TP-EI USER MANUAL
Contents
1. TP 8 1 USER MANUAL Introduction The Tracpod 81 intelligent LED color system contains 648 high efficiency high brightness LEDs which produce a wide variety of lighting effects such as chase strobe and mix colors by four modes Stand alone DMX Sound active or manual RGB adjustment It further provides 9 built in stunning chasing with variable speed and a build in controller This solid state lighting system has been designed for easy installation multi purpose hanging safe energy efficient and long life operation The System Includes 1 Tracpod 81 Unit 2x Mounting bracket Installation Guide Additional Items Not Included DMX controller Installation If the Tracpod is to be hung from a truss ensure that it is securely clamped and that a safety cable is wound through the Tracpod s mounting bracket and around the truss as a fail safe If the Tracpod is to be mounted to a wall ceiling floor or shelf ensure that the mounting screws will adequately bear the load Ensure that the Tracpod is hung or mounted in such a way as to allow adequate ventilation Built in enclosures must be actively ventilated Front and Rear Panel Functions DMX Modet 5177 Select DMX address Stand alone Mode 1 auto chase Ge sound chase and Fixture Control Made Select Mode 1 2 4 or 8 Manual AGA Color Mixing Press F 5 to begin Use and DOWN to Adjust Adjust Chase Fade Ti2. Fuse Replacement The Tracpod fuse may be replaced as illustrated below A Cautions DISCONNECT AC MAINS POWER BEFORE REPLACING REPLACE WITH FUSE OF SAME TYPE AND RATING Technical Specifications POWER SUPPLY 230v 50Hz 1 24ov O POWER CONSUMPTION Setup N Cautions FOR INDOOR USE ONLY KEEP DRY INSTALL ONLY IN WELL VENTILATED AREAS DO NOT ATTEMPT TO OPEN THE CONTROLLER OR FIXTURES NO USER SERVICEABLE PARTS INSIDE DANGER Ensure that main power supply is off before installing or wiring the Tracpod system Warranty The distributor warrants its products to be free of manufacturing defects in material and workmanship for a period of 90 days from the date of original purchase For products properly registered under the distributor warranty registratiojn program details below the distributor warrants its products for a period of 1 year from the original purchase date This warranty shall be valid only if the product is purchased from its authorized distributors or dealers It is the purchaser s responsibility to establish the date and place of purchase by acceptable evidence at the time service is sought For warranty service send the product only to an authorized distributor or dealer All warranties are void if the serial number has been altered or removed if the product has been modified in any manner if the product has been repaired or serviced by unauthorized personnel or if the produc
3. annel 5 Strobe 1 20HZ Channel 6 Sound active There are 8 modes of self running programs value 1 240 and one sound active value 241 255 in Channel 6 255 Sound active Chase 1 1 30 240 chase Chase 2 31 60 210 chase 7 Chase 3 61 90 180 chase 6 Chase 4 91 120 150 chase 5 Chase 5 121 150 a8 0 chase 4 Chase 6 151 180 60 chase 3 Chase 7 181 210 30 chase 2 Chase 8 121 240 0 chase Sound active 241 255 If DMX signal exists signal in the display panel will flash The lighting fixture should be preserved in dry cool and ventilated area The buit in controller will automatically detect the presence of a DMX signal In order to receive a DMX signal the buit in controller must be attached to a DMX controller by a 3 pin DMX cable and the DMX controller must be turned on To mix RGB color using DMX Channel 1 Rainbow must be off 0 When programming your own DMX sequences note that Channel 6 must be off 0 to avoid activating Sound active mode during playback DMX MODES dL DMX Mode 1 48 channel operation JL Control each Tracpod LED cluster independently DMX Mode 2 24 channel operation Control 4 sets of 2 Tracpod LED clusters CH CH CH CH 7 12 13 18 13 18 19 24 dl DMX Mode 4 12 channel operation I L Control 2 sets of 4 Tracpod LED clusters DMX Mode 8 6 channel operation Control all 8 Tracpod LED clusters in unison
4. me from 0 100 Adjust Chase Speed from 0 S500 minute L DMX 512 INPUT DMX 512 OUTPUT Microphone AUDIO LEVEL Stand alone Operation Refer to the four buttons on the front panel of the Tracpod Press the MODE button to view the Chase menu 1 Select Chases 1 9 using the UP and DOWN buttons IC Chases 1 8 run according to the Fade and Speed values Chase 9 is Sound active Press the F S button to set the Fade and Speed values Adjust Chase Fade Time from 0 100965 503 0 Adjust Chase Speed from 0 500 steps minute Manual RGB Adjustment Find Anu manual RGB adjustment menu by pressing MODE button Press F S to select desire color for adjustment use UP and DOWN button to adjust value o Indicates Red from dark to bright Dn0 Indicates Green from dark to bright Dad Indicates Blue from dark to bright Program will memory from last adjustment Sound active Operation In Stand alone mode select Chase 9 and adjust the audio input level using the sensitivity control dial on the rear panel of the Tracpod In DMX mode use Channel 6 to select Sound active operation DMX Operation Press the MODE button to view the DMX address setting menu ADO Select the DMX starting address for buit in controller using the UP and DOWN buttons The DMX Channel functions are Channel 1 Rainbow Channel 2 Red 0 255 Channel 3 Green 0 255 Channel 4 Blue 0 255 Ch
5. t is damaged due to improper use or maintenance as set forth in the instruction manual This is not a service contract and does not include standard maintenance or cleaning Lamps fuses brushes belts and all expendables are not covered by this warranty The distributor reserves the right to change design and specifications without obligation to include these changes in previously manufactured products Additional warranties provided at the discretion of the distributer dealers shall remain the sole obligation of the distributor or dealer
Download Pdf Manuals
Related Search