USER MANUAL
Contents
1. ION POSSIBLE HAZARDOUS OPTICAL RADIATION EMITTED FROM THIS PRODUCT DO NOT STARE AT OPERATING LAMP MAY BE HARMFUL TO THE EYES This product is CE FCC ROHS compliant2. e adjustment Move the mode key to the downwards position Press or key to adjust the volume as per demands 5 Motor focusing Move the mode key upwards to the top Press or key and check the symbol and 4 on screen to adjust the image to the optimum status When the n screen indicating the symbol of it means the focusing has arrived at the tap end When the screen indicating the symbol of 4 it means the focusing has arrived at the bottom end 6 Use the projector to charge other product The projector can be used for charging smartphones 6 1 Connect one end of USB cable to be purchased separately to a smartphone and other end of USB cable to the USB interface of the projector fully charged 6 2 The screen of smartphone will indicate charging until the charging is completed Important safety information Please carefully read the instructions in the user manual before using the projector and operate the projector as per the instructions Any damages caused by failure of complying with instructions will invalidate the warranty Warning Please do not block any air vents To ensure the normal operation of projector and prevent overheating the location of projector shall not influence the normal ventilation of projector To reduce the risk of electric shock do not open the housing of product No part inside the product can be repaired by user To reduce the risk of f
3. h battery Up to 2 5 hours projection time USB powerbank for smartphone 5V 500mA USB Charge cable included 5pin MHL HDMI cable included HDMI HDMI cable included Dimension 68W x 10 5H x 12 6D mm Weight 155gram Charger specification DC 5V 2 1A input for projector If using 5V 800mA charger when charging the projector then projector must be shut down when charging Use instruction 1 Charge the projector 1 1 Use the power adapter not included and USB charge cable included to charge the projector Using non standard power cable may cause charging abnormity 1 2 There are 4 charging LED indicators The white indicators will flash in turn when charging and will stop flashing and stay lightened when the charging is completed Attention For the initial use the battery of the projector shall be fully charged for about 4 5 hours The working hour of projector is above 2 5 hours 1 3 Press the power key to check the battery status When only one lightened LED indicator is left it means the battery of the projector is low Connect the power adapter and charge the projector promptly to avoid the automatic power off when the battery is low 2 Connection of projector 2 1 Connect the power adapter with the power connected to the USB power interface of the projector 2 2 Connect one end of the HDMI cable included in the packaging to the HDMI interface of the projector and other end to a device like notebook sma
4. he power cable to contact with heater or any heat source Use loose packaging to store the product Avoid the extreme bending of power wire 7 Do not expose the product to direct sunlight or any heat source such as radiator warming machine stove or any device that will generate heat including magnifier Do not place the product on the top of stereo equipment which will generate radiant heat 8 Prevent the cloth plastic bag or paper material blocking the air vent of products Do not place the product on the surface that may block the air vent such as sofa or bed 9 Do not overload the power outlet Only use the exclusively appointed power voltage 10 Do not move or place the product by pulling the power cable 11 If the product cannot be used due to the damage of power cable or plug damages caused by falling or immersion do not use the product Do not repair the damaged power cable or plug individually 12 To avoid the electric shock do not open the product housing or repair the product Improper repair may expose you in dangerous voltage or other hazardous 13 Do not store the product in flammable or explosive environment 14 Hold the plug or connector when pulling out the plug Do not pull the power cable Warning The product is with rechargeable battery built in Do not place the product in any area with high temperature moisture or direct sunlight Do not disassemble the product Do not put the
5. ire or electric shock do not expose the product to rain or moisture The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance servicing instructions in the literature accompanying the appliance Danger To reduce the risk of electric shock burn fire and injury 1 Do not use the product during showering 2 Do not locate the product at a place that may cause the product falling into a bathtub or flume 3 Do not expose the product to water or any kind of liquid 4 If the product falls into water do not take it out by hand cut off the power immediately 5 During operating prevent the product from falling into or being exposed to water or liquid Warning 1 Please pay special attention to child or mental patient who is present or using the product 2 Please operate the product as per the instructions of user manual 3 Please pull out the power plug during thunder storm or when the product is idle 4 Prevent any articles entering into the product 5 Prevent treading or squeezing the power wire especially the plug power outlet and vent 6 Prevent t
6. product into fire or water which may cause explosion or injury Keep the product out of the reach of children Do not touch the product with damp hands Please properly dispose the waste product Do not discard the product as common household rubbish Please contact the local recycle center to properly dispose the product Trouble shooting Q The projector cannot project video image A Please charge the battery of device and check whether the interface of HDMI data cable is correctly connected to the projector and device Q The projection image is fuzzy A Toggle the focusing adjustment button to adjust the image to the optimal projection effect The fuzzy image may probably be caused by the selected background Please select smooth background for projection Q The projector has been fully charged and is connected to my device but still cannot project A Check whether the data wire is correctly connected Q No signal my device has no data output A Check whether your device has been started up and is fully charged Trademarks Homi HDMI HDMI logo and High definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries or districts iPad iPhone and iPod touch are trademarks of Apple Inc registered in the U S and other countries DLP and the DLP logo are trademarks of Texas Instruments RISK GROUP 2 CAUT
7. rtphone tablet etc Notes certain device may need a converter to connect the HDMI data cable Or connect the HDMI interface of MHL cable included in the packaging to the projector and Micro USB interface of the data cable to the smartphone Attention when connecting to an Apple device please use an Apple AV adapter to be purchased separately to connect the HDMI data cable included in the packaging When connecting to other device please inquire the manufacturer or distributor of the product The connection may need other converters to connect the HDMI data cable such as Micro or Mini HDMI converter 3 Startup and operation of projector 3 1 Long press the power button about 7 seconds to start the projector 3 2 Choose and play your favorable movie or file by the device connected to the projector 3 3 The projector can work at any time and any place We recommend to aim the lens of projector at white background smooth and white background would be preferred if need picture effect with higher quality The dimension of projection image can be adjusted according to the distance between the projector and background An image of 60 will be the best Use the projector in a dark ambient environment will improve the image effect Attention the projector will become warm at both upper and down side during working This is a normal phenomenon of heat emission which won t impact the operation of projector 4 Volum
8. xxodd USER MANUAL Projector Nano Go 3 DLP TEXAS INSTRUMENTS READ THIS USER MANUAL COMPLETELY BEFORE USAGE Contents Appearance parts and name of product Product specification Charge the projector Connection of projector Startup and operation of projector Volume adjustment Motor focusing Use the projector to charge other product Important safety information Trouble shooting Trademarks Parts of the projector Top Bottom Side 1 Volume adjustment FOCUS key 2 Mode key 3 Power key Side 1 USB 5V OUT interface Micro USB charging interface HDMI MHL interface LENS A PN Specifications Projector Nano Go 3 Texas Instruments DLP Technology Megabright LED lamp 25 Lumen LED Lamp 20 000 hours lifetime Up to 60 screen size HDMI video audio input Compatible with HDMI for iPad 1 2 3d and 4 generation iPad mini iPhone 4 4S and 5 iPod 4 and 5 generation Apple devices require an Apple Digital A V adapter not included for HDMI use Most smartphones and tablets Cameras and Camcorders with HDMI port Mac amp PC notebooks with HDMI port Supports 5pin MHL video audio input via the HDMI input port An 11pin to 5pin MHL adapter may be required for 11pin MHL devices 1080p HD video input supported 640 x 360 WVGA 16 9 resolution Contrast ratio 1500 1 100 offset Short Focus Lens Motor focus Stereo speaker with digital control Rechargeable 3400mA
Download Pdf Manuals
Related Search