1 TOOLS NEEDED PRECAUTIONS ATTENTION EN: CIGARETTE
Contents
1. 4 Oki faa d beaa O Sx eas s Install cigarette lighter as shown e Re install the removed parts e Reconnect the battery e Shift the selector lever into P from N2. SUBARU EN CIGARETTE LIGHTER KIT Installation Instruction FORESTER PART No H6710SG000 EN COMPONENTS a TOOLS NEEDED PRECAUTIONS e Please refer to the precautions below before you begin work in order to install the product safely and accurately Please also refer to the vehicle Service manual e This manual shows typical installation procedures on RHD vehicle Installation will be mirror image for LHD vehicles AN ATTENTION e Please disconnect the battery cable while conducting wiring operations Failure to do so may result in electrical shock or injury e Please confirm that the electrical components of the vehicle operate normally Also please make an note of data in the memory of the electrical components such as the radio This will help avoid problems that may arise when performing the repair check after the installation When tightening bolts or screws use the proper tools and the proper size and comply for the specified torque specified for the part Failure to securely tighten the bolt and nut may cause them to loosen and fall off causing damage e When removing the connector from the vehicle remember to remove the lock that holds the main body of the connector instead of pulling the lead line This protects against a lead wire cuts etc e Please be sure to properly connect the connector and terminal This helps to avoid a poor connection e When wiring the harness wiring clamp the wires t
3. ogether along with the wiring harness of the vehicle This protects the harness from becoming entangled or causing strange sounds e When connecting or disconnecting parts or installing or removing the finisher etc be careful not to let the harness be hooked or pulled from the back This protects against a cut wire or shorts Be careful not to forcefully pull the wiring harness of the vehicle This helps prevent the connector from being disconnected and the wires from being cut or damaged After installing the wiring perform an operations check on the newly installed parts before reassembling This helps prevent mis wiring BEFORE BEGINNING INSTALLATION 1 Apply parking brake firmly and shift the selector lever into N range 2 Disconnect the battery negative cable MOUNTING THE CIGARETTE LIGHTER REPLACING WITH ACCESSORY SOCKET 1 Removing assocoated parts A Wrap the screwdriver with vinyl tape to avoid scratching the trim panels If connector is connected to the switch behind the cover disconnect it ere O a CA opt a L lA o_O j v i z ee Va re Cy Ss Hes Pisa 3 vo aoe Ue tL aw For manual air conditioner specifications A K 7 OAK Remove driver side control cable Re O Remove Pull to remove glove box Remove passenger side control cable Common specification for manual and automatic air conditioner a aX i oN ais eac a oN oN
Download Pdf Manuals
Related Search