User' Guide - Trygghandel.se
Contents
1. bathtub to keep in good 6 Clean and keep in good condition 6 1 usually use soft cloths and general liquid cleanser can wash away dirt but forbid to use the cleanser with acetone or the ammon ia composition when disinfect forbid to use the disinfector contained the formaldehyde 6 2 the dirty spot of surface can use the toothpaste to wipe with the soft cloth 6 3 to the low grade chafe of the surface or burned by cigarette can soak in water to whet with 2000 levigation sand paper then polishing 6 4 If the electroplate piece contain stain use the soft cloth to wipe lightly avoid to wiping with coarse cloth 6 5 often clean up the backwater net cover prevent it from stop 6 6 Check whether have break on pipe and waterway aperiodically gt gt Page 2 of 10 Massage bathtub 6 7 Please check whether there is fall off or breakage on wire switch connector plugs so that repair in time 6 8 In order to keep to use in a long term please reme mber don t use more than 3 hours continuely 7 Fault eliminate Fault Cause Way Voltage unstable Check circuitry Power connector didn t connect Insert again or change Machine or equipment well or open circuit i power line doesn t work The windpipe connect air switch Connect again or change fall off or break The air switch failure Change Power s parameter is not same as i nameplate Connect with supplier Big nose of machine Fixed scr2. User Guide IMPORTANT Read this manual before proceeding with installation of the bathtub and keep it with the other accompanying documents This manual is valid for the installation of tubs both with and without whirlpool MODEL M 808 WS 118 SIZE 1600X1600X800mm Massage bathtub Massage bathtub 1 Users must install loads in strict compliance with the circuit diagrams and para Install the diagram meters supplied by our company connect the cold blue connect the power suppl and hot red pipe line oo ica eeu E ee 2 External cable audio signal should not be strong enough to burn out the power amplifier of the system oO 3 The ground wire must be connected to the power supply line with good grounding 4 Users must use the power cable sized3x2mm or bigger and in compliance with the national standard GB and the socket for the power supply of the controller must be 20A or higher and in compliance with the national standard GB and reliably installed 5 Users must additionally add a 20A or higher air switch or leakage switch in com Plane chart pliance with the national standard GB and the leakage switch of the controller only plays an assisted role 6 Strictly check the power supply wiring of the control box Power on to use only after no errors confirmed 7 The electric appliances recommended by illegal manufacturers must not be co nnected to the controller Unapproved dismantling and mo
3. detector protection respectively 3 Water supply device 1 This device s hydraulic pressure is 0 2 0 4Mpa 2 The water supply characteristics on the wall The cold or hot water supplies inside the bathroom also establish in the shelter of the massage tub use the hose to connect with the cold or hot joint of the tub the pipe towards is decide by the customer the machine do not go with the hose 3 3 4 Installation introduction 4 1 Before install must consider the place of install massage bathtub whether can support this device s pressure 4 2 Place the massage bathtub on the install position adjust level to make the drain system smooth 4 3 Adjust the leg s screw to make sure all of the screw touch ground completely 4 4 Install the drain hose and make some measure to against on the connecter 4 5 Fix cold and hot water pipe well then install the showerhead And then put drain into downcomer finally connect with power and make sure whether device connected with ground can work 5 Using Method 5 1 Turn on faucet adjust water s temperature add water to the massage bathtub when the highest water level exceed the highest nozzle about 20 30mm and reach the detector press the switch button to let the electric machine 5 2 Revolve the adjust switch and choose the proper surf pressure 5 3 After finishing if should turn off pump at first then open drain button when water is all out please make a clean of
4. dification of the enc losed internal wiring are strictly prohibited Itis not allowed to connect or plug the wires and plug in units on the power supply box during the power on 8 The connecting wires of the power supply box should be connected and plugged correspondingly according to the tags and specifications of the connectors the output wires can not be short circuited each other 9 Itis a must to power off the whole unit after used to prevent long tine power on to accelerate ageing 10 The installation of the controller must be performed in strict compliance with the installation instructions by qualified persons Big nozzle Returm net 11 No recoverable elements exist in the controller don t try to improve it by you rself for the high voltage in the controller can cause dangers The maintenance Tap takes over sketch and adjustment must be performed by professionals n ee Our company shall not take any responsibilities to any harmful consequences caused by the violation of above operation procedures by users g0 i Colg EJ supp Water a 70Frainage gt pe Page 1 of 10 Waterfall drain Sprinkler drain Cold water gt pe Page 10 of 10 Massage bathtub 8 3 Volume adjustment 8 3 1 The radio system can realize the digital tuning by volume plus and minus buttons and the tuning steps are 40 with each step 2 dB and the volume adjusting range shall be 0 80dB During the adj
