MIDI] and N500 FITTING AND OPERATING INSTRUCTIONS
Contents
1. M100 and M500 FITTING AND OPERATING INSTRUCTIONS windoware IG INDIVIDUAL MOTORS TO RUN TRACK STER BUTTONS m d These are the buttons used to set the limit switch position Pushing up and holding up the adjustment buttons engages the index rings and when turned rotate them so that slots can be aligned The adjustment buttons can be turned in different directions M100 Wee Please note the M100 GPA roto has a 35kg individual cen apacity It has a built int bf but a separate receiver SSID Set ee The M500 Motor has a 45kg carrying capacity built in transformer and a receiver NB The safety clip must be moved sideways to allow the buttons to be pushed up During normal operation they are ge we _ located in the disengaged position SECONDARY MOTOR Both the M100 and M500 can have the carrying capacity doubled by installing a secondary motor on the same track When the safety clip is in mid position it keeps the adjuster buttons in the down and disengaged position The safety clip locks the safety clip in the mid position WARNING 25 NOT RECOMMENDED T WOTDR UNTIL IT 15 ATTACHED ANI THE TRACE A LICENCED ELECTRICIAN SHOULI INSTALLATION WORK MOTOR OPERATION When you receive your MTM Track from us please ensure that the arrow indicated on the track aligns to the white clip on the centre of the Master overap carrier 3 OF LIMIT SWITCHES2. When we supply MTM Tracks the limit switches have already been set and DO NOT need to be altered When the track leaves the factory we mark Ensure that when placing the motor on the individual adjuster buttons track that you engage the driveshaft into the motor The motor must click up and lock in Also check to see if the locking safety clip is fully engaged The button marked O for Open ie stack back and C for Close INDEX RINGS Vi MOTOR OPERATION Insert the main drive motor just by following the above instructions On the other end of the track insert the secondary drive motor and ensure that the locking clip is locked ADJUSTER NB The main drive motor has the limit switches inside and the secondary drive motor has no limit switches as you only require them on one side R COMPONENTS Index rings including micro switch When the motor runs these rings rotate at different speeds When all three slots are aligned it allows the micro switch to engage and stop the motor MOTOR PLUG
Download Pdf Manuals
Related Search