AB015: Smog Block Off Plates
Contents
1. AB015 Smog Block Off Plates 2014YAMAHA FZ 09 PARTS LIST 1 2 3 4 5 6 Small Smog Block Off Plate 1 Square Smog Block Off Plate 1 Air Box Cap 1 www GRAVESPORT com Toll Free 800 867 6480 YAMAHA SERVICE MANUAL Remove the seat Push the 4 pop rivets on the upper fuel tank cover and remove Remove 1 rear Allen bolts and 2 pop rivets on the inside of the front air scoop covers Do not remove the two Allen bolts on the front screen Pull the cover strait towards you till the pin has come free from the rubber bushing PHOTO 1 then giggle forward till free Repeat for both sides Peel the rubber guard away from the tank on both sides The guards may remain attached to the inner air Scoop cover To remove the tank remove the 4 Allen bolts securing the tank 2 on the sides and 2 securing the back Do not need to remove any hex head bolts Disconnect the fuel line breather hose fuel pump coupler and drain hose before complete removal from bike Remove the air box a First unplugging both plugs to the ECU b Remove the air box breather tube on the left of the air box This tube will not be re installed this will be the location of the provided air box cap PHOTO 2 C 7629 Densmore Avenue Van Nuys Ca 91406 Fax 818 902 3821 Loosen the three throttle body boot clamps PHOTO 3 Ps NOTE Recommend using a long 4mm ball end Allen socket d Remov2. e the air box by removing the Allen bolts on each side and the front of the air box securing it to the motorcycle There is no need to open the air box to remove Disconnect the air box vent line The purchaser releases Graves Motorsports Inc from all liabilities pertaining to the installation and use of purchased parts Purchaser recognizes that any alteration and or modifications to the vehicle may increase the risk of injury or accident This product is intended for Closed Course Competition Use Only and may render the vehicle illegal for use on public roads 7 Locate the smog pump and remove the blue plug as well as all the hose clamps from the smog pump PHOTO 4 Remove the smog pump 8 Remove the bolt holding the horn to its mounting bracket Carefully let the horn hang 9 Remove the upper left radiator mount bolt and slide the radiator to the right till it is free and push it forward slightly Leave all other hoses and bolts intact 10 Remove the bolts from the smog port covers PHOTO 5 The bolts have Loctite and will be very tight v Bs et i z SMOG PORT COVERS r aar A NOTE Recommend using a short 5mm ball end Allen wrench or a short stubby socket Allen to remove the bolts The bolts are long with plenty of thread so take your time while removing them Toll Free 800 867 6480 www GRAVESPORT com ee ey see Van Nuys Ca 91406 Fax 818 902 3821 11 Install the smog block off p
3. lates included in the kit smaller plate on the left and larger plate on the right PHOTO 6 Both should have the G top towards the radiator Use the stock bolts to install the smog block off plates It is recommend applying blue Loctite to lt PHOTO 6 a 12 Install the air box cap on the left side of the air box covering the outlet PHOTO 7 Be sure to secure the cap with a zip tie or safety wire 13 Reinstall all parts in reverse order of removal See service manual for torque specifications The purchaser releases Graves Motorsports Inc from all liabilities pertaining to the installation and use of purchased parts Purchaser recognizes that any alteration and or modifications to the vehicle may increase the risk of injury or accident This product is intended for Closed Course Competition Use Only and may render the vehicle illegal for use on public roads
Download Pdf Manuals
Related Search