5. e button again the system shall turn off the FM broadcast 4 play button 4 1 Push down the button CD function is take effect 5 Except for above listed functional buttons other functional buttons on the remote controller have the same operation methods with the corresponding functional buttons on the button panel V Precautions for Installation and Use Users must carefully read te following precautions to ensure the normal use of the product extension of its service life and the personal safety gt pe Page 9 of 10 Massage bathtub 1 Electricity parameter Rated voltage Rated power Rated electric current Reference circuit voltage 220VAC 750W lt 4A 12V 2 Electric installation 2 1 power supply s establishment should be compled with nation security standard voltage and frequency also shoule be accord withproduct s nameplate Especially install creep age protect switch and also check whether can connect with ground 2 2 The wire collected to the massage bathtub should be fitting permanent and the wire should be a three core wire the sectional acreage of each core cannot less than 12A when wire pass the wall it should be use bushing for protection until the AC outlet 3 Ground wire of bathtub should be test whether works with house appliance ground wire 4 The wire end of electricity control box should connect to the control panel water bottom light loudspeaker electrical engineering and the
6. ew did n fix or fall off Fix tightly again Support s leg screw did not touch ground E Adjust Aging Change water pipe leak out The joint did not fix well Fix again Water pipe or accessory leak Change Remark except this fault please according to situation to resolve or find experienced people to repair 8 special remind 8 1 please find qualified people to install bathtub according to introduction 8 2 when you are using it first of all you have to inject the cold water and then inject the hot water Don t inject the hot water first 8 3 bathtub s machine must connect on ground support must use 1 5mm yellow green double wire connect with ground and check whether effective please do not turn on machine without water before draining should turn off machine children should be looked after in bathtub bathtub s temperature cann t higher than people average temperature and the best is 32 37centigrade 8 7 after shower please cut off power 8 8 if have these situation please do not enter into massage bathtub 8 8 1 younger than 4 years old s child 8 8 2 blood circulation unstabled people 8 8 8 8 8 8 09 09 00 Onn 3 sot 4 suffer from flu 5 heart disease 8 8 6 already have sauna 8 8 7 after meal in half a hour Remark our company has the right to modify the above mention without further notice gt gt Page 3 of 10 Massage bathtub 6 Constant temperature function 6 1 only the water pu
7. for there are dangerous parts in it Only qualified servicemen are allowed for maintenance 2 Any change or modification to the controller not definitely recognized by its manufacturer or authorized units may cause many troubles to users Useful Tips 1 The intervals of continuous power on and off must be over 30s for extending the uses life of the controller 2 Please turn off the power after use 3 The used power supply must be in line with the specified voltage value shown on the controller otherwise it is not allowed to be used even burns out the controller 4 When installing the controller carefully check ifthe parameters of a load areas required by the controller otherwise it is not allowed to be used even burns out the controller 5 Please restart the controller in case of occasional down Il Brief Introduction 1 General Description of Functions Model PR1756 Functions Water pump Bulb pump Water bottom light FM digital tuning radio Connect with CD machine Constant temperature function Ozone function Remayk when you use function should instar temperature constant heater N IOIA OW NM 8 Water level sensor function l je eq I lalajaja j 9 Remote control function 2 Characteristics of the Remote Controller 1 Working voltage 3 0 VDC 2 Power supply 3V2025 button buttery 1 piece 3 Expected battery life Over 1 year 4 Transmission ra
8. l automatically lock the searched FM station The LCD shall display the frequency of the station Push down the button again when the upper limit frequency is 108 0MHz the frequency shall jump to 87 5MHz 8 2 2 Frequency up button Press TUN the tuning frequency can be increased by one step 1 step 50KHz If push down the button for more than 2s the system shall automatically search FM stations upward and the digital phase locked loop shall automatically lock the searched FM station The LCD shall display the frequency of the station Push down the button again when the upper limit frequency is 108 0MHz the frequency shall jump to 87 5MHz gt pe Page 8 of 10 Massage bathtub Show screen Condtant temperature C Water Pump Cg Bulb pump FM station memory MEM and selection FM CD FM CD switch Fung Function choice bottom light fuN FM frequency decrease TUN FM frequency increase 0 Power switch Remote control receive IIl Operation Descriptions of the Control Panel 1 Any functional button works with a beep sound accompanied by the buzzer 2 O Power switch 2 1 Push down the button the controller is on Repeat the operation again it is off 3 T Bulb pump 3 1 push down the button the bulb pump is on Repeat the operation again it is off 4 Water bottom light 4 1 Push down the button for more than 2s the water bottom lightis
