Read More - Racine Railroad
Contents
1. 1 Pin and Cotter Pin 5 Turn the battery Master Switch ON start the engine close the Hydraulic Bypass Valve raise the Workhead to the full UP position and reinstall the Workhead Safety Chains if applicable c Manual changes to reference a 1 Page 53 713016 Workhead Outside View a Change item 24 from 712342 to 712435 Distribution Anchor Remover Owners Operators RRP Service Technicians RRP Engineering Department RRP Sales Representatives2. New 712435 ye weight Bo r The new part number change is not reflected in all printings of the service manual so old lifting plates have been installed on workheads in the field Overtime the old 1 2 thick lifting plates bend and or crack in service and should be replaced with 1 thick lifting plates Keep the shim washers between the lifting plate and workhead and reuse the nuts bolts and washers RRP Service Bulletin 203 Rev 00 7SEP00 Subj ANCHOR REMOVER WORKHEAD LIFTING PLATE Page 2 of 2 6 Procedures Warning Ensure that all safety devices are installed and that lock out tag out and or other appropriate safety procedures are complied with before working on the machine a Required Tools 1 Wrench 3 4 Ratchet 1 Wrench 3 4 Combination 1 Pliers Long Nose 1 Hammer Ball Peen b Procedures 1 Turn the battery Master Switch ON start the engine close the Hydraulic Bypass Valve and lower the Workhead until it is either suspended in the Safety Chains or rests on the rail 2 Remove a Cotter Pin and the 1 Pin to disconnect the Lifting Plate from the Head Lift Cylinder 3 Remove the Lifting Plate 712342 1 2 thick and replace it with Lifting Plate 712435 1 thick Note Keep the Shim Spacers Item 27 P N 389675 between the Lifting Plate and Workhead and reuse the 1 2 13 x 2 5 bolts washers and locknuts 4 Connect the Lifting Plate to the Head Lift Cylinder and reinstall the
3. Racine Railroad Products 1524 Frederick Street Racine WI 53404 262 637 9681 Service Bulletin RRP Service Bulletin No 203 Revision 00 7 SEP 00 Subj ANCHOR REMOVER WORKHEAD LIFTING PLATES Ref a Anchor Remover Parts and Operating Manual RRP P N 910507 M 1 Purpose To provide supplemental information for maintenance personnel and machine Operators about a printing error in existing Service Manuals for Racine Railroad Products ANCHOR REMOVERS 2 Cancellation Not Applicable for Initial Release 3 Scope This Bulletin applies to all Racine Railroad Products ANCHOR REMOVER rail anchor remover machines 4 Definitions a Warning An operating procedure practice or condition etc which may result in injury or death if not carefully observed or followed b Caution An operating procedure practice or condition etc which may result in damage to equipment if not carefully observed or followed c Note An essential operating procedure practice or condition etc 5 Discussion Over the years the Anchor Remover Workhead RRP P N 713016 has been revised to improve reliability and strength One of these changes was to increase the material thickness of the lifting plate The old Po 3 lifting plate RRP P N 712342 used 1 2 thick ER aae Workhead material and the current one RRP P N 712435 Boge g iting Pate uses 1 material to accommodate increased SL Suet Old 712342 Toss i gx Gj 3
Download Pdf Manuals
Related Search