USER'S MANUAL - Taiwan Trade
Contents
1. option 6 NEMA 4 IEC 2 Universal 2 Schuko BATTERY Bttery Type amp Number 12V 4 5Ahx1 12V TAhx1 12V 9Ahx1 Typical Recharge Time 4 6 hours up to 90 capacity AC Mode Green Lighting INDICATORS Battery Mode Yellow Flashing Fault Red Lighting Smart Charging when UPS is off Green Flashing Battery Mode Sounding every 12 seconds ALARM Low Battery Sounding every 2 seconds Fault Continuously sounding PROTECTION Overload AC Fuse Short Circuit and Overcharge protection PHYSICAL Dimension D X W X H mm 280 x 100 x 140 Net Weight kgs 3 5kgs 4 5kgs 4 8kgs Altitude lt 5000 Meter ENVIRONMENT Temperature 0 C 40 C __ Humidity 0 90 Non Condensing Audible Noise lt 40dB2. UPS does not operate for a long period recharge the battery every month by starting the UPS for 8 hours 9 Replace the battery with the same number and type of batteries as originally installed in the UPS The UPS must be unplugged from the AC power source before replacing batteries this operation require specialistic staff ARON OND 5 TROUBLE SHOOTING UPS power is on but UPS does not start The line cord is not connected Or not plugged in The wall outlet is dead Connect the line cord to the UPS and plug the UPS into a working outlet Start UPS but red LED flash Low battery power because of long term AC power failure When AC power in normal condition Execute battery charge for 8 hours UPS does not provide the expected back up time The battery may be low power because 1 Long term storage 2 Overload 3 End of battery life 1 Charge the battery for 8 hours 2 Turn off connected applications 3 Replace the battery Red LED illuminates and alarm Continuonos beeping UPS fault Unplug the UPS from wall outlet 6 SPECIFICATIONS Nominal Voltage 120VAC 220VAC INPUT Voltage Range 80VAC 145VAC 160VAC 290VAC Frequency 50 Hz 60 Hz Voltage Batt Mode 10 Frequency Same as Input OUTPUT Built in AVR Two Boost 8 1 Buck Waveform Modified Sine Wave Transfer Time Typical 2 6 ms Outlets 4 NEMA 5 15R
3. Line Interactive UPS USER S MANUAL CAUTION Risk of electric shock Do not remove cover No user serviceable parts inside Refer servicing to qualified service personnel CAUTION To reduce the risk of electric shock use only indoors and in dry locations CAUTION Risk of electric shock Disconnect unit before servicing CAUTION Risk of electric shock Battery circuit is not isolated from AC input Hazardous voltage may exist between terminals and ground Disconnect unit before servicing battery 1 Overview 1 1 Introduction Line Interactive UPS offer excellent protection for PC Networking workstation and small internet working Devices The system built in line conditioning known as AVR Auto Voltage regulation the ideal device to protect your PC against all power 2 INSTALLATION AND OPERATION 2 1 Installation The following steps explain how to install the UPS to your PC Step 1 Assure AC power source output voltage is in the UPS Require range which specify on the rear panel Step 2 Plug the UPS power cord into a wall outlet or other Power source Step 3 Plug in the personal computer PC into the UPS output Step 4 Start the UPS by pressing the ON OFF button for 1 seconds Green led indicator illuminate indicating the UPS is now on You may now turn on your computer Step 5 Cold DC start UPS By Pressing ON OFF button for 4 seconds The red led indicator illuminate indicating the DC power is now avai
4. lable When AC power recovered the green led indicator illuminates indicating that AC power is normal Step 6 Shutdown the UPS by pressing ON OFF button for 6 seconds Till Red LED indicator turn off 3 LED and Alarm Indication 3 1 LED indication GREEN YELLOW FLASHING RED GREEN CONSTANT AC power mode UPS ON Flashing 10 sec UPS Overload on Battery mode 3 2 Alarm indication Beep every Beep every Beep ever Beep 10 secs 0 5 sec 1 sec continuously UPS on Battery Low Overload Overload battery mode warning cut off warning Disturbance including power blackouts Surge and Sag With Micro Processor inside the UPS not just work hard but work smart and to Protect your document save into PC 4 CAUTION Although your UPS has been designed and manufacturer to assure personal safety improper use can result in electrical shock To assure safety please observe the following rules 1 Turn off and unplug your UPS before cleaning Do not use liquid or aerosol cleaner A dry cloth is dust from the surface of your UPS Do not install or operate your UPS in near water Do not place UPS on an unstable cart stand or table Do not place UPS under direct sunlight or close to heat emitting source Do not place UPS power cord in any area where it may get damaged by heavy objects Do not connect UPS to home appliance e g hairdryer fan etc Do not connect UPS to Laser printer If you store the UPS or
Download Pdf Manuals
Related Search