PRIDE DX-300 Service Manual
Contents
1. PRIDE DX 300 Service Manual RID ELECTRONICS OSES DX 300 RECEIVE ON 4 wW HIGH OPERATE ANDBY POWER ST Amp Series Copyright 2004 CBTricks com Version 1 0 Be sure to stop by the CBTricks web site and check it out http www cbtricks com A WORD OF THANKS TO THE FOLLOWING PEOPLE FOR HELPING WITH THIS MANUAL Chris Reifsteck Nomad Radio Joe Piatt and N Channel Safety Instructions READ FIRST BEFORE SERVICING THIS AMPLIFIER Lethally high voltages are present inside the amplifier unit Never remove either top or bottom cover when power line is connected DO NOT attempt to operate unit when covers are removed 1 Lethal voltages would be open to contact 2 Protective interlock on top cover will short circuit the high voltage power supply attempting to operate under these conditions can cause damage to power supply amplifier tube or both 3 Attempting to operate the unit with bottom cover removed causes loss of air pressure to the tube and can cause rapid failure of the tube 4 Attempting to operate the unit with top cover removed with the interlock blocked may make the amplifier erratic in tuning and performance due to the high level of R F on the top chassis coupling to the coaxial input cable at the rear of the chassis If repairs should be necessary contact the factory or a repair facility with proper equipment and technical experience for the servicing of2. high power amplifiers If covers need be removed allow two minutes after turning the unit off and unplugging the line cord before removing covers Disclaimer Although the greatest care has been taken while compiling these documents we cannot guarantee that the information is 100 correct with that said we do feel that this is the most accurate information out there The publisher assumes no liability for damages resulting from errors or omissions or the violation of any law from use of this information This also covers unsuccessful attempts to repair the equipment covered in this manual The service and modification information shown here are provided for properly licensed operators only The user is solely responsible for making sure that any modifications made to the unit must meet all Federal and State Regulations for the Country of use Liability of damages to any equipment is the sole responsibility of the user Modifications are provided for information educational purposes only Copyright 2004 CBTricks com Bennie Bolin All rights reserved No part of this publication may be reproduced stored in a retrieval system or transmitted in any form or by any means electronic mechanical photocopying or otherwise without the prior written permission of the copyright holder CBTricks com All logos and Brand Names are the property of their respective owners http www cbtricks com
Download Pdf Manuals
Related Search