location & removal installation operating instructions
Contents
1. the TOOKI POR establishes a wireless Bluetooth link between the Porsche PCM radio and your mobile phone With key features such as Phone book synchronization phone dependent Privacy mode Radio keypad dial call hang up and noise cancelling technology NAV TV NAV TV UK LTD Unit R4 Capital Business Park Wentloog Cardiff CF3 2PU Telephone 44 0 870 801 0440 Fax telephone 44 0 870 801 0441 technical nav tv NAV TV UK Ltd is not liable for any incidental consequential or indirect damages In case of erratic behavior of the vehicle s electrical system please disconnect the NAV TV product and contact our technical support Team NAV TV UK Ltd does not assume liability for any di A TOOKI POR BLUETOOTH PHONE CONNECTION ALL PORSCHE equipped with PCM2 SW version 2 0 and above NAV TV UK LTD e11 72 245 2004 104 4020 00 RoHS 2002 95 EC 2002 96 EC2. LOCATION amp REMOVAL Firstly to determine if your PCM unit is compatible press and hold the MAIN amp TRIP buttons to display the PCM Software version Should be 2 0 or above Installation is made at the front unit To remove the head unit you will need to remove the surrounding trim then the 4 screws securing the unit as below Some models are removed with specific radio keys TOOKI POR is designed to work with a radio that has a factory SIM card based GSM phone option rather than Bluetooth As such certain functions displayed on the radio are not supported by the TOOKI POR The factory phone module if fitted will need to be removed from its power and optical con nection optical cables must be re connected to continue loop This module is located under the drivers O S seat on all models It is possi ble to install the TOOKI kit at the Factory phone location and allocate 12v perm and ground INSTALLATION With the head unit now removed locate the power ISO plug and the Black optical plug shown below Insert OPTICAL leads into TOOKI POR loom and car loom to create loop see diagram below IN cable from interface OUT cable from screen INTERFACE CAR CONNECTOR To remove the out fibre optic cable from the factory con nector you will need to remove the black outer casing and push out the blue locking insert You will need to do the same to insert the cable into the supplied loom shown in previou
3. s fig Next plug in the power link loom into the car harness plug in the microphone supplied and insert optical plug into the interface OPERATING INSTRUCTIONS 1 Press TEL on PCM Radio 2 Tooki Searching indicates no phone connected 3 Start the pairing procedure on your mobile phone Make sure the Bluetooth feature is turned on Con sult your phone s manual for phone specific pairing procedures 4 Once your mobile phone discovers Tooki xxxx last 4 digits will vary select and pair Tooki 5 When prompted for a passkey enter 6888 on your mobile phone 6 Once pairing is complete press TEL and select phonebook Choose the phone you wish to pair and select After a short while you should see your signal strength indicator and phone book list on the PCM Ra dio Pressing Tel will then show you your network pro vider and signal strength 7 YOU may pair up to 5 different mobile phones For information on phone selection section 6 8 To delete a paired phone select phone book scroll to the phone name you wish to delete select the name by pushing the rotary button When the name is se lected scroll to delete on screen and you should see the message are you sure you want to delete select yes 9 you may use any of the units hard keys as well as the on screen lists to dial out OPERATING INSTRUCTIONS The TOOKI POR is designed for a phone ready PORSCHE vehicle When used properly
Download Pdf Manuals
Related Search