EuroMat User Guide page 1.psd
Contents
1. 15 Mats from a wagon bed use an appropriate forklift truck Place Mat onto the ground to provide the coverage required t Be f o R z sy oy Ulle Cyne Hise A tite No ground preparation is usually needed As each Mat is placed it is essential to connect it to the neighbouring Mats using the correct connector To connect two Mats place the 2 Way Connector underneath the Mats Code EUROMAT 2WAY The raised cylinders on the connector unit should fit within the holes on the corner of each Mat When in place secure using 2No Connection Bolts Code EUROMAT BOLT taking care not to overtighten Where four Mats need to be placed together use the 4 Way Connector following the same process Code EUROMAT 4WAY Page 2 of 3 product user guide mjajbjejy all the support you need Title Issue Date 3 Storage and Maintenance 15 Mats Mats should be stored in bundles of 15 maximum h maximum separated by suitable timbers 4 recommended Suggested maximum No of bundles 5 high Where possible Mats should be lifted in bundles using a forklift truck If a forklift truck is unavailable Mats should be lifted individually Each Mat may be lifted by 2 or more people and is subject to site manual handling assessment 4 General Notes 4 1 Surface Debris Care should be taken to ensure that the surface of the Mats is kept clear of any debris that could damage them No specialist equipment i2. product user guide EuroMat Contents Page 1 Component Identification Sizes Weights and Codes Page 2 Installation and removal Single Mat Lifting Placing Mats comm lic m Connections 2 way amp 4 way and bolt Page 3 Storage and Maintenance Stacking Mats Lifting of Stacked Mats General Notes 1 Component Identification 4No Mat to Mat connection points Insert EuroMat 4 Way Connector Material High Density Polyethlyene HDPE Size 185 x 55 x 10mm Thick Code EUROMAT 4WAY Weight 0 4 kg 6No Lifting handling holes also available without handling EuroMat Material High Density Polyethlyene HDPE Size 2 41m x 1 20m x 14mm Thick With Handling Holes Code EUROMAT Without Handling Holes Code EJROMATPED Weight 36 0 kg M10 EuroMat 2 Way Connector Material High Density Polyethlyene HDPE Size 185 x 55 x 10mm Thick Code EUROMAT 2WAY Weight 0 1 kg Rubber washer below Connection Bolts M10 x 25 bolt Code EJROMAT BOLT Weight 0 1 kg Complete with steel and rubber washers Page 1 of 3 on top Q Steel KS washer product user guide Title Issue Date 2 Installation Removal is the opposite procedure Manual Handling To remove from wagon bed manually suitable edge protection will be required around the wagon bed Removal of Mats is subject to the site manual handling assessment the mat may be lifted by 2 or more people Handling To lift a stack of
3. s required to clean surface debris from EuroMat Mats Where necessary Mats can be cleaned using cold water and a pressure washer 4 2 Vehicle Useage EuroMats are intended mainly for light vehicle and pedestrian use but may be used for vehicles upto 80 Tonnes dependant on the combination of vehicle type and ground conditions If in doubt ask 4 3 Tracked Vehicles Steel tracked vehicles with aggressive tracks such as excavators should not be driven on these Mats Rubber tracked vehicles may be used subject to weight limitations 4 4 General Since our policy is one of continual improvement components may vary in detail from the descriptions given in this publication EuroMat is a registered trademark of Zigma Ground Solutions Limited Page 3 of 3
Download Pdf Manuals
Related Search