the shaft and slide the shaft into the bearing until the bearing at the other end can be re moved slide the shaft back to free the stepped end of the shaft and remove the belt Fit the new belt in its place and re assemble the shaft in reverse order to the above Tension the belt by sliding the motor base plate and tightening the nuts The belt should be tensioned so there is minimal slack 100 140 Franker Link Unit Service Manual 1 3 100 140 Franker Link Unit 1 3 1 4 Recommended Spares Part No E1038A F5000A G1026A G4035A G5024A EO061A 135 105UL Description Qty 8 x
Download Pdf Manuals
Related Search