Suntrack User Guide
Contents
1. Suntrack User Guide The user manual 28 2 2012 Heliostaat nl Mark Ursum Suntrack User Guide 28 februari 2012 User Guide Introduction This is suitable for both the standard SG2100A motors and the users with own motors Description With daily use only position 1 of the slide switch is used The mirror can focus on a target or power off the mirror will then go to the park position Turn to a parking position where the mirror is rotated slightly to the ground The mirror can always remain focused on one goal when the sun rises the next day the mirror will move toward it and then continue There are 4 working modes follow target 1 2 or 3 and follow the sun Position 1 Note To turn backlight on press an unused key on the remote next to target 2 or 3 This is the normal position Position 1 4 relates to the slider It can call stored points and be targeted directly at the sun With off the mirror will go to the park position Key Function Suntrack User Guide 28 februari 2012 Position 2 This is for manual movement If the mirror s manual moved the new point will be followed as a manual target Key Function Position 3 Calibration endpoints using the end switches First go to the min positions the LCD now shows the deviation in parentheses it should be between 5 and 5 Learn the highest position only once Note that it is usually not possible to go to Xmax and Ymax simultaneously the engines will c2. are immediately rotating 1 away from the end and can not always be seen The switch is broken or there is a cable lock or breakage flashing colon The flashing colon means that no DCF clock read the last 24 hours Make sure the LED blinks at one second rate by the DCF antenna The DCF clock is only read n Off state or between 0 00 and 1 00 at night backlight turns off The backlight on the LCD goes off after 3 minutes Turn it on by pressing an unused button for example right button 3 not responding to If engines do not run in mode 1 or 2 the maximum X or Y are may be remote low Do a calibration min and max position 3 not responding to Replace the CR2032 battery of the remote control Is the rotary switch on remote the back of the remote on the right position not responding to Advanced users can choose their own code A P remote recorded point has Make sure the mounting of the rotors is still leveled Do a zero calibration moved position 3 with Xmin and Ymin time date incorrect Time is always ano DST GPS users may have the wrong time zone DCF does not work Make sure the LED blinks at one second rate by the DCF antenna
3. lash First run both axes to minimum The controls are immediately turns 1 away from the end Run both axes to maximum to learn the controller the working area Key Function turn to the maximum horizontal position clockwise turn to zero anticlockwise turn to the maximum vertical position up Ymin turn to zero down Position 4 Saving Target 1 3 and sunposition The sunposition needs only be calibrated when installing or changing hardware Saving the positions must be confirmed with the Yes avoid unwanted stores To save a position press target LCD shows Save Ftl press Yes the LCD shows Saved FT1 or any other key to ignore How to calibrate the sun position see installation manual Suntrack User Guide 28 februari 2012 Function Targetl The postion to be stored Target2 Yes Sun Target4 Calibration of sun position Park Save parking postion Problems The control is equipped with various protection devices This can cause a message on the LCD description wait for GPS DCF DCF The internal clock has run out after a long time to have stood it can sync take a few minutes to receive a valid DCF signal Ensure that the LED flashes at one second rate by the DCF antenna HalX of HalY There is power to the motors but no movement on the sensor The motor is jammed or there is a cable lock or breakage Try to move to position 2 EndX of EndY Endy EndX or the limit switch s always seen The controls
Download Pdf Manuals
Related Search