取扱説明書
Contents
1. Nb EF 2 PT a ree iin rear WS U 42. VSWR 350 0022 445 1 TEL 0492 30 1220 Printed in Japan SUPER GAINER Foldover Rooftop Rail Mount Bracket K550 Operation Instructions Confirm required parts Bracket Rubber seal Lock nut dh Protection cap holder Protection rubber cap Right angled hexagonal wrench Pipe bracket Fastening belt with a U bolt P
3. 4 L L L L L
4. Nakadori Kawagoe Saitama 350 0022 Japan Printed in Japan SUPER GAINER K550 U a 8 mm DIAMHOND ANTENNA SUPER GAINER
5. Attach the bracket to U bolts at both end of the belt and 2 After loosening the bolt hit the top of the wrench then attach nuts and washers to four bolt ends lightly Hitting the wrench lightly will unlock the bolt and make it free to change installtion angle Then adjust the bracket to make it vertical to road surface To push lock nut at the oposite end will lock the bolt again And hitting the bolt at the oposite end with the wrench will unlock the bolt Unlock this to change installation angle NN 1 Hit lightly Fasten four nuts evenly By fastening four nuts evenly the belt can be fixed on the rail naturally To install the bracket on the place other than rooftop To unlock rail Though the bracket is designed to be instalied on rooftop rail it can be installed on variety of pipind Note Since the bracket is designed to be installed on places such as rooftop rail it does not have sufficient body ground Therefore depending on type of an antenna VSWR can not be lowered It is hightly recommended to use it with DIAMOND s high performance and stable radialless mobile whip antennas To install the bracket vertically for vertical installation of the antenna 1 Remove protection rubber cap and lossen socket bolt Use right angled hexagonal wrench included to loosen the bolt Protection rubber cap Socket bol right angled hexagonal wrench DAIICHI DENPA KOGYO CO LTD 445 1 Konakai
6. ngth of it and may cause to remove the bracket Be sure to bent back side of the belt inside
7. rotection rubber seat Double sided adhesive tape Optional parts There are variety of Teflon coaxial cable assemblies which are very convenient to feed the antenna into a car They can be selected by required cable length and or connectors Tools reduired to assemble Wrench 8 mm oe Screwdriver DIAMOND ANTENNA Installation Place a socket bolt on the left side of folding knob in front of the bracket In installation be sure to make SUPER GAINER letters in front of the bracket toward you 1 Decide where to install the bracket It iS recommended to install the bracket on center line side of rooftop rail since it can prevent antenna damage from trees Or obstacles along the SidewalK 2 To protect the rail apply double sided adhesive tape on back of protection mat and tie around installation place It is recommended to cut the mat to fit the rail before using it Rooftop rail Protection mat 4 3 Fix the bracket and fastening bet Remove nuts and spring washers on the belt and tie the belt around protection mat on the rail Note Be sure to confirm back and front side of the belt before installation Rooftop rail side 3 AACA TT A AC lt Ye Back side of the belt is a side where the belt is being folded To bent the belt be sure to make back side of the belt where the belt is being folded inside Make back side of the belt out weaken fastening stre
Download Pdf Manuals
Related Search