20121001 ~ EMRX Installation Manual (LQ)
Contents
1. 01210012. HT Se ZO 1x SHORT SCREW 2 LONG SCREWS NOTE SELECT APPROPRIATE TERMINAL COVER SEAL ENSURE SNUG FIT OVER CABLE ATTACH SEAL TO CABLE PULL THROUGH APPROXIMATELY 40mm LOOSEN TERMINAL FASTENERS DO NOT REMOVE FOLD SEAL OVER CABLE 10 1 1 INSERT WIRES INTO TERMINALS M 21 4 WI TIGHTEN TERMINAL SCREWS 12 13 13 TERMINAL 1 lt S lt GROOVE INSERT SEAL INTO SEALING RK LLI fi 2 0 S 5a 2 an gt alan 20 65 gt 2 1 5210 OE 20026 TO a DAD LL Ee 2 lt i lt 2540 lt lt 0 OO TRID aaa _J NL 7 E lt lt gt em CREW INA N 72 KA 7 0 8 1x SHORT e ae S FASTEN TERMINAL 2XLONG NOTE COVER EM SCREWS LIGHT HOUSING 16 ENSURE O RINGS STAY SEATED WITHIN TERMINAL COVER REMOVE LANOLIN SCREWS 17 GENTLY WARM LANOLIN TUBE N REMOVE LID FILL TERMINAL CAVITY WITH LANOLIN 13 STOP FILLING WHEN LANOLIN EXITS TERMINAL COVER NEAREST TO CABLE USE FILL HOLE _ FURTHEST FROM Y CABLE 19 REPLACE LANOLIN SCREWS CHECK O RINGS ARE PROPERLY INSTALL EMRX 3 FIRMLY FASTEN EM LIGHT TO NICHE HAND TIGHT ONLY MULT
3. I LIGHT INSTALLATIONS ONLY AIM FOR COMMON LOCATION OF RED 2 PUSH BUTTON FOR CONSISTENT LED COLOUR APPEARANCE TROUBLESHOOTING MODEL Light flashing Blue continuously Light flashes 2 times Light colours not synchronised Light not operating 1 Light not operating 2 Light not operating 3 Light not operating 4 Light not operating 5 System is in Reset mode Light over heating Power interruptions or lights have been used individually Faulty connection at transformer or light Mains power not connected or switched ON Damaged cable Faulty transformer Damage caused by high voltage and or incorrect power supply Refer to multi colour operating instructions Check light is fully submerged Check vents are not obscured Reset lights refer to multi colour operating instructions Confirm connection at light amp transformer as per instructions Ensure no frayed or loose wires Check transformer is plugged in to GPO and switched ON Replace cable Check transformer output with multimeter under load Ie 20W 12V Return product to Spa Electrics for repair If these issues cannot be resolved with the above recommended actions please contact your distributor or Spa Electrics PLEASE STORE THIS MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE www spaelectrics com au COPYRIGHT 2012 SPA ELECTRICS PTY LTD ALL RIGHTS RESERVED 2
4. INSTALLATION amp OWNER S MANUAL ULTRA COMPACT NICHE LIGHT FOR RETRO FITTING EXISTING POOLS STORE THIS MANUAL IN A SAFE A PLACE FOR FUTURE REFERENCE NSERIES CONTENTS READ THIS FIRST TOOLS REQUIRED IMPORTANT NOTE PRODUCT SUPPORT AND INFORMATION INCLUDED PARTS FINISHED INSTALLATION DIAGRAM ASSEMBLY STEPS 1 19 INSTALL EMRX TO NICHE TROUBLESHOOTING READ THIS FIRST This booklet contains important information about the correct installation and handling of EM series lights Please read this booklet carefully before commencing installation to familiarise yourself with the included parts accessories and correct installation procedures BEFORE YOU START e Ensure that the lighting system is installed by a suitably qualified persons e g registered pool builder and or qualified electrician in accordance with AS NZS 3000 2007 standards 9 For safe and proper installation ensure that only those parts supplied with the system are used e Check that there is enough cable behind the existing light to allow for servicing above water preferably at ground level pool side e Ensure the pool light end of cable is circular and free of damage or imperfections i e cuts cracks or deformation f possible trim cable back until a fresh end of cable is available e Confirm existing transformer is a magnetic type 12V AC ONLY and in good working order If in doubt contact Spa Electrics e If multiple EM
5. RX lights are installed ensure the red CLICK FIT tab is located in a consistent orientation to ensure uniform visual appearance of the LED colours See Page 18 for further infomation e The EM series light can be mounted at any angle provided the installation conforms to the above CLEANING e Only use warm water and a soft brush or cloth to clean EM series lights DO NOT use detergents spirits as this can damage the light and void your warranty USE e Do not operate light unless completely submerged in water Operating the light for at least 15 minutes every week is advised all year round e EM series lights are designed for continuous 24 7 operation EM series lights are suited for both domestic and commercial installations WARNING e The EM series light must only be powered by a 12V magnetic type transformer DO NOT use electronic or switch mode transformers with EM series lights These transformers will damage the light and void your product warranty Pool chemicals PH levels Due to the corrosive nature of unbalanced pool chemicals Spa Electrics strongly recommend that your pool water is balanced prior to installing your pool lights or any plastic or stainless steel components and tested weekly to maintain these levels pH levels should be maintained between 7 2 7 6 at all times to ensure the longevity of these components gt Failure to do so can result in chemical damage to the light housin
6. g and pool fittings including stainless steel components gt Please note Lights or components found to have excessive chemical damage will not be covered under our manufacturer s warranty policy e This light contains no user serviceable parts opening the light will void the product warranty TOOLS REQUIRED MODEL EMRX gt Flat blade screw driver gt Phillips head No 2 screw driver gt Cable stripper gt Pliers IMPORTANT NOTE 1 The use of power tools such as 240V and cordless drills during installation 15 not recommended as these devices can cause faults and damage to light components All EMRX installation steps should be carried out with manual tools only IMPORTANT NOTE 2 Before commencing retro fit installation of EMRX light to PAL Niche you must ensure that all connected transformers are 12V AC magnetic type only If in doubt contact Spa Electrics PRODUCT SUPPORT AND INFORMATION Phone 61 3 9793 2299 business hours Email info spaelectrics com au SALES enquiries Email tech spaelectrics com au TECHNICAL support enquiries Web www spaelectrics com au INCLUDED PARTS MODEL EMRX WHITE GREY GREEN 0 0 0 40 er QU 1X 1X 1X OPERATION INSTALLATION WARRANTY MANUAL Multi Colour Only FINISHED INSTALLATION 5 STRIP WIRES STRIP WIRES mm 20mm REMAINING REMOVE TERMINAL COVER amp SEAL FROM EM LIG
Download Pdf Manuals
Related Search