Wheel Center Cover Kit Instruction Sheet
Contents
1. avidson Parts amp Accessories are made of plastics and metals which can be recycled NOTE Any time a rear wheel is removed and installed the lug nut torque must be checked within 500 1000 mi 805 1610 km 7 Using the palm of your hand press the new wheel center cover into the center hole of the wheel until it seats and latches to the wheel 8 Repeat Steps 4 7 for the opposite wheel 9 Lower the motorcycle and remove the support 10 Connect battery negative cable Tighten screw following the instructions in the service manual WARNING After installing seat pull upward on seat to be sure it is locked in position While riding a loose seat can shift causing loss of control which could result in death or serious injury 00070b 11 Install seat is05876 Lug nuts 4 Lockscrew Washer Center cap assembly Tire and wheel assembly ST uN Figure 1 Removing Tire and Wheel Assembly 1 of 1 Please dispose of materials responsibly2. cMOTOR HARLEY DAVIDSON WY J04736 INSTRUCTIONS REV 2010 04 23 WHEEL CENTER COVER KIT GENERAL Kit Numbers 83841 09 40900044 Models For model fitment information see the P amp A Retail Catalog or the Parts and Accessories section of www harley davidson com English only Kit Contents There are no Service Parts available with this kit Additional Parts Required NOTE This instruction sheet references service manual information A service manual for your model motorcycle is required for this installation and is available from a Harley Davidson dealer INSTALLATION 1 Remove the seat WARNING To prevent accidental vehicle start up which could cause death or serious injury disconnect negative battery cable before proceeding 00048a 2 Refer to the service manual and disconnect the battery negative cable first 3 Refer to the service manual Raise and support the motorcycle with the rear wheels lifted off the floor 4 Refer to the service manual See Figure 1 Remove the lug nuts 1 and the tire and wheel assembly 5 from the motorcycle 5 Remove the lockscrew 2 and washer 3 from the center cap 4 assembly Discard lockscrew washer and center cap assembly 6 Install the tire and wheel assembly with the lug nuts fol lowing the instructions in the service manual Tighten lug nuts in a crosswise pattern to 90 100 ft lbs 122 0 135 6 Nm J04736 Many Harley D
Download Pdf Manuals
Related Search