9. mp starts the constant temperature heater can start 6 2 when the water pump starts Press w the controller commands the Water temperature according to the default Default temperature is 40 C Control rule water temperature gt Default temperaturet 1 C The heater stops heating water temperature lt Default temperature 1 C The heater reheats 6 3 When the constant temperature heater starts press the button Fun again Show last enactment temperature in the frequency manifestation press the button or tun to adjust the temperature 6 4 Press the button aJ the constant temperature function is off 6 5 The temperature setting scope 35 45 7 Ozone function 7 1 After press O to close the system The ozone device works automatically for10 minutes 8 FM digital tuning radio 8 1 Fweg Radio ON OFF button 8 1 1 Push down the button the system shall automatically enter FM receiving condition Push down the button again the system shall switch to CD play push dowm the button for third time the system close CD play 8 1 2 If the control system is OFF FM broadcast and CD play can be operated separately 8 2 Frequency adjustment button 8 2 1 Frequency up button Press TUN4 the tuning frequency can be increa sed by one step 1 step 50KHz If push down the button for more than 2s the system shall automatically search FM stations upward and the digital phase locked loop shal
10. nge The distance between the receiver and infrared sensor should be 5m atleast gt gt Page 5 of 10 Massage bathtub 5 Transmission angle Usually about 60 6 Transmission media Infrared ray 3 The LCD shows the following information 1 Logo and operation condition of the water pump 2 Logo and operation condition of the bulb pump 3 Logo and operation condition of the water bottom light 4 English letters frequency and unit of FM 5 English symbol and value of volume 6 English symbol of the channel storage and the channel value 7 Frequency hopping condition 4 Devices controlled ty the control system 1 current of the controllable water pump AC220V 1 5HP 2 Bulb pump AC220V 500W 3 Water bottom light AC12V 12W 4 Ozone AC12V 5W 5 constant temperatrue heater AC220V 1500W 6 speaker 80 8W 5 Schematic Diagram of Pr1756 Remote Controller az D 30 Bottom light run Function choice OEC Power switch CD switch S99 CD switc ae constant temperature D FM frequency decrease Wat PSr PETR FM frequency increase Q sup pump em FM switch MEM FM station memory gt pe Page 6 of 10
11. on Repeat the operation again it is off Water pump 5 1 The control system is equipped with a water level detection device to prevent the water pumps from idle running to cause damages 5 2 When the level device detects that the level had reached the setting value pushdown the button the water pump starts operation and push down the button again it stops operation 5 3 when the water level device detects that the level has lowered the setting value the water pump stops operation and can not operate any more gt em Page 7 of 10 Massage bathtub Bathtub User s Guide WARNINGS 1 Please follow the instruction contained in the attached installation manual to ensure that the product is installed properly the manuf acturer will not be held liable for damages or injuries caused by im proper installation 2 Follow the instructions contained in this manual when using the product 3 Before using the bathbub check the local voltage that if reach to the rated voltage pre installation card CONTENTS Safety Precautions II Brief Introduction Ill Operation Descriptions of the Control Panel IV Operation Instructions of Remote Controller V Precautions for Installation and Use gt pe Page 4 of 10 Massage bathtub Safety Precautions Warning 1 Don t expose the controller to the rain or moist environment to prevent fire or electric shock Don t open the cover of the controller
12. usting the LCD shall flash the volume value in the place showing FM frequency and the final adjusted value shall be the setting value After 2s the LCD shall display the FM fre quency again 8 3 2 Presw the button Fung then the Volume plus button The volume shall be incremented by 2dB after push down the button once When push Down the button for more than 2s the volume shall be increased at the speed of 10dB s 8 3 3 Press the button FUN then the Volume minus button L The volume shall be decremented by 2dB after push down the button once When push down the button for more than 2s the volume shall be decreased atthe speed of 10dB s 8 4 Station storage and retrieve button j 8 4 1 Station storage When select the station frequency to be stored push down the button for 2s and the frequency displayed at the LCD shall flash then push down the button again to select the location for storage after that push down the button again for 2s the station frequency shall be st ored in the selected storage location IV Operation Instructions of Remote Controller 1 Any functional button of the system works with a beep sound accompanied by the buzzer 2 D water bottom light 2 1 Push down the button the water bottom lightis on Repeat the operation again itis off 3 Cem_ Radio ON OFF button 3 1 Push down the button the system shall automatically enter FM receiving condition Push down th
Download Pdf Manuals
Related Search