Installation Manual for Floor Controlled Locking
Contents
1. Installation Manual for Floor Controlled Locking Device Balancer Accessory Set up Instructions Floor Controlled Locking Device Super Duty Balancer Part number BIL 3224 Refer to figures for reference 1 Disassemble and remove large manual lock knob 1 by inserting a 3 mm Allen wrench into the pinhole 3 see figures 1 amp 2 NOTE Manual lock knob is not needed for the set up of the floor controlled locking device 2 Align hole in flat plate 5 with hole 2 located above where the lock knob was located Make sure the flange on the flat plate 5 is pointed away from the locking device and the gap in the flange cradles the pin 6 as shown in figure 3 3 Insert screw 4 through the hole on the flat plate 5 and into the balancer Tighten the screw 4 using a 6 mm Allen wrench 4 Assemble the top plate 7 with the two screws 8 using a Philips head screwdriver see figure 4 5 For complete assembled balancer with locking device refer to figure 5 Figure 1 Figure 2 Figure 3 Figure 4 Figure 5 45534682 am Ingersoll Rand Edition 1 June 2007 Set up Instructions Floor Controlled Locking Device Heavy Duty Balancer Part number BIL 7343 Refer to figures for reference 1 Disassemble and remove large manual lock knob 1 by inserting a 3 mm Allen wrench into the pinhole 3 See figures 1 amp 2 NOTE Manual lock knob is not needed for the set up of the floor controlled locking device 2 Align hole in2. flat plate 5 with hole 2 located above where the lock knob was located Make sure the flange on the flat plate 5 is pointed away from the locking device and the gap in the flange cradles the pin 6 as shown in figure 3 3 Insert screw 4 through the hole on the flat plate 5 and into the balancer Tighten the screw 4 using a 6 mm Allen wrench 4 For complete assembled balancer with locking device refer to figure 4 3 1 D Figure 1 Figure 2 4 5 A 6 NO Figure 3 Figure 4 www irtools com 45534682 aim Ingersoll Rand 2007 Ingersoll Rand Company Edition 1 June 2007
Download Pdf Manuals
Related Search