CS-20 Speed & Cadence Sensor User's Guide
Contents
1. and tested successfully use the needle nose plier to help tighten the zip tie and make sure the Sensor is securely installed on the left rear chainstay Then use the plier to trim off excessive zip tie Press the Test Key on the Sensor to enter Test Turn the crankarm clockwise to pass the Cadence Spin the wheel counterclockwise to pass the Speed Mode for 60 seconds Sensor Sensing Point The Test Key LED should start Sensor Sensing Point The Test Key LED should start flashing if the device is installed properly flashing if the device is installed properly Use a coin to unclinch the Battery Cover Lithium Battery CR2032 IMPORTANT NOTE O ring waterproof component Please make sure the Battery Cover is securely sealed to prevent unexpected Remove the battery inside with a water leakage new one then close the battery cover onto the device Supported Devices amp Software This device is a Bluetooth 4 0 device compatible and applicable with many iOS devices including e iPhone 4S iPhone 5 The New iPad iPad 4 iPad mini e iPod Touch 5 In addition this device has been tested to work with various Apps listed in the following link http global mobileaction com SCS support jsp 1 The device can be used in rain but should not be used underwater 2 The position of Sensor and gaps between Sensor and magnets should be checked periodically 3 Do not use corrosive chemicals to clean the device 42. gatU CS 20 Speed amp Cadence Sensor User s Guide Cadence Sensor Speed Sensor Wheel Magnet Set Sensing Point Sensing Point Rubber Bracket Set Magnet Rubber Bracket Extension Test Key Battery Cover Rubber INSTALLATION Top View Cadence Sensor Sensing Point IMPORTANT NOTE Install Cadence Magnet on left crankarm near pedal gt Align Cadence Magnet with Cadence Sensor as shown Do not tighten zip ties completely to Sensing Point as shown Proper distance between allow magnet placement Use Extension Rubber for Cadence sensor and magnet should be less than 10 mm proper distance adjustment Magnet Install Sensor Pre fit Sensor and Rubber Bracket on left rear chainstay non drive side and trim excessive rubber from bracket Ensure the battery cover is facing up Install zip ties loosely to allow sensor placement For Round Spokes For Bladed Spokes Unscrew the wheel magnet to install on spoke F r IMPORTANT NOTE Align Wheel Magnet with Speed Sensor Sensing Point as shown Proper distance between sensor and magnet should be less than 10 mm Use screw driver for proper distance adjustment gatU CS 20 Speed amp Cadence Sensor User s Guide 4 Adjust Sensor and Magnet Sets GAP lt 10 mm GAP lt 10 mm e Adjust angle and position of sensor to achieve recommended gap distance range and align sensing points 5 Test Speed and Cadence Sensor with Magnet Sets After entering Test Mode
3. Do not disassemble the device Connect to Speed amp Cadence Sensor Supported Apps can be downloaded at iTunes App Store After installing the downloaded App follow the instructions in App to complete Bluetooth connection to the Speed and Cadence Sensor Note The Bluetooth interface is disabled by default Bluetooth connection will be established when the Bike is moving and Speed or Cadence data is detected
Download Pdf Manuals
Related Search